Question about 2003 Saturn ION

Open Question

How do I replace a starter on a 2003 saturn ion?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 5 Answers

SOURCE: saturn ion blower motor

lower settings as far as speeds for your blower motor go through a resister block to reduce the voltage your blower motor receives to make it turn slower. If it turns slow on high you would have to check the voltage at the blower motor, should be the same voltage that would be at the battery. There could also be material in the blower motor fan like things a mouse could have put there. Causes the fan to spin slower and also blocks the fins from pushing air. Any strange noises would be heard unless you have had the prob since you owned it and could not detect any changes. It could be even full of stuff and still
be in balance. but it could be a few other things.

Posted on Dec 23, 2008

Ad
  • 1596 Answers

SOURCE: where is 2003 saturn ion thermostat?

FACEING the ENGINE It is At TOP RIGHT SIDE Close to Master Cylinder takes About 1 hour to Replace Have Fun its a EASY One
Please Dont forget to RATE ME Thank You

  1. Drain the cooling system.
  2. Remove the bolts that secure the thermostat housing to the water pump feed pipe.
Remove the feed pipe
  1. Remove the thermostat and retaining sleeve, noting the orientation for installation.
Installation Procedure
Install the thermostat and retaining sleeve with the dimple placed into the housing slotImportant: Lubricate the O-ring with soapy water or coolant before installing the O-ring in the water pump.

  1. Install the feed pipe that connects the thermostat housing to the water pump.Notice: Refer to Fastener Notice in Service Precautions.

    1. Install the bolt that secures the water pump feed pipe.
      • Tighten the bolt to 10 Nm (18 inch lbs.) .
    1. Fill the cooling system.

Posted on Feb 09, 2009

blueextc3221
  • 15935 Answers

SOURCE: Oxygen sensor location on a 2003 Saturn Ion-1

One is front of the cat, and one after the cat of the exhaust.
The OBD Scanner should tell you which bank is producing the error.
Bank one is the front one.

Thanks for using FixYa - a FixYa rating is appreciated!!

Posted on Feb 21, 2009

  • 1596 Answers

SOURCE: rumbling noise on front of saturn ion car

Sounds Like A Wheel Bearing Has Failed. ISOLATE it & Replace it

Posted on Sep 08, 2009

  • 100 Answers

SOURCE: I need a fuse diagram for 2003 Saturn Ion

Go to carhelpsite.com it is free as long as you click on 2 of the ads at the website then your questions will be answered by an ASE certified mechanic,you don't have to buy or fill out anything on the ads,so help keep the site free.

Posted on Apr 13, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the starter located on a 2003 saturn ion


It is located about in the middle between the engine and the transmission. Also it is directly below the intake manifold. Hope this helps.

Jun 10, 2014 | 2003 Saturn ION

1 Answer

Saturn Ion 3, 2003


Is there a chance the engine is locked up ?

Jan 24, 2014 | Saturn Cars & Trucks

2 Answers

Were is the ignition switch on a 2003 saturn ion


The Ignition starter switch is located directly to the rear of the ignition lock cylinder and it is directly actuated by the lock cylinder. You must remove the outer covers of the column to replace it. Below is a picture of the switch. Use the OEM part as it is far better than aftermarket parts and about the same price.
7_6_2012_4_16_05_pm.jpg

Jul 06, 2012 | 2003 Saturn ION

1 Answer

The ignition fuse keeps blowing in my 2003 ion 2.2l motor what could the problem be


On Saturn Ions, it's been the starter switch, but those tend to fail open, which would leave the fuse unblown. (The switch is Saturn P/N 10392423)

Check your oil; if there is none it will be hard to crank. Starters also go bad over time, so you would expect that either the starter motor has come to draw more current and do nothing or that the solenoid has a short in it from some kind of damage (to the wires or the thing itself.) The car's computer probably has an opinion on this if you happen to be able to buy or borrow an ODB-II reader (and/or software so you can get a nice report on your computer.) In any case what you'll end up doing is removing the starter, stripping and cleaning it within reason (no rewinding wire,) replacing the brushes and testing it at the parts store before reinstalling it.

Sep 12, 2011 | 2004 Saturn ION

1 Answer

2003 Saturn Ion spark plug replacement


go to autozone.com and set up a free account. You will then have access to vehicle repair guides and can get all the info and diagrams you need, plus help with troubleshooting! Hope this helps!

Jan 02, 2010 | 2003 Saturn ION

1 Answer

My 2003 saturn has an intermettent starting


I would have a shop check your security system.Does more then one person drive car????how many keys are there for this car???

Dec 12, 2009 | 2003 Saturn ION

1 Answer

Starting problem for 03 saturn ion when engine is warm


replace the ign switch. the key has nothing to do with it.

Mar 16, 2009 | 2003 Saturn ION

1 Answer

We have a 2003 Saturn Ion that has intermittent starting problems. The problem occurs at all temperatures. If we wait 5-15 minutes it will start. Have replaced the battery and starter My girlfriends...


Take the car in, and have the fuel pump checked, and maybe the alternater. Something in there is going out. Could even be lose battery cables, or a lose connection. Either way, you should have it checked before you get stuck somewhere.

Jan 13, 2009 | 2003 Saturn ION

1 Answer

Repalce starter on a 2003 Saturn Ion I


Get a book to the car from AutoZone, it should tell you where it is. If you cant find it, it may be one of those cars that has to have the engine dropped. Those are a pain, because you cant do it yourself. Good luck.

Jan 02, 2009 | 2003 Saturn ION

Not finding what you are looking for?
2003 Saturn ION Logo

Related Topics:

202 people viewed this question

Ask a Question

Usually answered in minutes!

Top Saturn Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8269 Answers

Are you a Saturn Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...