Question about 2004 Chevrolet Colorado

Open Question

Blower motor dash switch 2004 chevy colorado not working

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: power door locks and drivers window have failed on 2004 colorado

I had the same problem to the T. I look online for all the same solutions and I can only tell you what worked for me. Actually what I think worked, HAHA! I went out to my truck and unplugged both battery terminals from battery and placed them together to supposedly reset the electrical system, "so I was told." After this for about 20 min or so, I went back out and in this order; re-installed positive terminal followed by negative terminal to battery. After this I checked locks and windows and surprise they worked. I've seen a lot of people say that all they did was wait and they worked later, so maybe it was that and not what I did, but who cares, they work now. Give it a shot and if it works for you, GREAT let me know, I HATE CHEVY CAUSE OF THIS......they wanted me to pay for a stupid diagnostic before they would help me........well screw you I fixed myself. LATER

Posted on Mar 06, 2009

  • 1 Answer

SOURCE: 1998 chevy blazer

check the fuse box under the hood and look for a burnt fuse (30A mini)
mine had the same problem and I check the fuses, found one that was blown,replaced fuse, now I have #4 position working

Posted on Jan 17, 2009

farroutideas
  • 78 Answers

SOURCE: blower only works on 4,123 not working.

Hi There;
You say your heater fan only works on high.

This issue can be repaired by replacing what is called the "blower motor resistor". The electrical current flows through this unit in all positions except #4.
If you look under the dash on the passenger side with the heater fan on #4 you will hear the blower motor running. Just slightly toward the drivers side of the blower motor & closer to the firewall you will see a four wire connector. this is attached to the "blower motor resistor". If you get a replacement one & examine it you will see two screw holes where you will need to remove the 9/32nds screws from the one in your truck to remove the fauly one & install your new on. This part is relitivly inexpensive & it is not worth trying to locate a used one.
Please let me know if you need more info on this
Farrout!

Posted on Mar 17, 2009

  • 540 Answers

SOURCE: 2004 colorado blower motor only works on 4

the blower motor resistor and connector located under the pass. side of the dash need replaced the connector melts and burns the resistor an updated part is available from the dealer I have replaced many of them

Posted on Jan 08, 2010

  • 623 Answers

SOURCE: 2005 Chevy colorado blower motor only work on

The blower only works on High because something called a "blower motor resister" has gone bad. The resister works by resisting/absorbing the power to the blower motor on the lower speeds, At high speed it lets all the power go through. The part is about $20.00 for a Jeep (common problem). Getting at it and knowing where it is I can't help. But with that knowledge, you should not get screwed by the repair shop.

Posted on Apr 29, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Colorado blower motor switch


Are you sure it's not the high speed blower relay lower right dash on heater box

Dec 31, 2013 | 2006 Chevrolet Colorado

1 Answer

05 chevy colorado blower motor only works on high


Check the blower motor resistor in the front of the passenger side floorboard

Dec 15, 2013 | 2005 Chevrolet Colorado

1 Answer

How to remove the blower motor on my 2004 Colorado


Go on the passengers side and remove the side kick panel.Then the blower motor is under the dash just remove the 3 screws that hold it in and disconnect the electrical and lower the blower motor.Reverse procedure for installation.Hope this helps.Good luck.

Dec 08, 2010 | 2004 Chevrolet Colorado

1 Answer

I have a chevy colorado truck and the air is cold when it works and it would only work if it was turned up on 4 1-3 didnt work and now it want come on in 4 what could my problem be


I have a 2004 Colorado since it was new. There was a recal for the blower motor problem. I think it was for a defective connector to the blower resistor assembly. There is also a recall for a bad brake light switch. I would take your truck to the dealer and get this recall work done.

Jun 28, 2010 | 2004 Chevrolet Colorado

1 Answer

Locate resistor switch 2004 chevy colorado


On my 2004, there was a recal for a defective harness. You might want to see if there was a recal for the 2005. The resistor is located on the passenger side below the and behind the dash mounted to the air duct.

May 04, 2010 | 2005 Chevrolet Colorado

1 Answer

2004 colorado blower motor only works on 4


the blower motor resistor and connector located under the pass. side of the dash need replaced the connector melts and burns the resistor an updated part is available from the dealer I have replaced many of them

Jan 07, 2010 | 2004 Chevrolet Colorado

1 Answer

Where's the hvac blower/resister located on 2005 Chevy colorado


Your blower motor resister is inside the cab under the dash on the passenger side below glove box area right around passenger foot area.

Nov 19, 2009 | 2005 Chevrolet Colorado

2 Answers

2004 Colorado cooling/heating fan will only run on high speed


sounds like the blower motor resistor is bad,thats what controls the speeds. replace that and your fan should work just fine, good luck.

Nov 13, 2009 | 2004 Chevrolet Colorado

1 Answer

On low speed there is a ticking in the fan as though something was rubbing. The noise goes away on higher speeds. How can I remove the heater motor to see if there is something rubbing. This is on a 2005...


It's on the pasenger side of the truck. Where the persons feet would be if sitting there. Lay down on your back and look up under the dash. There will be you blower motor. There are three gold or siver colored 5.5mm headed bolts holding it up to the heater case. Pull those out and the blower motor will drop down. Also you will need to remove the electrical connector before pulling the screws out. I will bet a peice of paper has been sucked out of you glove box and is in the blower motor. Be sure to note the position of the blower motor, it can only go in one way.

Oct 15, 2009 | 2004 Chevrolet Colorado

1 Answer

Blower on my 2004 Chev Colorado only works on high setting #4.


You need a resistor pack, which is likely located in the air box, near the blower motor.

Jun 29, 2009 | 2004 Chevrolet TrailBlazer

Not finding what you are looking for?
2004 Chevrolet Colorado Logo

Related Topics:

76 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...