Question about Cadillac Cars & Trucks

Open Question

How do you replace shifter selecter bulb 2007 sts cadillac console

2007 cadillac sts center console

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 94 Answers

SOURCE: cigarette lighter socket and lights out in center console

fuse in blown the cig lighter fuse controlls all the above problems

Posted on Mar 09, 2009

  • 5 Answers

SOURCE: console shifter light bulb replacement

you need to take your dash apart find out if the light is burnt out or if it not getting the signal

Posted on Jun 06, 2009

  • 1 Answer

SOURCE: Need to replace boot sleeve on manual trans shifter

The frame that holds the "leather" in place just pops right out (come at it from one side; it'll sort of pivot around the other side -- I can't recall which is which, but trial and error works). Alternately, if you remove the six screws holding the entire center console in place, it can slide forward and rotate such that it'll clear the e-brake. Alternately alternately, if you curl your fingers underneath the boot frame on the side facing the rear of the car, you can pop the darker gray smooth plastic part of the center console entirely off while leaving the whole center console screwed in.

Posted on Jun 24, 2009

greezy_je208
  • 237 Answers

SOURCE: left front turn signal bulb is out on my 2007

easily mabe. look down from under the hood, if not try try from underneath.

Posted on Dec 18, 2009

  • 1 Answer

SOURCE: how to replace bulb in the shifter console

Bulb is located under the P/R/N/D/2/R indicator. Normally you just need to remove the black plastic that surrounds sifter and indicator and has the cup holders.But the plastic may be brittle, so remove the center console. See photos.
527cdec.jpg

53d2055.jpg

Posted on Feb 21, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you get the H/A to reset 07 cts


How to Change the Bulb in your 03-07 Cadillac CTS Fog ...

? 4:13
https://www.youtube.com/watch?v=TaW1haYSThs
Oct 13, 2011 - Uploaded by 1A Auto Parts
How to Change the Bulb in your 03-07 Cadillac CTS Fog, Daytime ... Do you guys have video for replacing the turn signal bulb in a 2006 STS?Missing: h

Re: Reading/Clearing Diagnostic Trouble Codes (DTC) - Cadillac



Nov 26, 2015 | 2007 Cadillac CTS 3.6L

1 Answer

How to replace led bulbs on 2008 Cadillac STS??


You need to buy the entire tail light housing or if its the cyclops light in the center, you'll need to replace it as a whole part. You cannot replace individual leds on those parts.

May 25, 2015 | 2008 Cadillac STS

2 Answers

How do I remove the console shifter lever? and how do I replace the shift position indicator bulb? Thanks


Do a Google or Bing Search for "2007 (YEAR) Ford Explorer Shifter Light change" various blogs will come right up BUT the indicator is IN the Dash/Speedometer in the newer models and the shifter isin the Center Council....OR go to almost any of the Auto Parts stores and LOOK at their Haynes Manuals. MOST will change the light bulb for You!

Mar 13, 2015 | 2007 Ford Explorer Eddie Bauer

1 Answer

How do I replace the Tail light bulb in my 2005 Cadillac STS


2005 used an LED panel i don't think you can change just a bulb

Sep 12, 2011 | 2005 Cadillac STS

1 Answer

2005 sts wont start. Says no FOBS detected. Please help?


Are both FOBs doing this? If it's only one I would replace the FOB battery.
NO FOBS DETECTED Message on DIC, No Crank/Start Unless Fob in Center Console Pocket or Remote Keyless Entry (RKE) Button Inoperative (Replace Remote Control Door Lock, Theft Deterrent Receiver Assm) #04-08-52-008

Tell the Dealership to look at this. They should be able to fix it quickly.

Keep us updated.

Feb 08, 2011 | 2005 Cadillac STS

1 Answer

How to replace bulb in back up lights?


Open the trunk and carefully pull off the trunk lid carpet liner by working at each black push-pin. They will be tight, so confine your pulling to as close to each as possible. Using a deepwell 10mm socket, remove the 11 (?) nut washers on the studs holding the license plate and lamp assembly onto the trunk lid. Carefully remove the entire license plate/lamp assembly. You can remove the sockets and harness if desired.

You will need to replace ALL the bulbs - why go through this again ?? You'll need 4 each #194 (tag/running lights), 4 each #3457, and 2 each 2357.

The OEM bulbs are #3057 and #1157, but the new numbers are slightly brighter. Don't worry about the backup lamp bulbs being dual-filament: the wedge base will always align the correct filaments in the socket.

Now place a dab of flexible duct seal (hardware store) around each stud base. Carefully push the assembly back into place, and using an assistant, check the operation of all circuits. OK ?? replace all the nut washers, snugging them up in a center to outside sequence to spread the loads - don't tighten each one all the way the first time - work around and around 3 times.

If you still have a bulb out or dim bulbs, then check the wire harness where it exits the left trunk hinge rail and also the harness ground at the sheet metal at the left fenderwell.
Read more at http://www.cadillacforums.com/forums/cadillac-seville-cadillac-eldorado-forum/194807-2001-sts-reverse-lights-replacement-how.html?kcplink=1Read more at http://www.cadillacforums.com/forums/cadillac-seville-cadillac-eldorado-forum/194807-2001-sts-reverse-lights-replacement-how.html?kcplink=1

Oct 01, 2010 | 2001 Cadillac DeVille

2 Answers

Traction control won't disengage.


You can pull the fuse for now. The traction control pump could be faulty or the wheel sensors are dirty and need to be cleaned with brake parts cleaner

Jan 18, 2010 | 2006 Cadillac STS

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

80 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8202 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...