Question about 1995 Cadillac Seville

Open Question

2004 cadillac cts 3rd brake light out - 1995 Cadillac Seville

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

cadman000
  • 607 Answers

SOURCE: 2004 cts cadillac trunk will not open with remote

Check fuse.. Test for power to trunk release solenoid. When door button, or remote trunk release button is pushed. If there is power ( use a 12 volt test light ) most probably faulty release . Hope this helps

Posted on Apr 23, 2009

yotaguy
  • 232 Answers

SOURCE: 1995 Cadillac STS 3rd brake light OUT?

No it wouldn't be a fuse because it's partially still working,LEDs are wired in series so it could be one LED is burnt out or the current limiting resistor has opened for that section.Repairing it would be fairly simple but will require a multimeter preferably with a diode tester and a soldering iron.If you're not familiar with using a multimeter and testing electronic circuits I would say let a professional repair it or replace the whole unit.Comment back and I will give you the test procedures if you fell confident in making the repair.

Posted on May 28, 2009

  • 1 Answer

SOURCE: cadillac cts cranks but won't start

My 2003 CTS would not start on the first, second or third try after filling the gas tank. Finally after several months of this occuring every two weeks a check engine light came on. It was the evac purge valve. Tom

Posted on Jan 08, 2010

  • 1 Answer

SOURCE: 2004 CTS Cadillac front passenger turn signal bulb is out.

Actually no you don't. Crank your steering wheel all the way to the right so yo have the maxumum clearance for your hands and arms in the front of the wheel well. Remove the plastic clips that hold the wheel well splash guard and pull it back enough to allow access to the interior of your bumper.
Replace bulbs as needed.
Yes, a jack is nice and makes it a touch easier to access, but I did this in an AutoZone parking lot during a cross country road trip.
5 mins tops to complete.

Posted on Mar 14, 2010

Zeevert
  • 373 Answers

SOURCE: procedure to change turn signal light bulb on a

Remove 3 or 4 of the plastic pins holding the inner fender. They are located around the lip of the fender opening. The pins are removed by pulling the center cap of the pin straight out about an 1/8" and then wiggle and pull the whole pin out.
Pull the inner fender down and back.
Reach your arm in and grab the socket and squeeze the locking tab.
Rotate the socket counter-clockwise less than a quarter turn, and pull straight back.
Reach your other hand in and remove the bulb by pulling it straight out of the socket. It takes a 3157 bulb

Posted on Jun 22, 2010

Testimonial: "Thank you so much for your help. Really I had ask the question about 3 months ago, but since I didn't had it fixed yet, it's OK now. Franco"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why my2004 Cadallic cts brake lights wont work or shift out of park?TC lig


A failed brake light switch or brake light circuit fuse will cause BOTH problems. Start by verifying that the fuse is OK, then proceed with replacing the brake light switch if the fuse was not at issue.

May 24, 2014 | 2004 Cadillac CTS

1 Answer

2005 cts brake warning light


This could be a wide variety of things...

Start with :
Low Brake Fluid
Worn Brake Pads
Emergency Brake left On
Ensure the Emergency Brake is Completely OFF

Apr 05, 2013 | 2004 Cadillac CTS

1 Answer

Tc, abs and service brake assist lights are on


Could be a wiring problem or the object that triggers the sensor.

Jul 07, 2012 | 2004 Cadillac CTS

1 Answer

2006 cadillac CTS 2.8 v6. Two side brake lights went out


im replacing the BPP sensor on one now, Brake Pedal Position sensor

Jul 14, 2010 | 2006 Cadillac CTS

2 Answers

2006 Cadillac CTS Brake lights out


Hello,
I have 2006 cadillac CTS 2.8 v6. Two side brake lights went out and don't work only when you use brake pedal, when i use the alarm on the car they flash like they should so the lights are fine. The light in the middle works fine so do the turn signals.

May 02, 2009 | 2006 Cadillac CTS

2 Answers

Radio effected by brakes?


If this happens when the car is still you have voltage interference between brake light voltage & antenna. If this happens from motion check all wire connections, loose antenna wire, to antenna.

Oct 21, 2008 | 2004 Cadillac CTS

Not finding what you are looking for?
1995 Cadillac Seville Logo

Related Topics:

57 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...