Question about 2008 Nissan Rogue
I need to fix the outside drivers door lock, and I need to get the door skin panel off. How do I do it?
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
This is out of my haynes manual
1 disconnect negative battery cable
2 on manual window equipped modesl remove the window crank using a hooked tool to remove the retainer clip.
3 on power window equipped models pry out the armrest switch control plate and disconnect the electrical connections
4 detach the armrest pull handle retaining screw then remove the inside door handle trim bezel
5 insert a wide putty knife, a thin screwdriver or a special trim panel removal tool between the trim panel and the head of the retaining clip to disengage the door panel retaining clips.then remove the remaining door panel retaining screws at the lower edge of the door panel.
6 once all of the clips are screws are disengage detach the trim panel disconnect any electrical connectors and remoe the trim panel from the vehicle by gently pulling it up and out.
7 for access to the inner door remove the door panel support bracket then peel back the watershield taking care not to tear it. it install the trim panel first press the watershield back into place. if necessary add more sealant to hold it in place.
8 installation is the reverse of removal
Posted on Mar 20, 2009
Its tricky but you need to pop the half circle off to get to the 14mm bolt. Then roll the window down and there is a plastic circle at the top of the door frame. Pop that off and remove the one plillips screw and pop the panel off to get to the remaining 2 10mm bolts holding the door panel on.
Posted on May 23, 2009
Hi there, this is a very common fault, you need to replace the drivers door actuator to stop the noise, ive done loads of these. hope this helps.
Posted on Jun 07, 2009
Remove instrument driver lower cover.
Remove accelerator pedal assembly.
Remove filter cover and then remove in-cabin microfilter.
Posted on Aug 27, 2009
Tips for a great answer:
Jan 03, 2016 | 2008 Nissan Rogue
Jan 09, 2015 | 2008 Nissan Rogue
Mar 13, 2014 | 2008 Nissan Rogue
Feb 22, 2014 | 2008 Nissan Rogue
Jul 31, 2011 | 2008 Nissan Altima
May 29, 2011 | 2008 Chevrolet Impala
Nov 09, 2010 | 2008 Nissan Rogue
Jan 09, 2010 | 2002 Nissan Altima
Aug 26, 2009 | 2008 Nissan Rogue
573 people viewed this question
Usually answered in minutes!