Question about 2003 Dodge Caravan

Open Question

Is there an egr valve on the 2003 dodge caravan?

Is 2003 the only year without one?

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 2006 Dodge Grand Caravan - EGR code

I replaced the EGR Valve ($80 after tax), problem solved, vanruns great now. Now my problem is that I can't get the light to turn off.

Posted on Oct 06, 2008

  • 1596 Answers

SOURCE: 2005 Dodge 1500 code p0404 EGR valve.

The electronic EGR valve and solenoid assembly is attached to the rear of the left cylinder head ,

  1. Remove electrical connector (5) at top of EGR valve solenoid.
  2. Remove tube mounting bolt (1) at intake manifold.
  1. Remove two bolts (4) connecting EGR tube (1) to valve assembly.
  2. Remove gasket located between EGR tube flange and EGR valve assembly.
  3. Remove two EGR valve mounting bolts (5).
  4. Separate valve assembly (3) from engine.
  5. Remove and discard metal gasket located between cylinder head and valve assembly.
INSTALLATION
  1. Clean area at rear of left cylinder head where it joins base of EGR valve.
  2. Clean EGR tube where it joins EGR valve.
  3. Position new gasket between EGR valve and cylinder head.
  4. Position EGR valve to cylinder head. Install and tighten two bolts (5). Refer to Torque Specifications.
  5. Position new gasket between EGR tube flange and EGR valve assembly.
  6. Position EGR tube (1) to side of EGR valve and into intake manifold.
    1. Install EGR tube flange bolt (1) at intake manifold. Tighten bolt. Refer to Torque Specifications.
    2. Connect electrical connector (5) to top of EGR valve solenoid (2).Do a final tightening of two EGR tube bolts (4). Refer to Torque Specifications

Posted on Feb 05, 2009

  • 1 Answer

SOURCE: I HAVE A 2005 3.3

egr valve replaced and check engine light comes back on with p0405-check wiring at connector-if ok try performing at battery static discharge-disconnect both battery cable ends-and touch cables together-this discharges all ecu capacitors and resets adaptive memory

Posted on Feb 16, 2009

  • 1 Answer

SOURCE: Replacing the EGR valve on a 2004 Dodge Caravan 3.3L engine

I repair mine last summer,
It is on the exast port, left.
You have a tube attach to it, going in the Head Cover.
Easy to change. it cost me $105.00CND at the dealer

Good Luck
Jonathan Lévesque

Posted on Feb 28, 2009

  • 116 Answers

SOURCE: egr valve dodge durango

if this is a 4.7l engine, the valve is on the left rear of the intake. loosen the 8mm bolts that hold the egr intake tube to the egr valve, remove the egr bolts, disconnect wiring, remove valve and tube together, attach intake tube loosely to new valve, install new valve, tighten tube bolts to egr using a swivel socket, this is not a 5 minute job, so dont attempt unless you have some time and patience.

Posted on Apr 24, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is an egr valve?


An emission control part, called Exhaust Gas Recirculation valve. It allows a metered amount of exhaust gases to be returned back into the intake manifold, and thus into the cylinders, mixing with the air-fuel mixture. Why? It reduces the combustion temperatures inside the cylinders for cleaner emissions out the exhaust. Without it, we would have even deeper layers of smog.

Feb 12, 2013 | 2003 Dodge Grand Caravan AWD

1 Answer

2003 dodge carvan 3.3 purge control valve


The EVAP Purge valve on my 2003 Caravan is located under the car just behind the transmission in front of the front evap cannister (there are two cannisters on my car connected by a hose). It kind of looks like a black plastic EGR valve, but a bit bigger. I also had a vacuum leak. I found a ripped hose, replaced it, and still get the same code. I'm on the verge of getting a smoke test. Very aggravating. I tested my purge valve by removing it and applyiing vacuum. Was told that if it holds vacuum for 10 seconds it's good.

Nov 06, 2012 | 2003 Dodge Caravan

1 Answer

2006 Dodge Caravan Sputtering. Code says EGR Valve. Would an EGR valve cause the van to sputter and run rough?


Absolutely. You'll know if your EGR valve is stuck or malfunctioning because your car will experience symptoms like rough idle and bucking on acceleration.

Jan 24, 2011 | 2007 Dodge Grand Caravan SXT Minivan

1 Answer

I have a code PO 442, PO 455 in my 2003 dodge Grand Caravan, check engine is on. 2007 Town Country, i have codeP 1404, PO404


The p0442 is a moderate leak in the EVAP control system and p0455 is a large leak in the EVAP control system. First thing is to ensure that your filler cap is on tight and that the seal is effective. Next is to check the tubing of the EVAP system for any holes or disconnections. The P1404 is the valve in your EGR (exhaust gas recirculation) is staying closed. It could also be that the EGR piping is clogged up with soot (baked carbon deposits). Similarly the p0404 is an EGR related error code. Your vehicle is quite new and it would be unusual for the EGR to pack up or require cleaning out so early in its life. I would make sure that the connector pins in the connection socket to the EGR are clean and bright and that there no breaks in the wiring back to the power control module. If no joy then remove the EGR and examine the freedom of movement of the valve. If gummed up spray liberally with carburettor cleaner spray and leave to stand for at least ten minutes before wiping away the crud. Repeat until the valve looks like new and reinstall. After four or five restarts without fault the error code should clear.

Jan 14, 2011 | 2002 Dodge Grand Caravan

1 Answer

2005 dodge caravan diagnostic code p0404, please explain and do i replace the egr valve?


p0404 is-egr flow ckt range/performance, check egr, remove from vehicle and clean out carbon from valve and where it mounts on engine. also check the wireing connector and wire to valve. if this dosnt work, replace valve,

Apr 23, 2010 | 2005 Dodge Caravan

1 Answer

2005 dodge grand caravan getting code p0406


3.3 engines has the egr valve with transducer.you have to replace the whole unit. code p0406 what its trying to tell you your egr valve circuit is short to ground.it has failed .

Jul 04, 2009 | 2005 Dodge Grand Caravan

2 Answers

Location of egr valve?


The EGR Valve and transducer is mounted near the throttle body. 42224993.gif

Visit http://autorepair.about.com/library/faqs/bl948e.htm


Rate this fixya.

May 27, 2009 | 1996 Dodge Grand Caravan

1 Answer

I have a 2000 dodge caravan sport and the egr valve needs to be replaced.how accessible is it without hoisting up the vehicle


i co-oped at chryslers dealership for 6 months and never used the hoist to do egrs its 4-5 bolts

Nov 26, 2008 | 2000 Dodge Caravan

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

54 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...