Question about 1997 Nissan Quest
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Go to Auto Zone, get a Haynes manual on this vehicle. It will tell you where it's at and also help you with future problems.
Posted on Jan 07, 2009
Mine did this as well, you have to remove the cover that the button is in. I think there is a couple of hidden screws the it just snaps in the rest of the way. I never got mine all the way off, just enough to pop the switch back into place and now just careful not to push to hard on it.
Posted on Feb 08, 2010
The camshaft sensor is located inside the distributor and is part of it, in order to replace it you must replace the distributor,to replace remove the dist cap. mark the location of the rotor,by marking where its pointing to, then mark the dist housing, so now theres a mark on the rotor and housing to show where rotor points, next mark the location of dist going into housing, mark the shaft and the block,because it spins in block this way you can line back up.next remove hold down bolt and pull out,mark the new dist in exacat same spots as the old so you can install back the same,you may have to put it in and pull it out until your marks are lined up,this way the timing will be dead on, when done you can check timing. good luck
Posted on May 09, 2010
i beleive its on the l/h side (drivers side) next to your left foot. its mounted on the side of vehicle right above the kick panel. its a black squear with red button inside of it.
Posted on Dec 25, 2010
Testimonial: "found it! lol ty"
SOURCE: 2005 Nissan Maxima SL, trunk
does it work when you press release on key fob?if so remove the glove box and make sure someone performing work previously in that area didnt foget to plug it in.
Posted on Feb 01, 2011
Tips for a great answer:
Apr 05, 2017 | 1997 Nissan Quest
Aug 04, 2012 | 1997 Nissan Quest
Apr 20, 2012 | Toyota Camry Cars & Trucks
Feb 24, 2011 | 1997 Jaguar XJ6
Dec 25, 2010 | 1997 Nissan Quest
Jul 26, 2010 | 2004 Nissan Quest
Jan 07, 2009 | 1997 Nissan Quest
29 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: