Question about Mazda Cars & Trucks

Open Question

How to change map light mazda 2

Front passenger interior light bulb change on a Mazda 2, year of model 2010

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 5 Answers

SOURCE: Mazda 3 tail light on, brake light not on

The bulb actually has two seperate elements in it.
That is why the tail light works fine.

If you take the bulb out you will see the seperate elements.
Change the bulb and it should be fine.

Posted on Jan 10, 2009

Ad
CRTN
  • 716 Answers

SOURCE: changing the tail light bulbs on a 2000 mazda 626

The Tail Lights Are Accessed From The Inside Of The Trunk There Will Either Be A Panel Immediately Behind Where The Light Is Or Carpet. Remove It And It Will Give You Access To The Rear Of The Bolts Just Grab Twist And Pull And The Light Will Come Out.

Posted on Jan 26, 2009

  • 67 Answers

SOURCE: changing a wheel bearing, 2003 mazda 6

to change that, using a hydraulic press is highly recommended. if you are DIY experienced, this trick works as well:

take a pice of a stable metal pipe, 10-20 cm long. and in diameter just a tick smaller than gross bearing size. take a very heavy tool and use the pipe to beat out the old bearing. dont be shy, needs a lot of power.

do not use this method to insert the new bearing. use a pice of wood instead (must sit stable on the outer bearing ring!!), lubircate a bit and beat carfully and very straigt in fractions of a mm. this is the difficult part and here the bearing may brake if you are too rough.

Not really recommend, but working when used with brain and care.

Posted on May 29, 2009

  • 31 Answers

SOURCE: can't control passenger window in mazda 6

Passenger window lost programing. To reprogram, turn the key on, go to the passenger side and with the passemger switch run the window all the way down and hold switch in down position for 2 seconds, then run all the way up and hold in up position for 2 seconds, then repeat again within 5 seconds. Should work from drivers side master switch now.

Posted on Sep 17, 2009

philschneide
  • 448 Answers

SOURCE: Interior dome/map light replacement - 2008 Honda C-RV

You will have to pry off the lens CAREFULLY using a small screwdriver. There are two (or more) little plastic protrusions on each long side of the lens which fit into the casement. Look for very small slots along the side of the lens to insert the blade of the screwdriver. You can ease the casement away from the lens enough to get it to pop out. Re-inserting it is the same, but probably easier.
Gently, give it a try.
Hope this helps you.

Posted on Nov 21, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My mazda buzzes 2 times when I turn the headlights off and the instrumentation lights flash at the same time


Mazda 626 Electrical Issues - Car Forums at Edmunds.com

forums.edmunds.com > Mazda > Mazda 626

May 22, 2007 - 31 posts - ‎24 authors
clicking or buzzing sound coming from the "headlight relay" which is in ... off when you turn on the headlights then it clicks instead of buzzing in that fuse compartment and the headlight flickers about 5-10 times a second in time with the ..... I have a 1992 626 mazda, the battery died and replaced it two days ...

Thread: headlight issue and buzzing sound - Toronto Mazda 3

www.torontomazda3.ca > Forum > Technical Section > Electrical

Mar 3, 2009 - 25 posts - ‎10 authors
1. so in the fall my right headlight burned out, but then after nudging ... 2. sometimes when i turn off the car i hear buzzing coming from .... i turn off the car, was never able to open the hood in time before the sound disappears ... Buzzing sound behind centre console
11 posts
Sep 17, 2010
HID Problem: Bulb/Ballast Misfiring
25 posts
Aug 28, 2010
Buzzing relay after HID install with RELAY harness ...
15 posts
Mar 12, 2008
More results from www.torontomazda3.ca

Jan 07, 2016 | Mazda Cars & Trucks

1 Answer

I have a 2008 Mazda 5 minivan how do I change the headlight bulb


Headlight Change 2006-2010 Mazda 5 - CarCareKiosk

www.carcarekiosk.com/video/2009_Mazda_5_Sport_2.../headlight
This free video shows how to change a burnt out headlight on a 2009 Mazda 5 Sport 2.3L 4 Cyl.. Complete instructions for replacing a head light bulb on a 2009 ...

Low beam head light bulb replace 2000-2006 Mazda Mpv ...

? 5:11
https://www.youtube.com/watch?v=kblzMLRJrok
Jun 29, 2013 - Uploaded by hp11208
Low beam head light bulb replace 2000-2006 Mazda Mpv .... My step dad and I successfully replaced a headlight yesterday! :-) ...I've lost it trying to replace the bulb. if anyone can let me know I would really appriciate it thanks ! ..... 5:00. Cleaning your IAC to fix rough idle on 2000 or 2001 Mazda MPV ...

Nov 29, 2015 | Mazda Cars & Trucks

1 Answer

Replace outer front door handle Mazda cx7 2010 model


Hey, I just use a metal zipstrip. Cheap and easy. Look on youtube for Prizm handle replacement. You basically slip it under the current handle and slip it in the zip buckle to make a loop. It's ghetto but works and does not use duct tape unlike most Red Green type "solutons".

Feb 01, 2015 | 2010 Mazda CX-7

2 Answers

Front door adjar light on dash and overhead map lights is staying on on my 2003 Mazda tribute.


sounds like you door light switch is either broken or out of adjustment. unfortunatly it could be on any of the doors, including the back hatch.

check this link out, it may prove helpful
http://www.sparkys-answers.com/2010/01/2003-mazda-tribute-door-ajar-light.html

Sep 15, 2010 | Mazda Tribute Cars & Trucks

1 Answer

Changing side light passenger side front bulb on 2003 uk mazda 6


its inside the headlight unit ,take the cover off and just turn the holder and it will come out

Nov 22, 2009 | 2004 Mazda 6

1 Answer

Rear passenger turn signal won't work


make sure you have the correct replacement bulb for that car. Some bulbs do more than one thing.

May 19, 2009 | 1990 Mazda Protege

1 Answer

Mazda 3 tail light on, brake light not on


The bulb actually has two seperate elements in it.
That is why the tail light works fine.

If you take the bulb out you will see the seperate elements.
Change the bulb and it should be fine.

Jan 09, 2009 | 2004 Mazda 3

4 Answers

1990 Mazda Miata, Tail lights, Interior lights not working! :\


I have a problem with my tail lights in my mazda. Brake lights working great but the light that supposed to be working during night time are not. By the way the front lights are working too! Also the light of the panel inside is not working. Can anyone please tell me how to fix it?
Thanks alot in advance!

Sep 06, 2008 | 1990 Mazda MX-5

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

47 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8518 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...