Question about 2000 Mitsubishi Eclipse
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
There is pressure...you have to remove the rear seat cushion,then remove the service cover and then detach the fuel pump harness connector.Start the car and allow it to run until the engine stalls.Turn the key to off position.Then disconnect the negative battery cable, attach the fuel pump connector, and install the access cover. Now place shop rags or towels around the fitting that is being disconnected. Loosen the filter feed pipe flare nut on the bottom of the filter.Seperate the flare nut from the filter. If equiped, remove and discard the gakets. remove the mounting bolts and remove the filter.if necessary remove the filter bracket. To install: install the filter to it's bracket only finger tight. Make sure the flow arrow is in the right direction. Make sure new O rings are installed prior to installation. Insert the filter feed pipe to the lower connection of the filter and manually screw in the main pipe's fare nut. While holding the fuel filter nut with a back-up wrench, tighten the banjo bolt to 22 ft pounds and tighten the flare nut to 25 with a back-up wrench on the nut. tighten the filter mounting bolts to 10 ft. pounds. Connect negative battery cable. turn key on to pressurize the fuel system and check for leaks. If repairs on the fuel system are needed remember to release the pressure before opening the fuel system. Hope this helps. Good luck!
Posted on Mar 15, 2009
SOURCE: where the fuel filter is located
It is located on the passenger side frame. Look for the fuel tank fill tube and then crawl under your car. It is in front of the rear tire on the passenger side of the frame. Should be 2 bolts holding it there, and when you tighten it back up don't tighten too much, you will break the bolts.
Good luck and hope this helps.
Posted on May 07, 2009
look for access panels in rear hatch there will be one on each side remove those and there will be 10 ml nuts holding the light housings on remove those then you can access the lights
Posted on Jul 02, 2009
Tips for a great answer:
Jun 22, 2011 | 2000 Mitsubishi Eclipse
Jul 06, 2010 | 1999 Mitsubishi Eclipse
Apr 05, 2010 | 2000 Mitsubishi Eclipse
Nov 13, 2009 | 2000 Mitsubishi Eclipse
Nov 10, 2009 | 2000 Mitsubishi Eclipse
Oct 13, 2009 | 2000 Mitsubishi Eclipse
Jul 11, 2009 | 1997 Mitsubishi Eclipse
Jun 20, 2009 | 1989 Mitsubishi Galant
May 07, 2009 | 1997 Mitsubishi Eclipse
Apr 14, 2017 | 2000 Mitsubishi Eclipse
Jun 30, 2014 | 2000 Mitsubishi Eclipse
166 people viewed this question
Usually answered in minutes!