Question about Cars & Trucks

Open Question

My nissan sentra 200 sti doesn't pull like it used to, and it stalls when accelarating on low rpm

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 77 Answers

SOURCE: 93 Nissan Sentra engine stalls

you need to replace the coil packs.

Posted on Jun 27, 2009

Ad
NismoMaster
  • 146 Answers

SOURCE: torque settings for cylinder head nissan sentra

Tighten in sequence to 29ft.lbs then tighten in sequence to 58ft lbs. then loosen all bolts. Then tighten in sequence to 33ft lbs. then tighten each bolt in sequence 90 degrees then tighten each bolt again 90 degrees

Posted on Jul 26, 2009

  • 20 Answers

SOURCE: 2000 nissan sentra runs well on warm up, stalls in

i actually had this problem on my 97 sentra, its the air idle control valve. when your car is idling with your foot off the pedal, the throttle plate is closed, so this little valve opens up to allow air to detour around the closed throttle plate so your car can continue to run, when you give it gas the plate opens so your engine can increase revs.

after awhile the idle air control valve gets dirty with carbon buildup and eventually makes the valve stick so no air can pass through it which is why the car will stall when it attempts to idle. all it needs is a good clean. its very easy to do, just get some brake cleaner and a toothpick or q-tip or some other small brush.

locating this valve is a bit tricky, yours is a 2000 model mines a 97 so it wont be in the same location as mine, but what your looking for is a little cylinder type thing somewhere near the intake with an electrical connector at the back of it, take the connector off, mine had 2 phillips head screws holding the valve in place, once removed the valve slides out, and you can proceed to clean it. make sure you get all the black soot out of it and play around with it until it opens smooth, reinstall and it should run fine. to find out the exact location of your idle air control valve id google it or try a nissan forum, but itll be close to your intake manifold near the firewall. best of luck, once found its a very easy fix.

Posted on Dec 08, 2009

SOURCE: 2002 Nissan Sentra intermittant stalling no codes

Have a mechanic check it for vacuum leaks!

Good luck and be careful!

Posted on Feb 09, 2010

  • 60 Answers

SOURCE: How do I replace a fuel pump on a 2000 Nissan Sentra

lift the back seat and there should be an acces panel there

Posted on Apr 03, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2000 nissan sentra misfires when gas is applied to the mix but idles well and runs well at low rpm's.what could be causing this problem


You probably have a weak spark plug or injector.
You should get a check engine light and if you have the computer scanned you should have a code telling you which cylinder is not firing.
The problem is there at idle but not as serious as when you put a load on the engine.

Jan 12, 2013 | 2000 Nissan Sentra

1 Answer

93 nissan sentra, hesitation


Tune it up and replace fuel filter.

Aug 18, 2017 | Cars & Trucks

1 Answer

My nissan sentra 1987 stops, stalls and cuts off engine


Engine stall or RPM fluctuates at idle.

This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake while the engine is running, use up about 1/2 the can, engine will try to stall hold the speed up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to reset the base idle control

Sep 28, 2012 | 1995 Nissan Sentra

1 Answer

1999 sentra p0505 and p0301


the p0505 is a idle code look at the p0301 that is cylinder one misfire check the spark plugs and wires

Apr 21, 2012 | Nissan Cars & Trucks

1 Answer

'01 Nissan Sentra stalling when stopped - shop has had it 5 months: help!


If the idle air control valve is working, the passage may be clogged. Other things to check are the PCV flow and possible vacuum leaks.

Please see my tip at http://www.fixya.com/cars/r7427423-fix_poor_idle_high_idle_stalling_fuel . These are generic instructions. If you get stuck or need specific instructions for your car, please get back to me with engine size info.

Dec 30, 2011 | Cars & Trucks

2 Answers

I need the Torque Specs for a Nissan Q-R 2.5 Engine?


Nissan QR 2.5 engine produces a torque of 180 ft·lbf (244 N·m) of torque at 4000 rpm .

Oct 11, 2009 | 2003 Nissan Sentra

3 Answers

Torque settings for cylinder head nissan sentra


Tighten in sequence to 29ft.lbs then tighten in sequence to 58ft lbs. then loosen all bolts. Then tighten in sequence to 33ft lbs. then tighten each bolt in sequence 90 degrees then tighten each bolt again 90 degrees

Jul 18, 2009 | 1999 Nissan Sentra

1 Answer

Nissan 200sti


There are several things you can do including:

Ensure proper tire pressure
Remove all unnecessary things from your car to reduce weight
Tuneup: spark plugs, wire, rotor cap, rotor, fuel filter, air filter
In Summer: open windows at low speed, use A/C at high speed (if you are hot, that is)
Ensure you have proper wheel alignment
At a stop, gradually accelerate to speed, do not floor the pedal
Coast to a stop, meaning you let off the gas way early and use your brake less in the process
Do not go over 55 MPH

Doing all of the above mentioned, I have increased my mileage by almost 25%.

Oct 22, 2008 | 1997 Nissan Sentra

1 Answer

Idle problem


Yes you can,

do this with your RPM setting,

you ahve to just set you engine race settings,

try & having funn with your car,

THNX

May 18, 2008 | 1993 Nissan Sentra 4 Door

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

43 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...