Question about 1996 Toyota Previa

Open Question

Where do i find the knock sensor in a 1993 toyota previa with a 2tzfe motor

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 170 Answers

SOURCE: toyota previa 1993 startup problems

Does it spin at all? If not either the starter is bad or the engine is seized. Try to turn engine with a socket wrench on the crank pulley bolt. Anything happen to the truck just before you had starting problems (drive through a deep puddle, overheat the engine, lose oil pressure, blown head gasket)? If it was deep water the engine could have hydraulic lock from water in the cylinder(s), remove the spark plugs and try to turn it over with the starter. If it turns over clean, dry and re-install the plugs. If it overheated, ran with low oil pressure, or the oil was contaminated with coolant the engine is probably seized.

Posted on Feb 07, 2009

GasparMacari
  • 166 Answers

SOURCE: where is knock sensor in toyota previa

it has to be located on the engine block its 2 cable sensor
hope this helps

Posted on Nov 18, 2009

  • 1810 Answers

SOURCE: anti-knock sensor location

on all 4 wheels

Posted on Jan 02, 2010

mickha2
  • 145 Answers

SOURCE: need to know toyota previa cranks sensor

behind crank pulley

Posted on Aug 17, 2010

vetteman3002
  • 2299 Answers

SOURCE: how do i remove the old oxygen sensors and install

The first step and most important step is to disconnect your battery. Then locate the sensors. They are in the exhaust. You should have one before your Catalytic Converter and one after. They just unplug and the new one plugs in as far as the electrical goes. Then they are threaded into the exhaust.

Posted on Oct 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

The compression is the same for all cylinders(150), but when I turned motor over, water came out of #1 cylinder only. Any idea?


Sounds like a head gasket leaking water in from the cooling system. Does it run OK? Any water in the oil on the dipstick and a mayonnaise type film on the oil filler cap?

Jan 21, 2016 | 1992 Toyota Previa

1 Answer

In my Toyota previa 93 , it gives knocking sound when in gear and it become more if AC is ON and if i put it in neutral this sounds goes off Pls any one knows the reason


check your crank pulley,possible the rubber which is used on it cracked and on loading the ac knocks,or check the tensioner of the ac belt,or the ac compressor the pulley of it.

Sep 23, 2012 | 1993 Toyota Previa

2 Answers

Toyota previa stalled (died suddenly) while being driven it feels like there's a hiccup in the engine no matter how hard i press the accelerator it won't accelerate!


Ika, has it started back? If not, it may be a timing belt/chain broke. If it cranks, it may be a fuel pump, filter, pinched gas lines, or bad fuel injectors. It may be a problem in the ignitions. Spark plugs,coils, wires, distributor, coil pack, dist.cap, If it is not cranking, check ignition fuse. Check battery, wires, and whole charging system. If it is just dying on you and it starts back, it may be a map sensor, idle sensor or throttle sensor possibly. Need a little more info please.

Mar 07, 2011 | 1993 Toyota Previa

1 Answer

I have a 1992 Toyota Previa. The heater stopped blowing air. For the last year the fan would only work on the highest setting.... now nothing. Is it the Blower motor, fan relay, or Switch??? Any idea?...


the last year, your blower resistor has been bad, now your motor is bad. rap on the motor and see if it start to run, if so, replace the motor and the resistor.

Dec 16, 2010 | 1993 Toyota Previa

2 Answers

Oil level light stays blinking on toyota previa 1993


most of these models have 2 oil lights.The red one is oil pressure,if flashing or on when engine is running,it is usually serious.check oil level,but usually caused by blocked pickup screen(a common toyota fault) when services aren't done.The orange oil light is tripped by an oil level sensor on the side of the sump when the oil level is low.If the oil level is ok,note this is a common fault especially if oil changes have been missed,and/or a petrol engine oil used and sludge builds up,sometimes using an additive for flushing prior to oil change can help,but may not work on 1st oil change.

Nov 04, 2010 | 1993 Toyota Previa

1 Answer

How do i remove the old oxygen sensors and install new ones on my 1993 toyota previa?


The first step and most important step is to disconnect your battery. Then locate the sensors. They are in the exhaust. You should have one before your Catalytic Converter and one after. They just unplug and the new one plugs in as far as the electrical goes. Then they are threaded into the exhaust.

Oct 05, 2010 | 1993 Toyota Previa

1 Answer

Where is knock sensor in toyota previa


it has to be located on the engine block its 2 cable sensor
hope this helps

Nov 18, 2009 | 1996 Toyota Previa

1 Answer

Which refrigerant is used in a 1993 previa sold in Canada


1993 Previas contained R-12 from the factory.
33.5 +/- 1.7 ounces needed to perform a complete recharge.

Nov 14, 2008 | 1993 Toyota Previa

Not finding what you are looking for?
1996 Toyota Previa Logo

Related Topics:

29 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...