Question about Ford Tempo

Open Question

How to replace ecu in a 1990 ford tempo

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 337 Answers

SOURCE: 1992 ford tempo water pump replacement

http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528005d60d

Posted on Dec 07, 2008

  • 1114 Answers

SOURCE: 1990 ford tempo

if you have a 1.3L 4cyl these were famous for the idle solenoid on the intake manifold located close to wind shield drivers side two wire plug and 2 10mm bolts it is round looks like a cap on it cant miss it!!use EFI cleaner spray it out good this opens and closes sometimes carbon plugs them up you should get a lot of black carbon out when spraying it out this should help hope it did. John

Posted on Feb 15, 2009

michigan man
  • 3533 Answers

SOURCE: Manual for 1990 Ford Tempo

try your local library and they can make copies for you

Posted on Mar 01, 2009

emissionwiz
  • 75066 Answers

SOURCE: WATER PUMP REPLACEMENT 1990 FORD TEMPO

disconnect the side motor mount and raise that side of the engine up with a floor jack, be very careful not to damage the oil pan.

Posted on May 28, 2009

  • 93 Answers

SOURCE: need to replace broke window on 93 ford tempo.Pass. side

Door Glass, Front Removal

  1. Remove door trim panel and watershield. Refer to Section 01-05. ani_caut.gif CAUTION: Prior to removing center pins from the rivet, it is recommended that a suitable block support be inserted between door outer panel and glass bracket to stabilize glass during rivet removal. Remove center pin from each rivet with a drift punch. Using a 1/4-inch diameter drill, drill out remaining rivets as damage to plastic glass retainer and spacer could result.
  1. Remove two rivets attaching glass to run and bracket assembly.
  1. Remove glass.
  1. Remove drillings and pins from bottom of door.
Installation
  1. Snap plastic retainer and spacer into two glass retainer holes. Make certain that metal washer in the retainer assembly is on outboard side of glass.
  1. Insert glass into door.
  1. Position glass to glass bracket. Install two rivets to secure glass to glass bracket. NOTE: Two 1/4-inch-20 x 1-inch bolts and two 1/4-inch-20 nut and washer assemblies may be used as alternates for glass retention. However, torque must not exceed 4-7 Nm (36-61 lb-in). Equivalent metric retainers (6mm) may be used.
  1. Install door trim panel and watershield. Refer to Section 01-05.


2-Door Vehicles


n5878h.gif



4-Door Vehicles


n5879g.gif

Posted on Jun 02, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

WHERE on a 1990 FORD TEMPO location is the RELAY that controls the switch to the heater blower ???


IT BE NEXT TO THE BLOWER MOTOR WITH WIRES GOING INTO IT HELD ON WITH TWO SCREWS CALLED A BLOWER MOTOR RESISTER.

Dec 16, 2015 | 1990 Ford Tempo

1 Answer

1990 Ford tempo will not start unless I wiggle the shifter when in park


Id check / replace the "park switch".
It is either loose or is faulty.

Hope this helps...

Jul 24, 2011 | 1990 Ford Tempo

1 Answer

Im going to the junk yard to get a power steering pump and i need to know if theres any other year than 1990 that will fit on my 1990 ford tempo?


WHY BUY A JUNK YARD POWER STEERING PUMP 12 YEARS OLD SEALS PROBABLY CRACKED DRIED UP. 94 TOPAZ HAS SAME ENGINE 2.3 2300CC. FROM 1990 TO 1994 HAS SAME ENGINES.

Feb 02, 2011 | 1990 Ford Tempo

1 Answer

1990 ford Tempo


Almost any model of Ford is known for it's defective ignition switches.They have even been known to cause fires in the steering column and dashboards.My recommendation is to replace it as soon as you can.

Mar 01, 2010 | 1990 Ford Tempo

1 Answer

Need color codes for stereo 1990 ford tempo


Hi and welcome to FixYa,

Would the below wiring scheme help?

4f754b8.jpg

Good luck and thank you for asking FixYa.

Aug 02, 2009 | 1990 Ford Tempo

1 Answer

Installing New HeadLight Cover 1990 Ford Tempo


yes replace the lens and that will fix the problem.

May 28, 2009 | 1990 Ford Tempo

1 Answer

WATER PUMP REPLACEMENT 1990 FORD TEMPO


disconnect the side motor mount and raise that side of the engine up with a floor jack, be very careful not to damage the oil pan.

Apr 10, 2009 | 1990 Ford Tempo

1 Answer

Manual for 1990 Ford Tempo


try your local library and they can make copies for you

Mar 01, 2009 | 1990 Ford Tempo

1 Answer

Need fuse diagram for 1990 ford tempo.


Horns generally don't have fuses. Judging from the year it could be shot. replace with a new one as they are generally pretty cheap.

Aug 06, 2008 | 1990 Ford Tempo

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5470 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...