Question about 2003 Chevrolet Silverado 1500

2 Answers

Check engine light on

Says bank 1 and bank 2 are ruunning too lean. whick o2 sensors monitor these two banks 2003 chevrolet silverrado v 8 5.3L

Posted by on

  • 1 more comment 
  • fybountyhunt Jan 30, 2009

    I replaced four o2 sensors however problem still exist with low voltage reading. How does this effect the acceleration ?

  • beowulf69 Feb 03, 2009

    I also have a 2003 silverado 4x4 4.9l "v" engine. I currently have 2 codes 171 bank 1 runs too lean & 174 bank 2 runs too lean. my tech says it's the intake manifold? does this make sense?

  • beowulf69 Feb 03, 2009

    that is not it, we changed all 4 on tune-up 10/08, the pcv and hose, also replaced the fuel pressure regulator & cleaned the mass air sensor. I am really lost. tech at dealer says it has to be intake manifold gasket? but i don't see how, only thing i see is wasting $900! When cold car idles up high then low to almost stall or rumble then when hot smoothes out. HELP! What did my $9.99 get me?

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 8 Answers

Both

Posted on Feb 15, 2013

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 5 Answers

There are only 2 banks in the engine. That means that if it has 2 O2 sensors they may both need replaced. .....More than likeley it has 2 or more O2 sensors. They shouldn't be hard to locate.

Posted on Jan 20, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have the code p2196 02 sensor stuck lean bank one sensor one. what are possible fixes


P2195 O2 Sensor Signal Biased/Stuck Lean (Bank 1 Sensor ...

www.obd-codes.com/p2195
P2195 O2 Sensor Signal Biased/Stuck Lean (Bank 1 Sensor 1) Code ... This codespecifically refers to the sensor between the engine and catalytic converter (not the onebehind it). Note: This DTC is very similar to P2196, P2197, P2198.

trouble code P2195 - P2196 I changed all O2 sensor still have

www.justanswer.com > Ford
Diagnostic Test Code (DTC) P2195 is defined as "O2 Sensor Signal Biased/Stuck Lean Bank 1 Sensor 1". is highly likely to be caused by a vacuum leak.

Code p2195 (Bank 1 sensor 1 O2 sensor stuck lean) - Ford Truck ...

www.ford-trucks.com > ... > Super Duty & Heavy Duty
Sep 23, 2010 - Code p2195 (Bank 1 sensor 1 O2 sensor stuck lean) Super Duty ... this issue by unplugging the electrical to each injector one at a time and ...

Jan 01, 2016 | 2009 Ford Escape XLT

1 Answer

P1273 Manufacture contr fuel air metering 2004 nissan sentera


P1273 Nissan P1273 Nissan - Air Fuel Ratio Sensor 1 Lean Shift Monitoring Bank 1 Possible causes
- Faulty Air fuel ratio (A/F) sensor 1 Bank 1
- Faulty Air fuel ratio (A/F) sensor 1 heater Bank 1
- Fuel pressure
- Faulty Fuel injector
- Intake air leaks
- Faulty Air Flow Meter
Most probable is you have a bad heater in your upper bank 1 O2 sensor. Replace all of your O2 sensors.

Read more: http://engine-codes.com/p1273_nissan.html#ixzz3lgP7CTD8
Read more: http://engine-codes.com/p1273_nissan.html#ixzz3lgOwiMU8

Aug 27, 2015 | 2004 Nissan Sentra 1.8

2 Answers

What does code p1131 mean on a 2001 ford taurus


P1131 Ford
P1131 Ford - Lack of Upstream Heated Oxygen Sensor Switch Sensor Indicates Lean Bank 1

Repair Importance Level: 3/3

Repair Difficulty Level: 2/3

http://engine-codes.com/p1131_ford.html

Forum Code

Possible causes

- Faulty Oxygen Sensor

- Vacuum leak affecting bank 1 only

- Fuel injector problem bank 1

- Check for cylinder misfire on bank 1

- Engine mechanical condition

Tech notes

Though the Oxygen (O2) sensor, the Engine Control Module (ECM) has detected a lean system, which means that there is either not enough fuel or and excessive amount of air in the system. Start by checking for vacuum leaks.

