Question about 2003 Mitsubishi Eclipse Spyder GT

1 Answer

2003 mits eclipse automatic does not shift into gear. shifter works but no engagement, no reverse, drive

Trans had slight slip from 1st to second but when driving slipt. now there is no shift, cant feel any engagement. has a manual shift option and cant engage with it also. Cold weather...ohio.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 11 Answers

Check that the shifter cable is fully moving/engaging the linkage on trans other than that check fluid and check electronic plug connection

Posted on Jan 05, 2013

  • mark Jan 05, 2013

    i will do . didnt notice before but after towing back to garage I noticed in idle when shift to reverse or drive rpms increase still no go

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

New clutch was installed 2003 mitsubishi eclipse v6 it will go into all gears but is always in reverse too even when shifter is in neutral


sounds like your shifter linkage in the trans is out of its gates and in reverse, if you pull off the shifter cover make sure all shift rod in the trans are in the neutral position then reinstal shift cover

Oct 09, 2015 | Mitsubishi Cars & Trucks

1 Answer

I have a 91' ford f-150 that I pulled out of a parking lot and shifted from 1st to 2nd and instead of going into second it became stuck in fourth. then I proceeded to pulling the three screws out from...


if there has been no abuse or no chance somethind bent shifting rods under veh. check for loose or worn out shift rod connections,If internal trans shift drum problems your world just got more complacated

Aug 26, 2013 | Cars & Trucks

1 Answer

Speedometer quit and transmission will not work in 3rd or drive but will in 1st and 2nd


i have a 2003 chev s-10 pickup with automatic/ 4 cyl I am not able to move shifter from park to drive i believe my shifter cable is binding
gears selection matches fine when shifting. But will not get out park go to reverse or neutral selection only drive, 3rd, 2nd and 1st
do i need to replace shifting linkage cable?

Oct 01, 2012 | 1996 Chevrolet C1500

2 Answers

How do you adjust the shift cable on a 1995 gmc jimmy, wont go into reverse or park.


On the 1995 Jimmy, the shift cable can come loose on the mount on the side of the transmission where the cable meets the trans. When it slips, the alignment goes off and causes the driver to not be able to put the trans into park. If you take a long stick you can push the shift arm on the trans to the park position and your trans will go into park.....what you (and I) really need to know is how to take the shift cable mount apart and reset it.

Aug 05, 2012 | GMC Jimmy Cars & Trucks

1 Answer

I have a 2001 V8 Lincoln LS and have tranny problems. The reverse does not work and the transmission will not shift automatically. If I put it in any gear on the auto side, I can hear it engage but when I...


If you drive it a few days like that ,you will have a $3000 repair bill

instead of a $332.20 Solenoid Trans Pack, I put in my 2004

Any time you have, any trans issues,you stop driving it immediately
You never drive again, until diagnosed and repaired

I used to own a trans repair shop.

You will have to add labor to yours.

Dec 08, 2010 | 2001 Lincoln LS

1 Answer

88 toyota supra auto trans slips. won't up shift to 2nd gear


yep, sounds like your transmissions on its last leg, mabye you can get by, by starting in 2nd, if you have the option lol, but auto tran's are pretty cheap on ebay or try www.supraforums.com seen one for 300$

Apr 02, 2009 | 1988 Toyota Supra

2 Answers

98 Civic Auto Trans Slippage


you need to replace clutch pack for that gear can be ordered seperately from parts store or dealer if you want to save money call peach street auto recycling at 1800-365-2341 for a warrantied used one! also might be time for change trans filter and fluid filter could be slightly clogged but I lean towards clutch pack I replace these alot on Hondas

Dec 12, 2008 | 1998 Honda Civic

Not finding what you are looking for?
2003 Mitsubishi Eclipse Spyder GT Logo

117 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

80608 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...