Question about Cars & Trucks

1 Answer

93 ford bronco rough idol stalls at stop light also idle rises and falls in park

Changed plugs wires distributer cap rotor and coil

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Have you checked for vacum leak at brake booster ? if leaking vacum , when braked pressed . will make hissing sound .

Posted on Jan 06, 2013

  • peter semikoff Jan 11, 2013

    only makes a short pssst when pressing on brake pedal thank you though ill be working on it this wkend

×

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
tommyboinow
  • 324 Answers

SOURCE: getting misfire codes for cyl.

it is your fuel injectors, replace them, and the problem will be solved..

Posted on Nov 26, 2008

  • 188 Answers

SOURCE: 1988 jeep wrangler idoling rough

It does sound like a vacuum leak. Get a can of WD-40 and start spraying around the carb. It will rev up, and U can pin point the loose vacuum hose, are crack vacuum hose.

Posted on Feb 14, 2009

  • 6982 Answers

SOURCE: jeep wrangler stalls out

check idle air control, tps & map sensor. As usual with electronics, test test test before buying anything/

Posted on Feb 18, 2009

  • 881 Answers

SOURCE: 1989 toyota camry 232000miles Runs rough at idle

YOUR problem is the carby acc pump and idle jet ...... what you need to do is remove airfilter and take the top off the carby and you should see a small ball and spring under gasket ...when you open the throttle it will pump petrol to the small pick up jet and the other jet will take over ...clean out carby jets and rebuild and that should be ok

Posted on Sep 23, 2009

  • 24 Answers

SOURCE: My 1994 Chevy Silverado 5.7

This misfire could be an intake valve or exhaust valve stuck open. Remove spark plug, and use a fiber optic camera to look in the chambers to look at the valves. It could be a bent valve or badly worn edge of a valve or simply a build up of carbon debris. I own a 95 Jimmy with a V6 Vortec and it has the same problem with a miss. mine is a bad valve, I hope yours is something small, but I hope it helps anyhow.
D

Posted on Jan 06, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 96 ford bronco runs rough on acceleration,idles fine. Runs good under light acceleration but if hit the gas hard runs bad and pops. Changed fuel filter no change.what next?


givit a tune--new distributer cap--new plugs and cables--------also have air intake cleaned plus idle control--use a nonchlorinatd solvent sold a napa etc

Jul 22, 2014 | 1996 Ford Bronco

1 Answer

Bronco idling up and down, idling rough, and has popping in the header


Try to replace the cap and rotor for starters sounds like its misfiring.

Apr 13, 2014 | 1990 Ford Bronco

1 Answer

1988 ford bronco11 have feul,but no fire from distributor to coil


with distributer cap off have someone crank engine and see if your rotor is turning if not repair distributer or replace.

Apr 05, 2014 | 1988 Ford Bronco II

2 Answers

Ford 1981 f 150 not running changed Coil distributor cap Roar arm plug wires did not help started bur ran extremely rough then died


motors need 3 things to run properly. gas spark and compression. the starting point. also spark timing.
the motor you are dealing with is easy. i just rebult a 1978. anyways sounds like a timing problem . first i would check the distributer. if all is ok spay a squirt of starting fluid in the air filter, or even wd40.,,,,,,,see if it is gasoline problem. isolate where the problem is.

Aug 29, 2017 | Ford Cars & Trucks

1 Answer

1988 jeep wrangler idoling rough


It does sound like a vacuum leak. Get a can of WD-40 and start spraying around the carb. It will rev up, and U can pin point the loose vacuum hose, are crack vacuum hose.

Feb 13, 2009 | 1988 Jeep Wrangler

1 Answer

87 ford bronco II idling and power problem


check the i.a.c. (idle air control) valve near the throttle body, it fixed my low idle!

Sep 09, 2008 | 1987 Ford Bronco II

1 Answer

No fire


Coil pack. Distributer. Spark plugs. And spark plug wires are all things that deal with the firings of the motor. the distributer cap and rotor may also be bad.

Jul 29, 2008 | 1989 Ford Bronco II

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

68 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...