Question about 1995 Buick LeSabre

1 Answer

Accidently crossed jumper cables on my 95 buick lesabre has power but wont click or turn over

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Does that have a silonoid on the starter or seperate from the starter? either way i would test the silonoid. i usually take a screw driver an touch it post to post on the. make sure to keep your hand on the handle an not on the metal because you might get shocked. usually when a vehicle wont turn over but clicks its the starter but if it doesnt click then its the silonoid. hope this helps.

Posted on Jan 05, 2013

  • cbf1984666
    cbf1984666 Jan 05, 2013

    thats kinda what i was thinking i crossed the posts and it started to turn i also checked all the fuses and relays including the fusible link but can crossing the wires even kill my solenoid like that

×

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: 95 buick lesabre wont start

98 buick lesabre wont crank with key. When I cross the starter it runs great for 10 seconds and dies.

Posted on Dec 12, 2008

  • 4 Answers

SOURCE: 1995 buick lesabre wont start have power to everything

you might try turning the key all the way back to reset the system or if ur steering wheel is locked hold it all the way to one direction while starting it... thats the way ive fixed that problem in other cars but if that dont work then im clueless

Posted on Feb 10, 2009

  • 120 Answers

SOURCE: 1995 buick lesabre wont start have power to everything

yes it could check batteries in the remote or check the security wires on the back of the ignition switch behind the steering wheel

Posted on Feb 19, 2009

SOURCE: To program the keyless remote for a 1998 Buick

under drivers side dash, with small wire or paper clip.

Posted on Mar 15, 2009

  • 148 Answers

SOURCE: 1997 buick Lesabre limited all lights come on,wont start

the ingnition switch has a wire broken that wont allow the computer to turn the security system off to let the car start

Posted on Jul 19, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

No communication with pcm on 95 buick lesabre 3.8 have replaced pcm checked powers and grounds any ideas would be appreciated


What did you replace with used or new pcm ? has to be programed . Important:: Replacement PCM must be programmed. Refer to Powertrain Control Module Replacement/Programming
In 95 they used UART serial data pin 9 at DLC a tan wire.No class two yet.

Jan 23, 2015 | 1995 Buick LeSabre

1 Answer

1993 buick lesaber clicks once wont start


check your postive battery cables that model should have 2 cables at the postive with a spacer between them they are famous to corrrode under the red covers requiring the ends to be replaced or the whole of both to be replaced if corrosion has traveled down into the cables

Feb 14, 2013 | 1993 Buick LeSabre

1 Answer

95 Buick LeSabre 3.8 L which is the fuel pump relay?


You can usually go by the wire colors. The fuel pump relay wires are pink, gray, black, and green with a white stripe. When troubleshooting a fuel pump that is not coming on, the relay is the best place to figure out why. You can pull the relay out and put a jumper wire from the battery to the terminal with the gray wire. If the pump runs, you know that isn't the problem. Then turn the key on and use a jumper between the terminals with the pink and gray wires. If this turns the pump on, you know the ignition switch is sending power to the relay, and the fuse is good. Pull that jumper out, but leave the key on. Push the relay back into the socket, but put a jumper from a ground point to the terminal with the black wire. If that turns the pump on, the ground wire is bad. If not, the PCM is not turning the relay on. Reasons for that may be a bad wire from the PCM, a passlock issue, or the PCM fuse/power wire.

jturcotte_1838.gif

Jun 14, 2011 | 1995 Buick LeSabre

1 Answer

Wont start in the cold , it will turn over but wont catch


If possible have someone give you a jump next time that happens. If it starts with the jumper cable hooked up then you have a weak battery which isn't supplying enough voltage to the fuel pump and injectors.

Dec 28, 2010 | 2001 Buick LeSabre

1 Answer

How do you jumpstart an ac compressor 96 buick lesabre


connect jumper wires to the negative and positive parts of the harness connector to energize the clutch on the compressor.

Make sure you do not cross live wires as this can cause injury or death some cases.

Jun 29, 2010 | 1996 Buick LeSabre

1 Answer

My 1998 buick lesabre wont crank and it makes a clicking noise when I try to start it


if it clicks more than likely a jump start will get it going and unless the headlights or other power is left on you might need a battery or alternator also the car is new enogh it will need a direct 12 volt power source for the pcm so if you un-hook the jumper cables and it dies it definetly needs a battery hope this helps

Jun 10, 2010 | 1998 Buick LeSabre

1 Answer

Niether fan on my 95 lesabre won't turn on


usually always hot. the fans sometimes run for a while even after leaving the car. look for voltage. if there then it/s the heat sensor or it's wiring. if not its the wire,fuse,relay or fusible link as i am not familar with your model

Jul 28, 2009 | 1993 Buick LeSabre

1 Answer

93 buick lesabre 3.8 liter starter replaced,new one just clicks


Given the steps you have taken, only one of two things this can be is a resistive connection between the battery and the starter solenoid terminal. Or the battery itself has a bad internal connection. Bear in mind: you cannot crank the engine through the average set of jumper cables unless the battery in the dead vehicle will hold and deliver a good charge. Jumper cables are not really intended to start the car, they are for boosting the good, but low battery in the car being jumped.

Dec 16, 2008 | 1993 Buick LeSabre

2 Answers

95 buick lesabre wont start


98 buick lesabre wont crank with key. When I cross the starter it runs great for 10 seconds and dies.

Nov 08, 2008 | 1998 Buick LeSabre

Not finding what you are looking for?
1995 Buick LeSabre Logo

Related Topics:

70 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8270 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...