Question about 2006 Nissan 1400 Bakkie

Open Question

My 1400nissan bakkie just cut-off while driving expecially when climing a slope

And it sometimes start after an hour and can another distance till it reach another up-hill road and cutt-off again please help

Posted by Anonymous on

Ad

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
Gort007
  • 1187 Answers

SOURCE: Where is the throttle body on a 96 maxima... and

The throttle body is where the carburetor used to be, in the middle top of the intake manifold where the air intake tube ends.
Use a major brand "Fuel throttle body cleaner" in your gas tank every 6 months or so. Don't use store brand. Ther eis also a spray for the linkage, etc. Use that too... and spray into the throttle body with engine running. Don't let the engine die while spraying into the throttle body.

Posted on Sep 30, 2009

Ad
  • 16 Answers

SOURCE: 1996 Nissan Pathfinders engine dies after driving

Does it happen when idling is gear? (I.e. at a red light, then when you try to accelerate it stalls?) Have you tried keeping your foot slightly on the gas pedal? If so, this could be a vacuum seal problem. Get a Vacuum Gauge, then use this site to help determine what the exact culprit is:

http://www.secondchancegarage.com/public/186.cfm

Posted on Jul 09, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My polo 1.4 se's fuel gauge has sat on 3 quarters for 3 days now, not normal with the amount of driving I do daily, what could be causing the problem? It changes a bit when on a slope though


Hi Josh:
I'd start by completely filling the fuel tank.
Since you know how far you usually can go on a full tank, when you have gone about alf that distance, the gauge should show about half a tank, and when you've gone just over 3/4 of that distance, the gauge should be starting to show on the low side.
At least, if you know that the gauge is not reading correctly, you won't run out of gas if you keep track of the distance and always fill the tank completely.
Hope this helps.

Apr 07, 2016 | Cars & Trucks

1 Answer

When my corsa lite bakkie 1998 model is is parked on a flat surface it starts but does not start slope or angle why?


with a full fuel tank or part ways empty ? reason i asked i had a older car that the end of fuel pick up rotted off(sat for a long time) and it only would run with a full tank , shut right off at 3/4 full

Feb 10, 2015 | Cars & Trucks

1 Answer

I drive a Nissan 1400 bakkie (not a champ) i drives good and then starts jerking and wants to die as soon i i give petrol it sounds like its smothering


hi, personally ..i love that bakkie. Ok you changed points condensor, petrol filter! please check.. When it cuts out 1. if the ignition coil is not hot, if so thats your problem.2. also on the carb... over the needle and seat there is a tiny filter... somtimes gets blocked. 3. also check when it stolls if the fuel pump is not hot or pull the outlet fuel from the pump
and crank the engine... note if fuel comes out sufficiently.

May 21, 2014 | 2006 Nissan 1400 Bakkie

1 Answer

Got bakkie started revs increase but cannot maintain revs and then cuts out


You could possibly have an air leak in your intake, hense the engine cutting out at low revs. Check your piping from the air filter to the intake manifold, and also your intake sensor.
Unplug the sensor and if it does the same thing then thats your problem.

Mar 19, 2014 | 2007 Nissan 1400 Bakkie

2 Answers

Opel corsa bakkie 2002 . motor cuts out without warning


check crank position / cam position sensor s / wiring
run the fault codes first

Apr 25, 2017 | Cars & Trucks

1 Answer

1400nissan bakkie tappet making noise after changed the oil


are you sure u are using the correct graded oil i think it is 20w40

Mar 15, 2013 | Nissan Pickup Cars & Trucks

1 Answer

Corsa Bakkie keeps cutting out when not applying gas.


Yo man, i have the same bakkie more or less same problem.Lights came on as i was driving on the highway and it just died...pre ecnition...Starts then dies again...bla bla bla.List goes on!
Start by replacing the Petrol pump relay!!!+- R400 i think.

Its next to your right foot ,next to gas pedal.Behind that cover.A small black box!

don't buy it from a dealer!
Good luck

Mar 19, 2009 | 1997 Oldsmobile Aurora

Not finding what you are looking for?
2006 Nissan 1400 Bakkie Logo

Related Topics:

186 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...