When is the code detected?

The Engine Control Module (ECM) detected bank 1 oxygen (O2) at its lean limit

Possible symptoms

- Engine Light ON (or Service Engine Soon Warning Light)

P1131 Ford Description

A Heated Exhaust Oxygen (HO2S) sensor indicating rich at the end of a test is trying to correct for an over-lean condition. The test fails when the fuel control system no longer detects switching for a calibrated amount of time.

Read more: http://engine-codes.com/p1131_ford.html#ixzz3izk89wMu

Aug 16, 2015 | Ford Cars & Trucks

2 Answers

Difference between Air fuel ration sensor to O2 sensor?


usually an O2 code is 3 digits and not this type of code. if it has an mass air flow sensor(MAF) it could be it. I would start with checking the MAF readings then the O2 readings. OBD 2 codes are emission regulated so no matter what car it is the codes represent the same problem.

Aug 04, 2015 | 2005 Infiniti G35

1 Answer

Codes P2270& P2272 after oil change check engine light on drove under 100 miles both O2 sensors bad .Could shop have caused this somehow??? Maybe banging them or something ?


make sure they are plugged in tight Definition of Diagnostic Trouble Code P2270 Category: Powertrain Definition: O2 Sensor Signal Biased/Stuck Lean Bank 1 Sensor 2Note: This definition of P2270 is applied to all manufacturers

P2270 - O2 Sensor Signal Biased/Stuck Lean Bank 1 Sensor 2 Comments ' Add Yours
Possible causes
- Faulty Rear Heated Oxygen Sensor Bank 1
- Rear Heated Oxygen Sensor Bank 1 harness is open or shorted
- Rear Heated Oxygen Sensor Bank 1 circuit poor electrical connection
- Exhaust gas leaks Help with this
When is the code detected?
The Powertrain Control Module (PCM) detected the HO2S12 sensor has reported a lean condition for an extended period during an intrusive test
Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
- High Fuel Consumption
- Excessive Smoke from Exhaust
P2270 Description
The Powertrain Control Module (PCM) supplies a voltage of about 450 mV between the HO2S high and low signal circuits. The oxygen sensor varies the voltage over a range from about 1,000 mV when the exhaust is rich, down through about 10 mV when the exhaust is lean.
The PCM monitors and stores the heated oxygen sensor (HO2S) voltage information. The PCMevaluates the HO2S voltage samples in order to determine the amount of time the HO2S voltage was out of range. The PCM compares the stored HO2S voltage samples taken within each sample period and determines if majority of the samples are out of the operating range.

Definition of Diagnostic Trouble Code P2272 Category: Powertrain Definition: O2 Sensor Signal Biased/Stuck Lean Bank 2 Sensor 2Note: This definition of P2272 is applied to all manufacturers

P2272 - O2 Sensor Signal Biased/Stuck Lean Bank 2 Sensor 2
' Add Comment
Possible causes
- Faulty Rear Heated Oxygen Sensor Bank 2
- Rear Heated Oxygen Sensor Bank 2 harness is open or shorted
- Rear Heated Oxygen Sensor Bank 2 circuit poor electrical connection
- Exhaust gas leaks
What does this mean?
When is the code detected?
The Powertrain Control Module (PCM) detected the HO2S22 sensor has reported a lean condition for an extended period during an intrusive test
Possible symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
- High Fuel Consumption
- Excessive Smoke from Exhaust
P2272 Description
The Powertrain Control Module (PCM) supplies a voltage of about 450 mV between the HO2S high and low signal circuits. The oxygen sensor varies the voltage over a range from about 1,000 mV when the exhaust is rich, down through about 10 mV when the exhaust is lean.
The PCM monitors and stores the heated oxygen sensor (HO2S) voltage information. The PCMevaluates the HO2S voltage samples in order to determine the amount of time the HO2S voltage was out of range. The PCM compares the stored HO2S voltage samples taken within each sample period and determines if majority of the samples are out of the operating range.
P2272 Information for specific makes
P2272 BMW
P2272 DODGE
P2272 FORD

Jul 30, 2015 | Cars & Trucks

1 Answer

2006 hundai elantra P2270 code. If this is an O2 sensor, which one?


