Question about 2003 Chevrolet Monte Carlo

Open Question

Monte carlo 2004 tune up - 2003 Chevrolet Monte Carlo

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

emissionwiz
  • 75797 Answers

SOURCE: 2004 monte carlo sunroof won't close

THERE IS NO MAN OVERIDE, REMOVE THE DRIVE MOTROR AND THE SUNROOF WILL CLOSE.

Posted on Dec 11, 2008

GM Elec
  • 1000 Answers

SOURCE: how do you reset the computer on a 2004 chev monte

You can reset the vehicles PCM ( computer) to factory default by disconnecting both negative and positive battery cables for 20 minutes.
All calibrations will return to nominal.
Good luck, let me know.
Regards,

Posted on Jul 30, 2009

  • 436 Answers

SOURCE: 2004 monte carlo. turn signals dont work. the

try pressing the hazards on and off if they still don,t work replace the flasher unit. it is built into the hazard switch( all one unit ) change this and all will be good.

Posted on Aug 30, 2009

carfreakt
  • 68 Answers

SOURCE: need to replace water pump 2004 Chev Monte Carlo

ok take the belt off take the hose off the pump catch the antifreeze take the bolts off the pump clean off the old gasket off the engine and install new pump and gasket reinstall hoses and bolts anrefill with anti freeze and reinstall belt start it and make sure it does not leak
good luck

Posted on Oct 05, 2009

techbuster
  • 5081 Answers

SOURCE: replacing heater core on 2004 monte carlo

REMOVAL PROCEDURE 1. Remove the fuel injector sight shield. 2. Drain the cooling system. Refer to Draining and Filling Cooling System in Cooling System. 3. Use J 38185 in order to position aside the heater hose inlet and outlet clamps at the heater core. 4. Disconnect the inlet and outlet heater hose from the heater core. 5. Remove the RH Instrument Panel Closeout/Insulator panel. 6. Remove the LH Instrument Panel Closeout/Insulator panel 7. Remove the floor carpet. 8. Remove the rear floor air outlet duct from the holes in the floor reinforcement. 9. Disconnect the rear floor air outlet duct from the heater air outlet cover. 10. Remove the rear floor air outlet duct. 11. Remove the heater air outlet cover screws (2). 12. Remove the heater air outlet cover heat stakes (1) with a small chisel. 13. Remove the heater air outlet cover from the HVAC module assembly. 14. Remove the heater core cover screws (2). 15. Remove the heater core cover heat stakes (1) with a small chisel. 16. Remove the heater core cover from the HVAC module assembly. 17. Remove the heater core from the HVAC module assembly. 18. Remove the heater core foam seal (1) from the HVAC module assembly

Posted on Nov 08, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I have the smell of gas inside my 2004 Monte Carlo, it started over a week ago, no sign of gas leak and gas mileage is still good. Anyone have any ideas?


I'd use a fuel pressure gage and check correct fuel pressure. Once correct pressure builds up, see if pressure holds for a bit with everything off? If pressure drops like rock, you have a fuel pressure leak. Another thought would be evap leak?
How long since a tune-up? Any applicable trouble codes?
smell-gas-inside-2004-monte-carlo-hosjjvp310ks0pxrhoabtzav-5-0.jpg

Nov 13, 2016 | 2004 Chevrolet Monte Carlo

1 Answer

2004 monte carlo. Turn signals dont work. The stalk still works with other functions, such as wiper, brights. The fuse is fine. Could it be a bad relay? When u push the stalk up or down nothing happens on...


try pressing the hazards on and off if they still don,t work replace the flasher unit. it is built into the hazard switch( all one unit ) change this and all will be good.

Aug 30, 2009 | 2004 Chevrolet Monte Carlo

1 Answer

Monte carlo


you might check the crank and cam sensors

Jan 29, 2009 | 2004 Chevrolet Monte Carlo

1 Answer

2004 monte carlo sunroof won't close


THERE IS NO MAN OVERIDE, REMOVE THE DRIVE MOTROR AND THE SUNROOF WILL CLOSE.

Dec 11, 2008 | 2004 Chevrolet Monte Carlo

Not finding what you are looking for?
2003 Chevrolet Monte Carlo Logo

Related Topics:

32 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...