Question about 2002 Ford Explorer Sport Trac

Open Question

Where is the flasher hazard lights relay location in a 98 ford explorer

Where is the hazard lights relay location 98 ford explorer

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
wfservices
  • 260 Answers

SOURCE: location of starter relay on 98 ford explorer

starter relay is under hood on the drivers side fender area.034ad7c.gif

  1. Disconnect the battery ground cable (14301).
  1. Disconnect the starter motor solenoid relay switch wiring.
    1. Remove the protective cover.
    1. Disconnect the push-on electrical connector.
    1. Remove the nuts.
    1. Remove the cable.
    2. d57efc7.gif
    Remove the starter motor solenoid relay switch (11450).
    1. Remove the engine sensor/generator wires.
    1. Remove the bolts and ground wire.
    1. Remove the starter motor solenoid relay switch
    2. 1056336.gif

Posted on Mar 14, 2010

Ad
chuck943
  • 783 Answers

SOURCE: where is the flasher for the turn signals in a 1999 ford explorer

The 2 fuses are no 10 (7.5amp) and no 21(15amp) in the interior fuse panel.The flasher is located on the base of steering column under dash. See this this pic find connector c214 on bottom 3rd from right.
http://i253.photobucket.com/albums/hh43/chuck943/EXN15113.gif

Posted on Mar 14, 2009

john631068
  • 172 Answers

SOURCE: 98 ford explorer oil pressure sensor location

2.9L and 4.0L engines-Left side front of the engine, below the cylinder head in the engine block

237d46d.jpg

Posted on Nov 28, 2009

ZJLimited
  • 17970 Answers

SOURCE: 99 ford contour hazard flasher unit where is it

Flashers - REPLACEMENT

Turn Signal Flasher
(see Figure 1)

e21631a.jpg

Fig. 1: The turn signal flasher is located on the multi-function switch in the steering column

  1. Disconnect the negative battery cable.
  2. Remove the upper and lower steering column shrouds.
  3. Pull the flasher from the back of the multi-function switch.

To install:
  1. Install a new flasher in the multi-function switch.
  2. Install the column shrouds.
  3. Connect the negative battery cable.

Hazard Warning Flasher
  1. Disconnect the negative battery cable.
  2. Remove the knee bolster panel from the underside of the driver's side of the instrument panel.
  3. Grasp and pull the flasher from the connector located near the top of the steering column.

To install:
  1. Install a new flasher in the connector.
  2. Install the knee bolster panel.
  3. Connect the negative battery cable.

Hope this help (remember comment and rated this).

Posted on Apr 02, 2010

  • 73 Answers

SOURCE: flasher relay located in a 1998 ford explorer

flasher relay is in the #10 location (7.5A fuse), also #21 location (15A fuse) in the power distribution box that is under the hood.

Posted on Apr 07, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Turn signal harness 2002 ford ranger 14a320 diagram turn signal connector wire colors and ppin location


images for Turn signal harness 2002 ford ranger

Ford explorer turn sinal problem got fixed - YouTube

? 3:23
www.youtube.com/watch?v=I2SUGIvYAWc
Jul 12, 2013 - Uploaded by Raybob216 My 04 exployer left turn signal and break light not working fix loose wires behind ... bulb and come to find out wire had popped out of the harness. ... How to Change Ford Explorer 2002 Flasher Relay for Hyper Flasher Relay ... How To Install Replace Turn Signal Wiper High Beam Switch Ford Ranger 95-98 ...

Oct 07, 2015 | Ford Cars & Trucks

1 Answer

1998 ford explorer. My signal lights not working but my hazard lights are. check the fuses but its not that could it be a relay.


you need to replace the turn signal flasher. it looks the same as the emergency flasher but only operates when the signals are needed.

Oct 10, 2014 | Cars & Trucks

1 Answer

I do not have any turn signals or hazard light on my 2000 ford focus zetec how do i correct this


There is a flasher unit that controls both the normal indicators and hazard flashers, on a 98 ford escort it is fixed to the base of the indicator stalk switch, if you remove the shroud that covers the switches around the top of the steering column you can see the flasher unit, usually it is black and just plugs in to the bottom of the hazard and indicator switch. The unit should have an ignition supply to it as well as a perm ant supply when the hazard switch is pushed down. Sometimes these switches get sticky contacts so if you bang the switch on and off a few times it can sometimes make the contacts work and then then all the indicators start working again.

May 01, 2014 | 1998 Ford Escort

1 Answer

The turn signal lights on my 2004 Ford Explorer stay on and don't blink. My hazards flash, but there is no clicking sound of normal use. Eventually, they tend to come back on, or blink with the...


Sounds like your flasher relay is broken. A lot of people think that because their hazard flashers work that everything is OK, this isn't so. Hazard flashers are on a seperate system, and as such they have their own relay.
You will need to find where your indicator relay is located and replace it with the correct type.

Aug 17, 2011 | 2004 Ford Explorer

1 Answer

My turn signals and emergency flashers work some time where is the turn signal flasher relay located and how do you detach it?


For 1998 Ford Truck Explorer 4WD 4.0L EFI SOHC 6cyl the Flasher is located in front seating area, driver side, behind dash, mounted on steering column.

Both the turn signal flasher and the hazard warning flasher are mounted on the fuse panel on the truck. To gain access to the fuse panel, remove the cover from the lower edge of the instrument panel below the steering column. First remove the two fasteners from the lower edge of the cover. Then pull the cover downward until the spring clips disengage from the instrument panel.

The turn signal flasher unit is mounted on the front of the fuse panel, and the hazard warning flasher is mounted on the rear of the fuse panel.

Hope helps.

Jan 26, 2011 | 1998 Ford Explorer

2 Answers

Location of turn signal relay for a 2001 ford expolrer


look under the dash to the right of the steering wheel. both the turn signal and hazard light relay should be there.

Jan 23, 2011 | 2001 Ford Explorer Sport

1 Answer

Need to know location of the turn signal flasher in 98 ford mustang


The electronic flasher is right next and part of the under dash fuse panel. The flasher looks like a fuelpump relay and may even plug where one goes, It has 5 blades, and costs 20 bucks at Oriley Auto parts/ This part seldom fails and it's designednot to blink but just stay on if there's a bulb out. Best check all of the bulbs by turning all the lights on with the hazard flasher sitch and see which ones aren't working and fix them first. If the hazards out the turns will too as the flasher is good anyway.

Oct 24, 2010 | Ford Mustang Cars & Trucks

1 Answer

Where is flasher located 1999 ford explorer


turn on hazard lights and listen for click and follow noise, there will be 2 flashers in this area. the 1 not clicking is the turn signal flasher.

Aug 20, 2009 | 1999 Ford Explorer

1 Answer

The turn signals dont work on a 2000 Ford EXplorer


most likely not in the fuse box nor is it a relay, check the fuse and replace if necessary. Turn on your hazards and listen for a clicking sound under the dash on the drivers side. Normally the hazard and turn signal flashers or near each other. Not a Ford fan so I can't exactly say where it is located.

Aug 15, 2009 | 2000 Ford Explorer

2 Answers

Where is the flasher for the turn signals in a 1999 ford explorer


The 2 fuses are no 10 (7.5amp) and no 21(15amp) in the interior fuse panel.The flasher is located on the base of steering column under dash. See this this pic find connector c214 on bottom 3rd from right.
http://i253.photobucket.com/albums/hh43/chuck943/EXN15113.gif

Mar 14, 2009 | 1999 Ford Explorer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

118 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5520 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...