Question about Cars & Trucks
Posted by Anonymous on
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
The first thing i would check is all 4 abs sensors at the wheels.You can do this with a volt meter set on ac voltage and spin the wheel if it generates voltage at all on the meter its good.
Posted on Mar 06, 2009
there is nothing to do here but have the dealer run a scanner test to see what trouble codes were set with the lights coming on, until then there is no way to tell what the problem might be as there are over 200 possibilities.
Posted on Jun 22, 2009
SOURCE: abs light on in land rover
I have spent way too much money trying to get the 3 amigos to go out...ABS light, TC light and downhill descent. I have decided to try and ID the wires that go to those particular dash lights and cut them. I am tired of this ****. Landrover told me three different things that may cause this issue and told me to start with the least expensive one first! Go to hell, Landrover. I will NEVER buy another Landrover product. Which wires can I cut?
Posted on Oct 20, 2009
Traction control only works when one wheel is spinning faster than the other it trys to even them out so it wont spin...sometimes if one of the wheels come off the ground in an uneven area or if you take a turn too fast and one wheel turns when the other one dont it is designed to operate.
I would remove all wheels and check the braking system...Is it 4 wheel disc or rear drum ?
If it has rear drums you could have a wheel cylinder leak that will sometimes lock the wheel because of fluid contamination....This would cause both lights to come on...If you find no problems
sometimes the abs sensor builds up fragments on the magnet and makes the light come on...
or if the abs sensor is not close enough to the exciter ring it will make the light come on because it will be out of adjustment.....all you do is press the sensor inward until it barely touches the ring and it will adjust itself....You can sometimes clean the magnet if it is contaminated and make the light go off ( only after you reach 6 to 15 mph. it will go off ).If it dont go off you have to buy a sensor.
Also make sure all tires have same amount and plenty of air to keep vehicle in balance/level.
Posted on Feb 21, 2011
Tips for a great answer:
Feb 22, 2017 | Rover Cars & Trucks
Feb 18, 2015 | 2001 Land Rover Discovery Series II
Dec 26, 2010 | 2002 Land Rover Discovery Series II
Nov 23, 2010 | 2002 Land Rover Discovery Series II
Sep 30, 2010 | 1999 Land Rover Range Rover
Nov 08, 2009 | 2002 Land Rover Freelander
Nov 03, 2009 | 2002 Land Rover Freelander
Jun 19, 2009 | 1995 Land Rover Range Rover
Mar 08, 2009 | 2000 Land Rover Discovery
Jun 26, 2008 | 2001 Land Rover Discovery Series II
434 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: