Question about 2002 Mitsubishi Lancer

Open Question

Where can i buy a mixer box for my CK2 lancer , my motor is going bad in my vehicle air condition

Posted by Anonymous on

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

polarcycle
  • 1392 Answers

SOURCE: air conditioning compressor will not kick in,

If it is above 100PSI, you are over charged. Any thing under, should be normal to low. You probably need to get it checked by a professional to make sure it has the correct charge, and the compressor is getting power when the switch is turned on.

Posted on Jul 14, 2009

  • 1 Answer

SOURCE: i have a 2000 lancer ck2 engine or 4G13 1.3, my

there's a regulator which adjusts the car rpm when ac is on
or it could be a vacuum hose check hoses

Posted on Sep 16, 2010

  • 328 Answers

SOURCE: my ck2 lancer hard starts

its an injectors nozzles problem im sure of it
might be dirty nozzles needs to be cleaned and clogged up
or the nozzles are getting wider spraying hole so rather than spry the fuel it dripping it causing such a start up problems
but the sure thing is you need just check the injectors nozzles
have a nice day

Posted on May 30, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a ck2 lancer a 4g13 carberata model I have transmission problem it has stick on gear 3 an neutral light is blinking I have changed transmission an brain box an nothing has fix


Dang, spend all that time and money. When you have a bad wire somewhere. Check the wiring from the transmission to the brain box. I would bet you'll find it.

Jun 26, 2016 | Cars & Trucks

1 Answer

How to replace the hood release cable for Mitsubishi lancer ck2 1998


If your not particular mechanically inclined, than do not attempt this.
You probably will not have the tools.
I would go to a friend who happens to have a LOT of mechanical tools and ask for help.
This is something that would be simple for someone good with their hands.

Jan 07, 2015 | 1998 Mitsubishi Lancer

1 Answer

How do i change to hood release cable on the ck2 lancer


Cut the handle end off, use gorilla tape to attach new cable to the old one, then very carefully pull it through the firewall.

Jan 07, 2015 | 1998 Mitsubishi Lancer

1 Answer

How do i change to hood release cable on the ck2 lancer


With some difficulty ... the cable runs inside the front inner guard box section down to the firewall and into the cabin. You will likely have to remove the LHS headlamp, quarter light, disconnect the front bumper cover from the guard panel, and then remove the guard panel.

Jan 07, 2015 | 1998 Mitsubishi Lancer

1 Answer

Lancer Ck2 N light indicator blinks while on drive when get to stuck on gear3


the blinking of a nuetral light usually means overheating of the trans fluid. it says to pull over an let it ( the fluid ) cool down..... hope that helps

Oct 16, 2014 | 2002 Mitsubishi Lancer

1 Answer

Lancer Ck2 N light indicator blinks while on drive ?


check tests in the FSM book yet?
when you get a tranny code, there are tests to do.
to find out if.
the voltage to the solenoid are wrong.
the coil open or the valve dead.
or if the tranny is slipping and fooling the TCM.


31 LR solenoid opened

read the in the FSM, it shows you what to test.

on some A/t you can force it into manual mode and driver and shift manually (I have a test box, i made that does that to all cars)
but you can do that and check for tranny slip and see that all solenoid infact work and can hold a gear.

keep in mind the TCM is stupid as a brick
it cant tell of tranny slips , if the solenoid is dead 6 ways from sunday
in many cases, only that the RPM in the tail shaft is wrong.
some can check the solenoid voltage. the FSM tells you if that is true or not, so not looking and reading that first makes tests harder.

May 09, 2014 | 2000 Mitsubishi Lancer

1 Answer

I have a mitsubishi lancer ck2 1998 model no air comes out of the center vents, the air condition works I get air coming out of the side vents what may be the reason for no air coming through the center...


Could be a blend door problem. The blend doors under the dash direct air thru the heater core and the vents.
Are you sure the center vent is not blocked off ?

Jul 16, 2013 | Cars & Trucks

1 Answer

Ck2 lancer


is it a automatic or stick ?

Jun 15, 2013 | Cars & Trucks

2 Answers

The air conditioning in my 2004 mitsubishi lancer will periodically stop blowing cold air.


It could be a number of things...it may be low on freon...the drier/filter may need replaced...could have a bad expansion valve... regardless it should probably go to a qualified shop to be checked out...

Oct 02, 2008 | 2002 Mitsubishi Lancer

Not finding what you are looking for?
2002 Mitsubishi Lancer Logo

Related Topics:

19 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...