Question about Hyundai Cars & Trucks

Open Question

Windows do not work not the fuse

2005 hyundai getz gl. where is the relay for the master switch window controller

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
maklean
  • 1665 Answers

SOURCE: 2001 Hyundai Elantra - All four windows inoperable

1. Remove the switch from the door trim panel. 2. Check for continuity between the terminals. If continuity is not as specified in the table, replace the power window switch. POWER WINDOW MAIN SWITCH caeb1ca.gif 77eecfc.gif WINDOW LOCK SWITCH 66921fc.gif

Posted on Jun 03, 2008

Ad
  • 883 Answers

SOURCE: power window relay or control unit

Control unit (with MANY wires) is inside trunk on right side and there is a fuse box with 3 fuses at the "REAR"...assume trunk again...I have schematic only...remove the Control unit wire connectors and re-insert them to polish the contacts...

Posted on Jul 04, 2008

countrysi248
  • 443 Answers

SOURCE: 97 honda crv driver side window will not work.

buy one of those neadle testers and make sure you have juice at the switch .. with the key on .. if so then try on the other side of the switch and see if its going through the switch .. if so its the motor .. again ?? test it all the way back to motor you will soon find what is wrong.. jerry holler if you need more.

Posted on Feb 07, 2009

  • 32 Answers

SOURCE: 2001 elantra master power window switch

at the bottom and top of the switch there are retaining tabs. you can try to pop it out at those points with a flathead screw driver, but it is sometimes easier to just remove the door panel to get it out.

Posted on Aug 13, 2009

MNfisherman
  • 11896 Answers

SOURCE: 2004 Dodge 2500 RAM Quad-cab.

The switch itself may be faulty. Have you tested it with an ohmmeter? Have you tested power to the passenger switch with a voltmeter?

Posted on Sep 30, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Tried it today and none of the windows work from master switch on drivers side except ft passenger window, which went down but will not go back up.


You can't put up the front passenger window with it's own switch ? Did you check the POWER WINDOW RELAY in the instrument panel fuse / relay box ? An you checked POWER fuse 30amp same fuse box ? All window switches have direct power from power window relay !
Fuse Block - Instrument Panel
Left of the Steering Column, behind the storage Compartment
P/W Relay
--
Sunroof Switch Assembly, Window Switch - Left Front, Window Switch - Left Rear, Window Switch - Right Front, Window Switch - Right Rear

Apr 02, 2015 | 2003 Pontiac Vibe

1 Answer

The windows on my crv wont work


at all stations?
all fuses, in both boxes. (did you read the operators guide to find them,
some cars have a circuit break (thermal) for windows,
and is located in the fuse box.
all this info is at alldata.com
ill look. ill respond , as you are a pro DIY person, can read schematics. if not , its just a guessing game.
IT IS a FUSE, not a breaker. but each motor in door has CB.
UNDER HOOD 40am Fuse #13
then fuse 23 underdash and fuse 8 same.
then the relay.same place.
and the relay is controlled by, master station (drivers)
the driver location doesnt need the relay to work.
the relay feeds power to all other window controls
so the master station is unique.
log in to alldata.com and see the pages on power windows.
here are some tid bits.
battery pull warning

Resetting the power window control unit is required after performing the following procedures: Disconnecting the battery, Removing the No. 6 (7.5 A) and/or the No. 23 (20 A) fuses from the under-dash fuse/relay box or disconnecting the driver's door wire harness.
and
window relearn/reset.
Control Unit Reset
  1. Turn the ignition switch ON (II).
  2. Move the driver's window all the way down by holding the driver's switch firmly down; when the window reaches the bottom, hold the driver's window switch firmly down for 2 seconds.
  3. Move the driver's window all the way up by holding the driver's switch firmly up; when the window reaches the top, hold the driver's window switch firmly up for 2 seconds.
  4. If the window does not work in AUTO, turn the ignition switch OFF and repeat the procedure.
  5. Check the window and power door lock operations

Jan 12, 2014 | 2006 Honda CR-V

1 Answer

Back windows wont roll down


i first check to see if you have a master power control switch at the driver side switches. If so, is it set to block? Also try pressing on and off a few times( maybe bad /corroded contacts inside the switch} . try the switch at each window{replace as necessary} there will be CIRCUIT BREAKERS not fuses you can check, also maybe window relays ,BURNT wiring, bad main switch,{master window} the last thing i would check is the motors themselves,doubt they would both be burned out!!! DAN F A.S.E. CERTIFIED TECH

Aug 19, 2012 | 2000 Hyundai Elantra

1 Answer

1988 subaru gl can't locate turn signal relay


there is no turn signal flasher or relay, its a combination switch, but there is a fuse, in the fuse box under the dash, the fuse isn't mark well, but says;

BACK
TURN
(4WD-AT)

if you have a gl-10 this fuse also controls power windows,
i had this same issue where my turn signals and my power windows stopped working (but my hazards still worked) and changing this fuse fixed all my issues

Jan 16, 2011 | 1988 Subaru Justy

1 Answer

Passenger side automatic window switch is not working in my 2004 Chevy Aveo. The window is operational from the driver's side master switch but not the passenger side. Im thinking its a fuse or a relay,...


Make sure the window lockout button is not depressed on the master window switch. This will turn off the other switches and not let them control there respective windows.

Power is supplied to all the windows from one fuse and one relay. So if the master switch operates the window than we know the fuses and relays are o.k. We know the master switch will operate the window so that tells us the window motor and ground side of the passenger window motor circuit are also good.

Which leaves us with a bad switch or no power to the switch. The passenger window switch gets its power to operate independently from the master switch window lockout button. When the button is off power is supplied to the passenger switch and allows the passenger to operate the window themselves.

The only thing you need to do is check for power at the passenger switch on the brown wire with orange stripe. If there is power there then you have a bad switch.

Oct 08, 2010 | Chevrolet Aveo Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

398 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8518 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...