Question about 1998 GMC Jimmy

Open Question

Where is inertia switch for 1998 gmc jimmy located

Can not locate inertia switch

Posted by Anonymous on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 51 Answers

SOURCE: where is the fuel pressure regulator located on a 1999 gmc jimmy

It's on your fuel injection rail BELOW the upper intake manifold. The upper intake manifold MUST come off first.


Posted on Aug 01, 2008

  • 125 Answers

SOURCE: TPS in a 1998 GMC Jimmy

the tps is ususally at the side of the throttle body opposite where the throttle cable / tv cable mount.
sometimes it won't start, run, or run erratically. there are ways of testing this unit (by output voltage) before you commit to buying a new one. to test it you will need a dvom (digital volt ohm meter).

just a note: straight from the book... "a broken or loose tps can cause intermitten burst of fuel from the injector and an unstable idle because the ecm thinks the throttle is moving."

Posted on Sep 22, 2008

  • 254 Answers

SOURCE: fuel filter, where is it located on a 2000 GMC Jimmy

fuel filter is located on the drivers side behind the rear quarter panel .
thanks and plse do not forget to accept the solution

Posted on Apr 03, 2009

  • 272 Answers

SOURCE: Cannot locate where the a/c clutch cycle switch is... there is no power in the wires to the clutch and fuses are okay.

The a/c clutch is attached to the front of your a/c compressor. It is the part that your serpentine belt runs on. It is either engaged or not based on the demand of the a/c system. It will not run if it senses low pressure in the freon supply line so you might try having the system checked for proper fill before replacing the clutch.

Posted on May 29, 2009

  • 432 Answers

SOURCE: need to know where the heater blower motor

Unless they moved it and are still using the same part,I would say that this one is located behind the glove box sandwitched between the underside of the dash and the top of the airbox.The blower motor is mounted to the underside of the airbox.

Posted on Jan 04, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

1994 GMC Topkick not getting power from the fuel pump. Where is the fuel pump relay located?

Before going there, check your INERTIA SWITCH (INTERTIAL CUTOFF SWITCH). A small accident or a sharp bump can cause the cutoff switch to trip. The switch is located adjacent to the passenger side rear shock tower, and there is a pushbutton to reset (on most Topkick tucks). Carbureted Topkick trucks do not have cutoff switches, and some custom trucks have the inertia switch relocated.

May 13, 2015 | GMC Cars & Trucks

1 Answer

Fuel switch inertia

Your's doesn't have one Theresa,do you think your fuel pump clocked out and went home.

Nov 19, 2013 | 2000 GMC Jimmy

1 Answer

Location of inertia switch

Gmc don't have one, fords do. Check the grey wire for power at pump connector when you turn on key. Big black one is ground. If power and ground is good then you have a bad pump. If no power check fuses and change relay

Nov 18, 2013 | 1992 GMC Jimmy

1 Answer

Does my 95 gmc jimmy hav a emergencie fuel shut off switch

Yes. It's not somthing that's manual in any way tho. It's called an "Inertia relay"
and it's typically located on the drivers side firewall, next to the brake master cylinder. It shuts off the fuel pump when there is an accident or a rollover "impact"
If there is more than one relay there, turn the ignition switch to the run position, then pull and replace "repetidly" the fuel pump fuse. You will hear a clicking noise from the correct relay. Thats IF you are trying to track it down......also, you will need a second person to "feel" the relays to sense the vibration of the click.

Dec 09, 2011 | 1995 GMC Jimmy

1 Answer

Where are the freeze out plugs located on a 1998 Jimmy 4 wheel drive.

The freeze plugs are located on the very side of the engine block and on these should be 3 per side. Locate the oil pan and look about 4-6" up and you will see them. What kind of problems are you having?

Oct 25, 2010 | 1998 GMC Jimmy

1 Answer

I have a 1998 GMC Jimmmy and can't locate the

hi most resisters are located on the blower itself. paul

Jul 07, 2009 | 1998 GMC Jimmy

2 Answers

1998 olds silhouette fuel cut off switch location

not sure what you are looking for?? there is no fuel cut oof switch in these vans. Not factory anyway. if you could elaborate on what you are looking for and or why.

Apr 29, 2009 | 1998 Oldsmobile Silhouette

Not finding what you are looking for?
1998 GMC Jimmy Logo

Related Topics:

55 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts


Level 3 Expert

77544 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides