Question about Chrysler Neon

Open Question

Where is the heater control valve on a 2000 chrysler neon lx

Where is the heater control valve located on a 2000 chrysler neon lx

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 396 Answers

SOURCE: where is the heater control valve locatedon a 2002 mitsubishi

Most heater control valves are on or near the firewall behind the engine. Look for coolant hoses attached to a small metal piece. It also will have an arm that has a cable from inside the vehicle attached to it.

Posted on Oct 19, 2009

Ad
  • 21 Answers

SOURCE: chrysler neon lx gearbox

If you find one that has a 4-speed and the same engine size, then they will fit. What you need to watch for is that you get the correct gear ratio tranny to keep your car operating properly. I only know one way to know for sure and that is a number stamped just above the pan rail on the bottom oil pan. It will be long and have some letters at the start of it. You may be able to get that to a dealership and have them look it up. If the donor transmission is still in the car then the vehicle id number should tell you what ratio the trans is when it's looked up. That is how it's done with the US cars, it may vary a bit with the UK ones, but I am not sure.

Posted on Nov 13, 2008

dgjtex
  • 405 Answers

SOURCE: heater not producing hot air

look between engine and heater core on heater hoses. It will be there on one hose or the other.

Posted on Dec 28, 2008

  • 15 Answers

SOURCE: 1995 Nissan Altima Heater contorl valve location

HELLO THE HEATER CONTROL VALVE IS LOCATED AT THE REAR CENTER OF THE ENGINE COMPARTMENT BY THE FIREWALL

Posted on Mar 02, 2009

  • 396 Answers

SOURCE: where is the heater control valve 2000 siverado

Most heater control valves are up next to the firewall behind the engine. Look for coolant hoses running to that area.

Posted on Oct 13, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I bought a 2000 chrysler cirrus lx and the car is idleing high why is that?


before you spen money on a idle control valve look at the engine breather pipes,and look good for a split or perished pipe

Aug 27, 2010 | 2000 Chrysler Cirrus

1 Answer

Airconditioner compressor (clutch) on 2001 chrysler neon 2.0 does not activate when turning on a/c. a) bypass of a/c relay in engine comparment control box causes clutch to engage b) fuse is not blown. c)...


Resolution:
The problem turned out to be a blown fuse labelled EBL Clutch, located in the instrument console (side panel in the dashboard next to steering wheel on a RHD model).

I downloaded the manuals of the Neon and it advised a sequence of checks to be done:
1. Test High Pressure switch located on compressor - check that the switch w/o/ cable gives a closed reading, then test with bypass in cable.
2. Test Low pressure switch located on accumulator, ( I could not find this switch). Bypass of this switch should engage the compressor clutch
3. I discovered the blown fuse when trying to activate the rear window heater and saw that the light on the switch did not activate - went looking for the fuse for this device and then found the EBL Clutch, really by accident. Shows you how confusing an abbreviated label on a fuse can be and that it does not always support the significance of it.

Other observations:
1. A/C compressor cannot run non-stop and must be controlled by the A/C controller. Hard wiring the clutch and running the engine for a few minutes led to the compressor shuddering and then discharging some gas through the saftefy valve. Normally this power supply would have been interrupted by the high pressure valve.
2. Release of coolant gas from the high pressure safety valve located on the compressor may indicate a faulty high pressure switch, but the primary or underlying reason may be due to a blocked Dryer in the A/C system.
3. The Daimler Mercedes Neon Agents, and an A/C company and an auto electrical company all attended unsuccessfully to this problem. No discredit meant in any way, it just shows that the incorrect label here makes solving such an ordinary problem very problematic. If any advice can be given to the Agents, read the manual.

Dec 23, 2009 | 2001 Chrysler PT Cruiser

2 Answers

Where is the frost plug installed on a 2000 plymouth neon?


there are several.4-6 or more?? if the coolant is rusty, plan on doing all of them or sell the car. BIG $$$$...If you have not kept up with the coolant service,you will have much bigger problems later on. how many miles? at 90k miles replace the timing belt, tensioner and water pump, use factory chrysler parts only. if you dont and the belt breaks, or water pump siezes, the engine will be trashed.

Oct 02, 2009 | 2000 Dodge Neon

1 Answer

Auto Chrysler Neon Petrol consuming issue


That's only 17 or 18 MPG/U.S. Gal. Not very good for a Neon. When was engine serviced last, as in air filter, oil filter , oil change, and perhaps a scan for any trouble codes? What type of driving conditions?

Jun 28, 2009 | 2006 Chrysler Neon

1 Answer

Cd player inoperable


Radio fuse blown - Check your documentation on fuse panel lid or owners manual.
You're looking for a red 10A fuse.

Feb 03, 2009 | 2004 Dodge Neon

1 Answer

Heater Control Valve 2000 Taurus SE


Taurus doesn't have what is called a heater control valve,are you reffering to the remote climate control module,the one that the vacuum lines hook to? If so it is behind the glove box. Just open the glove box and press the 2 clips on the sides so it opens all the way up and it will be located right behind this.

Jan 28, 2009 | 2000 Ford Taurus

1 Answer

Air id warm not hot where is the heater control valve located


remove the glove box and look left blend door motor is sticking

Jan 17, 2009 | 2000 Ford Expedition

1 Answer

Heater valve


Check heater hose routing up to firewall area, or back from, and control should be there in line.

Jan 16, 2009 | 1995 Chrysler New Yorker

2 Answers

Chrysler neon lx gearbox


If you find one that has a 4-speed and the same engine size, then they will fit. What you need to watch for is that you get the correct gear ratio tranny to keep your car operating properly. I only know one way to know for sure and that is a number stamped just above the pan rail on the bottom oil pan. It will be long and have some letters at the start of it. You may be able to get that to a dealership and have them look it up. If the donor transmission is still in the car then the vehicle id number should tell you what ratio the trans is when it's looked up. That is how it's done with the US cars, it may vary a bit with the UK ones, but I am not sure.

Sep 23, 2008 | Chrysler Neon Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

181 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8589 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...