Question about 2003 Volkswagen Passat

Open Question

Serpentine Belt Diagrams skoda superb 2.0 tdi

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: 2003 Jetta tdi serpentine belt

the belt just broke for me and 02 golf tdi

i was wondering if it's possible to drive the car home (about 8 miles)?

Posted on Aug 12, 2008

Ad
FixinFax
  • 3085 Answers

SOURCE: Skoda Superb 2004 1.8tdi. How do I remove the rear

It just pries off . Use a stiff putty knife.

On the inside, remove 2 screws at the bottom.

Posted on Sep 05, 2009

Testimonial: "It`s actually a Skoda Superb, & the trim panel appears to be held by the pull handle fixings. "

  • 1757 Answers

SOURCE: broken belt no routing diagram have 2004 jetta tdi

My sincere apologies for the delayed response.
I am personally going back to answer your unanswered questions.
I have only been a free contributor to this site for the past 4-months.

I do not know if you still need this information, but I am going ahead and answering it anyway. You may want to Print the Diagrams for future use.

CLICK
on the following LINK. It has the Belt Diagrams you will need.

If you would: Before Clicking: Let me know if this helped you, or if you have any additional information or questions. Feel Free to contact me at FixYa.com!

Again my apologies...
The Belt Diagram is located approximately 1/2 the way down on the Link Page.
http://www.2carpros.com/car_repair_information/year/2004/make/volkswagen/model/jetta/2004_volkswagen_jetta_drive_belt_routing_diagram.htm

Posted on Mar 07, 2010

  • 1 Answer

SOURCE: skoda octavia 1.9 tdi

lods have a problem it a skoda 19tdi no power when i give it the boot 80 km only turbo kicking in ok changed air flow , washed out boost valve, would u think the timing is out

Posted on Jul 01, 2010

  • 100 Answers

SOURCE: installing a serpentine belt on

Hi if the tensioner is loose or noisey when spun replace it but if its doing a good job as before use it again, but any sign of it slipping replace it

Posted on Mar 02, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have Skoda superb 1.9 TDI 2011 facing missing problem at 1000rpm cleaned diesel talk ,injector, turbo,fuel supply and changed fuel pump still getting the same prob in scanning every thing is perfect


mechanical problems will not show as codes so if a valve clearance is incorrect, weak valve springs, faulty hydraulic lifter/s loose valve seat inserts or partially blocked injector, the problem will not be revealed unless you do mechanical checks
take it to a service dealer and have it tested as it should still be under warranty and may be subject to a recall or service modification

May 04, 2016 | Skoda Cars & Trucks

1 Answer

Why is my multi v belt still bouncing around after fitting a new belt and tensioner on my 2005 skoda superb diesel


Check all pulleys and idler pulleys sound like maybe a bearing gone that would make it noisy

Jul 15, 2013 | Cars & Trucks

1 Answer

How to change timming belt on skoda octavia 1.9 tdi 2006


how to change timming on skoda octavia elegance tdi 2001

May 15, 2012 | Skoda Octavia Cars & Trucks

1 Answer

Belt routing diagram 2001 volkswagen jetta tdi 4 cyl


Click on the following free direct Link. It has the correct Serpentine/Drive Belt Diagrams for your 2001 Volkswagon Jetta with either the 1.8L or 2.0L In-Line 4-Cylinder Engine. The Belt Diagrams are located towards the end of Page. There is additional Diagams that will prove helpful to you for future use.

http://www.2carpros.com/car_repair_information/year/2001/make/volkswagen/model/jetta/2001_volkswagen_jetta_drive_belt_routing_diagram.htm

Let me know if this helped, or if you have additional information questions. Feel Free to contact me at FixYa.com!

Mar 24, 2010 | 2001 Volkswagen Jetta TDI

5 Answers

2003 Jetta tdi serpentine belt


hi doug
im dave
there should be a diagram for the belt somewhere under the hood of your car usually adjacent to the emission (VECI) label near the rad the belt or on the actual hood
the tensioner is automatic adjusting. using a ratchet and the proper size socket rotate the tensioner (usually anticlockwise but youll be able to tell as you turn it) to release tension and slip the belt off of the alternator pulley. be careful not to let go of the tensioner while slipping the belt off or you will hurt your fingers!

Jul 02, 2008 | 2003 Volkswagen Jetta TDI

Not finding what you are looking for?
2003 Volkswagen Passat Logo

Related Topics:

65 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

yadayada
yadayada

Level 3 Expert

76691 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8531 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...