Question about 2006 Hyundai Sonata

Open Question

Noise in steering column of 2006 Hyundai sonata

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 2 Answers

SOURCE: 2006 Hyundai Sonata brake light problem

there is a tsb for the brake switch in 06 sonatas. it must be adjusted or replaced by dealership. is your check engine light on, if so its probably code p0504

Posted on Jun 29, 2008

Ad
  • 4 Answers

SOURCE: my 2006 hyundai sonata alarm keeps going off

One word:

Dealer.

Next time just disconnect the battery until you get it towed as this is a warranty item. I'll bet some wondered if this was a prank question like I did, right?

Posted on Nov 22, 2008

  • 1 Answer

SOURCE: headlights for 2006 hyundai sonata

Answer
1. Remove the dust cover from behind the bulb that needs replacement.
2. Unplug the bulb.
3. Taking note of the bulb orientation, unhook the bulb retaining clip from the tang that holds it in place.
4. Remove the bulb.
5. Install the new bulb in the same orientation and clip in place.
6. Reconnect the electrical connector to the bulb.
7. Reinstall the dust cover.

Alternatively, if the bulb is burned out and you have less than 60,000 miles, you should take the car to the dealer and let them do it for free for you.

Posted on Feb 16, 2009

  • 67 Answers

SOURCE: My 2006 Hyundai Sonata's brake lights are not working

try the brakelight switch, it is right near the pedal above the footpad

Posted on Jul 24, 2009

  • 52 Answers

SOURCE: clicking noise when turning right

check your cv axles in the front end. they are basically your drive axles. the popping while turning is usually the outer boots on the axle shafts have torn and the grease inside the boots has ran out causing the shaft to be dry and click or pop when steering. usually you can replace the boot thats torn but it must be done within a few days of it tearing otherwise you will need to replace the axle shafts.

Posted on Aug 10, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The cruise control and the hooter does not work on my steering please help


Does the air bag light come on as well ? The clock spring in the upper steering column is use so your steering wheel button's have power an you can still turn the wheel from right to left . They break no an then ! How to replace clock spring in 2006 Hyundai Sonata

May 24, 2015 | 2003 Hyundai Santa Fe

2 Answers

Where is the radiator cooling fan relay on a 2006 Sonata 3.3L?


The relay in engine compartment fuse box.
For its exact location and wiring diagram,click the link below:----Hyundai Sonata cooling fan not working http://schematicsdiagram.blogspot.in/2012/02/hyundai-sonata-cooling-fan-not-working.html
---------------This will help.Thanks.

Feb 26, 2012 | 2006 Hyundai Sonata

1 Answer

Hyundai Sonata 06-My turn stalk sticks everytime I turn whether left or right turns. I have to manually cancel/return to neutral position. Any advice on whether this is fuse relay or just the switch...


its the cam in the steering column. either its worn down or the spring jumped off or something, but its in there somewhere. you might have to take the steering wheel off but its most likely the cam.

Mar 10, 2011 | 2006 Hyundai Sonata

1 Answer

Wiper switch broken how do you remove and replace with new unit on 2005 sonata


i dont see a need to remove the steering wheel. so pull the cover from under the steering column wheel and you shoul have axcess. cheers.

Dec 09, 2009 | 2005 Hyundai Sonata

1 Answer

How can i change the rack and pinon on a 2000 hyundai sonata


the K-frame has to be lowered in order to slide the steering rack out. this is after you have disconnected the hydraulic lines, the tie-rod ends, the exhaust (flex) pipe, the steering column shaft universal (at the bottom of the steering column), the stabilizer bar links, and the 4 17mm bolts holding the rack to the K-frame.

Oct 11, 2009 | 2000 Hyundai Sonata

1 Answer

2006 Hyundai Sonata: Wet road causes power steering failure


Ok, the high pitch sound is your idle pulley bearings going bad. The splash of water is exactly that, the belt gets wet and slips. Definitely a pully, more than likely the idler pully.

Sep 27, 2009 | 2006 Hyundai Sonata

1 Answer

Clicking noise when turning right


check your cv axles in the front end. they are basically your drive axles. the popping while turning is usually the outer boots on the axle shafts have torn and the grease inside the boots has ran out causing the shaft to be dry and click or pop when steering. usually you can replace the boot thats torn but it must be done within a few days of it tearing otherwise you will need to replace the axle shafts.

Aug 10, 2009 | 2006 Hyundai Sonata

1 Answer

Power steering makes noise when at almost maximum


Have you check the power steering fluid?

Jul 10, 2009 | 2006 Hyundai Sonata

Not finding what you are looking for?
2006 Hyundai Sonata Logo

Related Topics:

300 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8755 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...