Question about Acura MDX

Open Question

2003 acura mdx is overheating

There is no leaks and overheating while idling

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 18 Answers

SOURCE: remote garage door opener

1-800-355-3515
www.homelink.com

1. Position vehicle within 10 feet of garage door- engine off and battery on.

2. Press/hold 2 outside buttons of Homelink transceiver until red indicator starts flashing rapidly, then release button. This should take about 20 seconds. This erases any previously learned codes.

3. Press/hold remote control and press/hold button of Homelink transceiver simultaneously. Slowly move remote control from 5" away to 1" away from Homelink transceiver. Release both buttons after red indicator starts blinking rapidly. This should take about 5 seconds. I discovered that the Homelink in my TL is a bit faulty because it took much longer to accomplish this than when programming the Homelink in my MDX. My TL's Homelink may "unlearn" it's code in the future and the needed proximity of the TL to the garage door may be much closer than desired until I get the Homelink fixed.

4. Press training button on garage door opener unit until the indicator lights illuminates- this should be immediate.

5. Within 30 seconds press/hold the Homelink button for 2-3 seconds until the red indicator starts flashing rapidly. Repeat a second time. It should now be programmed. Check it by pressing the programmed button on the Homelink receiver.

6. When programming more than 1 garage door opener unit, disconnect power from unit before programming more units. By not doing this the programmed unit could conflict with the unprogrammed units commands.

Problems:

1. The Battery in the garage door remote may be too weak to program Homelink. However, the battery may be strong enough to operate the garage door. One of my remote controls had a weak battery- my system was installed today, fresh out of the box. I had to use the second remote control for the programming of Homelink on my 2 vehicles.

2. Antenna on the garage door opener unit must be hanging down, fully extended.

Posted on Dec 08, 2008

Ad
  • 1 Answer

SOURCE: How to use TPMS in Acura MDX 2005

The TPMS light will be visible in your instrument panel like your parking brake would if activated. The TPMS function is activated automatically once any of your tires are improperly inflated. Furthermore, it will identify which tire needs attention.

Posted on Mar 14, 2009

co7196
  • 3433 Answers

SOURCE: 2006 Acura MDX bluetooth stopped

Bluetooths have batteries, Rechargeable. If it won't hold a charge replace the batt.

Posted on Oct 16, 2009

  • 1 Answer

SOURCE: 2004 Acura MDX Water Leak

The 2002 MDX I worked on turned out to be a drainage problem . Seems the factory installed foam in the bottom of the hinge pillar post which blocked the drain holes . Take off the mud flap , remove enough of the splash shield to access the bottom of the hinge pillar and drill a half inch hole at the front lower corner aiming the drill slightly upward ( be sure to protect the bare metal) .Water gushed out when I did this. For extra ins. remove the kick panels and check for two holes a few inchs from the floor, plug and chaulk these holes. Hope this worksfor you too

Posted on Jan 07, 2010

  • 3 Answers

SOURCE: Need to reset the code my Acura MDX navigation

check the side of the glove box. my TL has it on the outside side panel as you look from the driver side. my honda prelude had the code there as well. hope this helps

Posted on Apr 30, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What gear to drive 2003 acura mdx


In Drive? Should be the letter D on your shifter. *If it's an automatic"

Jun 05, 2014 | 2003 Acura MDX

2 Answers

Where are the fuse boxes on a 2003 acura MDX


where is the relay a/c condenser fan location?off 2003 mdx acura?

Apr 19, 2012 | 2003 Acura MDX

1 Answer

How to remove front seats from 2003 acura mdx.


there should be 4 nuts screwed onto fixed bolts.remove the 4 nuts and unplug the electrical connectors then remove the seats

Jan 21, 2011 | 2003 Acura MDX

1 Answer

Will steering angle sensor trigger vsa maulfunction on 2003 acura mdx


the steering angle sensor is used as one of many inputs on honda's vehicle stability assist system. so in short yes. hope this helps

Dec 15, 2009 | 2003 Acura MDX

1 Answer

Where is the fuse box on a 2003 Acura MDX?


there is one on the door jam of the drivers door and another one on the pass door

Aug 18, 2009 | 2003 Acura MDX

1 Answer

DO YOU KNOW WHERE I CAN GET A DIAGRAM FOR ACURA 2003 MDX ROUTING BELT


there should be a sticker under the hood showing the belt route it may be on the hood, fender, radiator support, etc.

Jul 09, 2009 | 2003 Acura MDX

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

70 people viewed this question

Ask a Question

Usually answered in minutes!

Top Acura Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you an Acura Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...