Question about 1995 Buick Century

Open Question

1995 Buick Skylark, how to change spark plugs

Back spark plugs look like they're hard to reach.

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: 1995 buick riveria

Change the BCM (Computer) under glove box. Start the car and drive off! About $80 at Autozone or Advance Auto

Posted on Jan 20, 2009

  • 3 Answers

SOURCE: Replacing spark plug wires on 1995 Buick Riviera

You need to drain some coolant. Loosen and disconnect water lines by the firewall- the ones in the way of your wire change. u need to get a diagram of the firing order of the engine so that those wires are correctly connected to the coil packs.

Posted on Mar 25, 2009

honeymokey
  • 3113 Answers

SOURCE: while driving my 1995 park avenue it just cut off

Crank sensor?

Posted on May 05, 2009

matney68
  • 426 Answers

SOURCE: Cannot change 3 rear spark plugs on 1999 Buick park avenue

there is a special tool for this job but I have cheated on this but you ned to be careful when doing this.The wishbone shaped mount on the front going from motor to front of vehicle, remove and it allows the motor to tilt.

Posted on Jun 19, 2009

MNfisherman
  • 11896 Answers

SOURCE: i have 1991 buick skylark, have no spark to plugs

Do you have an anti-theft system on this car. That is about the only other thing I could think of besides bad relay or fuse. Since crank sensor and module are good.

Posted on Nov 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the oil sending unit on a 1995 Buick Skylark 3.1 V6?


OIL PRESSURE SWITCH

1995 Buick Skylark 2.3L MFI DOHC Quad 4 4cyl

The Oil Pressure Switch is located:

OIL PRESSURE SWITCH

1995 Buick Skylark 3.1L SFI OHV 6cyl

The Oil Pressure Switch is located: Under hood, center, front engine area, front driver side of engine, mounted in engine block

Jan 05, 2013 | 1995 Buick Skylark

1 Answer

How do i change the spark plugs in the 4 cylinder?


remove cover on top of motor if equipped there are no plug wires just boots attatched to cover then remove plugs and replace .

Sep 18, 2010 | 1995 Buick Skylark

1 Answer

I have a 1995 buick lesabre and i changed control module,position sensor,cam sensor and computer. car stop and will turn but want start. when i first bought car it had this vibration on take off but never...


Are you getting gas and spark to the cylinders?

If you add gas to the throttle body, does it start?
If so, then you have a fuel pump delivery problem in this vehicle.

If it doesn't start, then you may have a spark problem at the spark plugs due to a coil pack going bad or a module (but you said you changed the module).

Also, is this a 1995 Buick LeSabre of a 1993 Buick Skylark (which it is listed under)? What engine size is this?

Aug 06, 2010 | 1993 Buick Skylark

1 Answer

1995 buick skylark custom ran great now it chugs and acts like a spark plug isnt firing. runs rough and chugs at low speed under 35mph. rough idle.what would cause this?


start by checking the plugs, then see if you got spark at all the plugs, check for vacuum leaks, worn wiring, fuel pressure,

Nov 23, 2009 | 1995 Buick Skylark

1 Answer

Replacing spark plug wires on 1995 Buick Riviera


You need to drain some coolant. Loosen and disconnect water lines by the firewall- the ones in the way of your wire change. u need to get a diagram of the firing order of the engine so that those wires are correctly connected to the coil packs.

Mar 21, 2009 | 1995 Buick Riviera

1 Answer

1995 buick skylark can't get fans to work


it sounds like the fan is out on it you will probably need to replace it and its not hard to do three screws and a plug and then you put the new one in in its place.

Jan 24, 2009 | 1995 Buick Skylark

3 Answers

95 Buick Skylark Stops Running


the fuel pump is slowly going out

Dec 01, 2008 | 1995 Buick Skylark

1 Answer

1994 buick skylark 3.1


NEED TO KNOW WHAT SIZE MOTER

Aug 30, 2008 | 1994 Buick Skylark

1 Answer

Power window problems and spark plug removal


this sound to me like a broken wire in the door jam on the drivers door. this door has all the wires for all the windows running threw the rubber gromet. you will need a test light to check power at the wires you will also need to remove the drivers door panel to get at the switch and wiring to test. its just basic power and ground tests when you push the window button. i rate this repair a 7. the spark plug is real easy. disconnect the dog bone (the top motor mount that keep the engine from rocking for and aft. now put a jack and a block owood under the back side of the trans. this will tilt the engine foward and you can reach these plugs i rate this repair a 2

Jul 08, 2008 | 1994 Buick Skylark

Not finding what you are looking for?
1995 Buick Century Logo

Related Topics:

41 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...