Possible O2 sensors:

P2270 O2 Sensor Signal Stuck Lean Bank 1 Sensor 2
P2271 O2 Sensor Signal Stuck Rich Bank 1 Sensor 2
P2272 O2 Sensor Signal Stuck Lean Bank 2 Sensor 2
P2273 O2 Sensor Signal Stuck Rich Bank 2 Sensor 2
P2274 O2 Sensor Signal Stuck Lean Bank 1 Sensor 3
P2275 O2 Sensor Signal Stuck Rich Bank 1 Sensor 3
P2276 O2 Sensor Signal Stuck Lean Bank 2 Sensor 3
P2277 O2 Sensor Signal Stuck Rich Bank 2 Sensor 3
P2278 O2 Sensor Signals Swapped Bank 1 Sensor 3 / Bank 2 Sensor 3
---
This is Bank 1 (closer to the dash panel) Sensor 2 (located after the catalytic converter).

---
Note: A malfunctioning front oxygen sensor may cause fuel trim codes to set.
  1. Several Diagnostic Trouble Codes use specific terminology to refer to sensor location. The illustration and key below explain the following terms:
  2. Engine BANK Bank 1 is closer to the dash panel, (also referred to as RH or right hand). Bank 2 is closer to the radiator, (also referred to as LH or left hand).
  3. UP Refers to Sensor 1 or "front sensor". It is located closer to the exhaust manifold and before the catalytic converter.
  4. DOWN Refers to Sensor 2 or "rear sensor." It is located after the catalytic converter.
  5. The following examples show how to interpret oxygen sensor terminology:
  6. B1/S1 = Bank 1/Sensor 1 = Dash panel side, BEFORE the catalyst or "upstream"
  7. B2/S2 = Bank 2/Sensor 2 = Radiator side, AFTER the catalyst or "downstream"

Aug 06, 2010 | Hyundai Elantra Cars & Trucks

1 Answer

Where is the location of the bank one sensor one o2 sensor on my 2003 chevy suburban


bank 1 on a chevy is on the drivers side youll have 4 O2 sensors sensor 1 bank 1 is on the engine side of the cat converter sensor 2 bank 1 is after the cat converter (drivers side )
bank 2 is on the passenger side sensor 1 is pre cat sensor 2 is post cat converter

Mar 18, 2010 | 2003 Chevrolet Suburban 1500

1 Answer

P0137 p0171 p0174


P0137 o2 circuit low voltage bank 1 sensor 2 --o2 sensor after the cat converter -check for faulty o2 sensor -short or open circuit exhaust leak near sensor or plugged cat converter ----P0171 and P0174 -system too lean bank 1--and system too lean bank 2 they are usually from the same problem which can be caused from the o2 problem but check ur maf sensor connections and or clean if necessary[carb cleaner] vacuum leak downstream from maf sensor also inspect pcv lines

Feb 16, 2010 | 2003 Chevrolet Silverado 1500

2 Answers

03 impala, Car has minimum power 0-30 and then full power...Why?


if it said bank 1 lean, probaly it is an o2 sensor, but if bank 1 and 2 are lean then you have a vacuum leak. a hose or the intake. was there 1 code or more?

Aug 12, 2009 | 2003 Chevrolet Impala

3 Answers

Codes 1133-0131-0171-0300


p1133 - o2 sensor, Insufficiant Switching, Bank 1 Sensor 1.
p0131 - o2 sensor circuit, low voltage, bank 1 sensor 1
p0171 - Lean condition, Bank 1
p0300 - Random Misfire

I would be looking at the front passenger side oxygen sensor for issues. It may be bad, it may not be plugged in, bad wiring at harness.

The random misfire may be symptomatic of the o2 sensor problem.

Mar 17, 2009 | 2002 Chevrolet Silverado 1500

Not finding what you are looking for?
Cars & Trucks Logo

343 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

60792 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...