Question about 1994 Buick Century

2 Answers

How do you get the power steering pump off a 94 buick century 2.2l. it has a brack that connects to the head but the pully on the power steering pump is in the way? Is there a place that I can look at the exploded view of it online also?

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

The pulley has three holes in it. After you remove the serpentine belt, you can rotate the pulley until one of the holes lines up with one of the three bolts holding the pump on. You will need a socket wrench with an extension to reach the bolt, and probably an open-end wrench to hold the nut from spinning as you remove the bolt.

Posted on Mar 04, 2009

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 77 Answers

Autozone.com

Posted on Feb 04, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

CANNOT FIND WHERE TO ADD POWER STEERING FLUID TO A 1999 BUICK LASABER 3800 SERIES 2


follow the belts. power steering pump is pwered by a pully connected to the fan belt.

Sep 18, 2013 | Cars & Trucks

1 Answer

Have a 94 Buick century. Replaced thermostate. Running hot. Looks as tho is leaking underneath front near pump. And also in passenger floor board can't see the leak from inside. It's just alwa


Whenever I see a system which is leaking from more than one or two places, I do a head gasket check because that tells me that the system is experiencing above normal pressures. the wet floor is a heater core. whether it's a water pump or some other thing near it only you can tell. Actually it rarely happens, but the wet floor could be the hose where it meets the heater core at the firewall; again, only you will be able to tell the difference. if the hose connection looks dry, assume that it is the core itself.

Mar 03, 2013 | 1994 Buick Century

1 Answer

How do you tighten waterpump pulley on 94' buick


How to Change a Water Pump on a 1994 Buick Park Avenue. ... Thread all the bolts onto the pump finger tight, then tighten the short bolts with your wrench in ... www.ehow.com/how_7471017_change-1994-buick-park-avenue.html
hope this will help

Jan 26, 2012 | 1994 Buick Century

1 Answer

94 buick century 3.1L replaced fuel pump relay no power to relay why? checked all fuses. was not getting power to fuel pump. red wire going to relay with female connection not pluged in ,what is that used...


The fuel pump relay is twice fused. The relay power is provided through a fusible link connected at the starter post that the positive battery cable connects to; and there is an in-line fuse inside a cube shaped plastic box near the relay. Either the fusible link or the inline fuse is blown, or there is a break in the wire that runs from the stater post to the relay.

Sep 07, 2011 | Buick Century Cars & Trucks

1 Answer

1995 buick century custom, the anti lock light came on and the brakes seem fine. What should I look for


i have a 1995 buick centry and my anti lock light came on should i be concerned about anything? my bracks work fine.

Sep 09, 2010 | 1995 Buick Century

2 Answers

Replacing power steering pump in a 95 buick regal


i think you need to remove pully first it is a special puller gm has

Jan 13, 2010 | Buick Regal Cars & Trucks

1 Answer

Torn Serpentine Belt. Bad belt driver


You say belt driver? The belt runs on a series of pullys, there should be a pic./diagram on the radiator support that shows the routing of the belt. simply take the belt off and check each pully( they will either drive the belt or be idlers/tension pullys)to see which one has any "side to side" motion. If it is on a "driver" you are looking at replacing that part(water pump,power steering pump. etc.), as the real problem will be a bad bearing in that unit.

Oct 12, 2009 | 1997 Buick Century

1 Answer

Belts and Pulleys


you don't need to remove pully the holes in the pully will line up with the bolts

Oct 06, 2008 | 1995 Buick Century

2 Answers

Horn relay 95 Buick century


It is located in the convenience center to the left of the steering column.

Jul 19, 2008 | 1999 Buick Century

Not finding what you are looking for?
1994 Buick Century Logo

120 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...