Question about 2001 Isuzu Rodeo

Open Question

2001 isuzu anti lock brakes are bad

The brakes are very touchy and lock up

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 31 Answers

SOURCE: brake light and anti

you may have to clean or adjust your abs sensors

Posted on Jul 22, 2008

Ad
bigbarrygg
  • 4 Answers

SOURCE: brake light and anti

Your wires might be crossing or touching metal.thats what mine did.check where your back license plate light is at.thats where the problem could lie.replace some of the wires if you haven't already.

Posted on Oct 03, 2008

  • 1 Answer

SOURCE: Isuzu Rodeo abs light

I had it repaired: one of my sensors needed to be replaced. No more light!

Posted on Nov 23, 2008

  • 255 Answers

SOURCE: anti-lock brake

Hi ,you should check the rear brakes of your vehicle ,it is posible that they are not returning back when the brake is applied,the brake cilinders may be staying open , c1

Posted on Dec 31, 2008

  • 38 Answers

SOURCE: 95 isuzu rodeo anti lock brake lite staying on and

You probably have a bad wheel speed sensor, Most likely the sensor is telling your antilock system to activate, causing your brake pedal to pulse under your foot, you may have to take it and get it diagnosed. or check the wiring harness's, make sure they are properly connected, behind the front brake caliper if your vehicle is equiped with 4 wheel antilock, and the rear antilock may be either behind your brake drum or caliper, depending on disc or drum brakes on the rear. Some Vehichles have a single speed sensor located usually near the center of your rear axle,instead of individual sensors on the rear. look for a wiring harness connecting to the rear axle. It will likely be the only wiring connected into your rear axle. Hope this helps

Posted on Feb 14, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What would cause my brakes to be too touchy on my 1999 Chevrolet Astro


When were the brakes last serviced? If you don't know then have it done and have the tech check the function of the brake booster and any anti lock brake system fitted.

Nov 03, 2014 | Cars & Trucks

1 Answer

What is anti-lock braking system on cars?


Anti-Lock Brake systems are all essentially the same they will prevent the driver form applying 100% Brake pressure and locking up the wheels while driving. The ratchet the pressure more slowly to prevent the car from skidding. Our first reaction in an emergency is to slam on the brakes and that is 90% of the time not the right action. So Anti-Lock brakes are designed to prevent this unwanted skid.

Sep 17, 2014 | Isuzu Rodeo Cars & Trucks

1 Answer

My anti-rear lock light and brake light came on and the brake pedal goes to the floor.....is it more than changing the brakes?


ANTI LOCK BRAKE LIGHT AND BRAKE LIGHT COMES ON YOU HAVE BRAKE FAILURE.NOT SAFE TO DRIVE.YOU HAVE LEAKING BRAKE LINE OR LEAKING BRAKE CALIPER OR WHEEL CYLINDERS.THE MASTERCYLINDER OR ABS UNIT FAILED.DONT DRIVE VECHICLE NOT SAFE.

Jan 09, 2011 | 1992 Isuzu Pickup

1 Answer

What does "ABS" mean on the dashboard?


anti-lock brakes......chances are u have a bad wheel speed senor at one of the wheels. ur brakes will still work beautifully

Oct 05, 2010 | 1998 Isuzu Rodeo

1 Answer

I have a 2002 Lincoln ls . How do I replace the abs speed sensor? Right front tire?


you have one on the inside of each wheel.
SECTION 206-09A: Anti-Lock Control 2002 Lincoln LS Workshop Manual
REMOVAL AND INSTALLATION Front Wheel Speed Sensor
Material Item Specification RTV Silicone Sealant
FSTZ-19G204-AB (Canada CXC-114A) NAVSTR Sealer
Removal and Installation
  1. Raise and support the vehicle. For additional information, refer to Section 100-02 .
  1. Position the inner splash shield aside.
    1. Remove the pin-type retainers.
    1. Position the inner splash shield aside.
  1. Disconnect the anti-lock brake sensor electrical connector.
  1. Remove the anti-lock brake sensor harness from the brake hose clips.
  1. Remove the anti-lock brake sensor.
    1. Remove the anti-lock brake sensor clip.
    1. Remove the anti-lock brake sensor.
  1. NOTE: Make sure the anti-lock brake sensor is fully seated before installation of the new clip.
    To install, reverse the removal procedure.
    • Apply a 2.5 mm (0.1 in) bead of silicone sealant to the outside diameter of the anti-lock brake sensor.
-------------------------------------------------------------------------
Rear Wheel Speed Sensor Removal and Installation
  1. Raise and support the vehicle. For additional information, refer to Section 100-02 .
  1. Disconnect the rear anti-lock brake sensor electrical connector.
  1. Remove the rear anti-lock brake sensor harness from the control arm clips.
  1. NOTE: Clean off dirt and foreign material that may have collected around the rear anti-lock brake sensor before removal.
    Remove the rear anti-lock brake sensor.
    1. Remove the anti-lock brake sensor bolt.
    1. Remove the anti-lock brake sensor.
  1. To install, reverse the removal procedure.

Feb 24, 2010 | 2001 Lincoln LS

1 Answer

2001 Alero - anti-lock brake light warning light won't go out - had brakes replaced - is there a re-set button?


no reset button.have the car anti-lock brake system scanned.to check code.because when anti - lock brake light come on.it can be many things.like faulty wheel sensor.faulty relay or the anti - brake unit low on brake fluid or the abs unit faulty.

Nov 28, 2009 | 1999 Oldsmobile Alero

1 Answer

2001 Chevy Silverado anti-lock brakes activate on dry pavement, the pedal pulsates, the typical anti-lock brake sound is heard, and the truck feels like it is not going to stop at times


One of the sensors has gone bad and needs to be replaced, the other thing to that would also do that is the ABS sensor is dirty or needs to be re gaped to the speed ring on the hub. There was a issue bulletin with your Tahoe on the ABS activating under 8 km/h. Good luck and hope this helps, if not clean out the sensor with brake parts cleaner and check the wire harness and ABS sensor bracket. Re gap the sensor to the speed ring hub. Here is the bulletin. Anti lock Brake (ABS) Activation at Low Speeds (Clean Wheel Speed Sensor Mounting Surface) #03-05-25-007C - (05/16/2006) 2001-2006 Chevrolet Suburban, Tahoe

Jun 05, 2009 | 2001 Chevrolet Tahoe

1 Answer

ABS light stays on


that has four wheel anti lock so your gonna need to either take all them off and clean ends it may correct the problem but more than likely your gonna have to take to a large shop that has abs computer to find which sensor is bad then correct the problem

May 23, 2009 | 2001 Nissan Maxima

1 Answer

Anti-lock brake


Hi ,you should check the rear brakes of your vehicle ,it is posible that they are not returning back when the brake is applied,the brake cilinders may be staying open , c1

Dec 31, 2008 | 1994 Isuzu Trooper

Not finding what you are looking for?
2001 Isuzu Rodeo Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14378 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...