Question about 1995 Dodge Dakota

1 Answer

2002 dodge dakota truck right side headlight not working. Checked voltage and only getting 8 volts at headlamp plug. any ideas?

Have changed plug and still not working.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 325 Answers

Could be worth checking headlamp relays for power drop on output side,if not try a check on headlamp earthing points...Good-luck..

Posted on Jan 05, 2013

Testimonial: "Thanks I will check those"

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
sprintfanm
  • 2 Answers

SOURCE: I need information on how to change spark plugs on a 2004 Dodge Dakota 4.7 liter V-8

Make sure that you buy the correct type plugs(Champion RC12MCC4 or equivalent). Also it may be a good idea to have a flexible-extension for your ratchet.

Posted on Jun 26, 2008

  • 5 Answers

SOURCE: Changing a 2002 Dodge Caravan headlight

Hello, You remove the headlamp assembly by removing the 3 bolts that hold it in place. The bolts are #1 in the following picture:

7e81e20.gif

Posted on Oct 23, 2008

  • 1 Answer

SOURCE: headlamp

There are 2 screws one the frame above the headlight after you open the engine hood. One screw has a long shaft, both need to be removed and will release the headlight housing. Next you need to pull the headlight assembly out which might mean you have to push down on the plastic surrounding the assembly. Once the assembly is out all you need to do is pull up on the clip that holds the wiring and pull it off. There is a plastic ring around the lightbulb that you need to screw off and then you'll be able to pull out the bulb. Make sure you have a new HB5/9007 type replacement bulb, and do not touch the glass on the bulb with your fingers, if you do take a soft cloth and wipe the glass to remove any oils. After you place the new bulb in the assembly, put everything back in reverse of how you removed it and you'll be finished.

Posted on Nov 04, 2008

  • 1 Answer

SOURCE: how to fix gauges on 1997 dodge dakota truck

how do i remove the gauge face on a 2000 dakota

Posted on Jul 20, 2009

mrjfisher
  • 141 Answers

SOURCE: My 2001 Dodge Dakota pickup, No headlights.

There is a fuse you may have more then one fuse box look under the hood & under the dash. Most of the time Chrysler will just put a number next to the fuses. Go to your owners manual & see what number is your head light fuse. If you still can't find the right fuse take your test light & check both side of each fuse if one side lights up & one side does not replace it with the same size fuse.

Posted on Jun 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Everything blinks when lights are turned on,changed the headlight relay and everything is still blinking, even changed out the switch. Any idea what is making everything blink?


What is everything blinking ? headlamps , dash lamps ,what else ? The headlamp switch is an input to the central timer module !
Also does it do it with headlamps hi or low beam ? Don't know what relay you replaced , there is no headlamp relay ! There is a park lamp relay ! http://bbbind.com/free_tsb.html Go here an check out wiring diagrams . Enter your vehicle info. Then under system click on lighting ,then under subsystem click on exterior lighting !

Apr 16, 2016 | 2002 Dodge Dakota Club Cab

2 Answers

'02 Taurus SES Headlights and Hi Beams not working, Hi beams work w/ momentary lever pulled back


There is no relay for the headlamps on your Taurus . The lamps have constant B+ voltage , the fuses supply B+ right to the headlamps . The Voltage then travels to the dimmer an flash to pass switch on the steering column , then to the headlamp switch . When you turn on the headlamps the B+ voltage then goes to ground through the headlamp switch ! Pull the headlamp switch an test for B+ voltage on the red with yellow stripe wire . If you do your switch is bad . Go to www.bbbind.com/ for free wiring diagrams , then go to youtube an check out videos on headlamp not working trouble shooting ! From practical experience I'd say there is a problem with the headlamp switch , but don't guess test !

Jan 18, 2016 | 2002 Ford Taurus

1 Answer

95 Dodge Dakota headlights, taillights dash lights suddenly went out. Have turn signals and flashers, no brake lights. Replace 15 amp fuse under dash that was blown nothing, replaced headlight switch


Did you check for voltage at the 50 amp fuse circuit. Even if the fuse is good if no voltage on the fuse circuit, the circuit is still dead. There is a light green wire that carries voltage from headlamp switch to dimmer, is that wire hot with headlamp switch on?

There are wiring diagrams for free, just about everywhere, if you don't have one. Autozone .com has free wiring diagrams on vehicle repair guides link. You have to register your vehicle, year--make--model, all that good stuff. It's free.

Dec 15, 2014 | 1995 Dodge Dakota

1 Answer

My 1998 dodge Dakotas headlights went out so I changed the switch and now the headlights work but the taillights don't work. Every other light works except the running lights. Also the light that show


The black wire with yellow tracer is voltage for tail lamps. With the headlamp switch on, any voltage on that wire? Use a test light to check. Also check fuse 14--15amp.

Dec 11, 2014 | 1998 Dodge Dakota

2 Answers

1999 DODGE DAKOTA HEADLIGHTS NOT WORKING , i HAVE CHECKED ALL THE FUSES AND REPLACED THE HEADLAMPS, STILL NOTHING, WHAT ELSE CAN IT BE?


Sounds like either a headlight switch or a broken ground. Did you lose both the hi and low beams? Do your parking lights work? The headlight switch outputs to the hi/low selector on the column. If both hi and low beams are out I would check output voltage from the switch. Sounds ike that make be your issue. Good luck and let me know if I can assist further.

Nov 15, 2010 | 1999 Dodge Dakota

1 Answer

TRUCK BLOWS A LOT OF HEADLIGHTS...BOTH SIDES, ANY IDEAS WHERE TO START


usually due to high resistance causing high voltage. Check voltage at headlamp. should be between 12 & 14 volts.
check headlamp grounds. if loose or corroded, it will cause high current draw.

Mar 10, 2009 | 2006 Dodge Ram 3500 Truck

3 Answers

Why is does my 1997 dodge dakota's headlights flicker on and off.


UNDER THE HOOD ,,DRIVERS SIDE, BLACK BOX,, ARE CIRCUIT BREAKERS,,, 50 amp breaker goes to headlamps,, 50 amp goes to blower motor, switch those breakers around and problem is solved...

Jan 25, 2009 | 1997 Dodge Dakota

1 Answer

2004 Dodge Dakota


Replace your resistor if you haven't already. I had the same issue with mine, it only worked on high.

Nov 24, 2008 | 2004 Dodge Dakota

Not finding what you are looking for?
1995 Dodge Dakota Logo

117 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...