Question about 2003 Kia Sedona

1 Answer


Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Kia Master
  • 14,417 Answers

Trouble Code: P0510

Closed Throttle Position Switch Circuit Malfunction

Trouble Code Conditions: Engine running and the PCM detected the Closed Throttle Position switch status did not change from "off" to "on" during normal driving.

Possible Causes:

Closed throttle switch signal circuit open or shorted to groundClosed throttle switch signal circuit shorted to VREF or powerClosed throttle switch is damaged or has failedPCM has failed

Posted on Jan 05, 2013


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2009 toyota corolla, check engine light flashing and engine sputtering. When driving it will randomly go up to 3000 rpms and then bog down. Why.

You need to pull the fault codes with a code reader, you have a misfire in the engine, the fault code will indicate which one, then you do the needed diagnostics to pin down the cause of the misfire.

Sep 29, 2016 | 2009 Toyota Corolla

3 Answers

When i drive the car the check eng light comes on then in a bit it will go out I check for code's but there's no code's?

You can only check the code whilst the light is on. Leave the code reader plugged in. When the light comes on, pull over if safe to do so and read the code reader.

I had a similar thing on my Lexus. It was a thermostat sensor that was telling the engine stayed hotter than it should for a while until the thermostat opened.

Dec 17, 2015 | Cars & Trucks

1 Answer

Montro sport Engine light turns on while driving. what should i do?

check the computer by using a code reader to pull the code to tell you the area thats at fault.

Nov 04, 2013 | 2000 Mitsubishi Montero Sport

1 Answer

My 2008 Hyundai Sonata has a check engine light that stays on and ESC off. This happened as I was driving on the interstate at 60 mph and it idled all the way down. Hyundai dealership told me it was a...

When a 'check engine light' (MIL=Malfunction Indicator Lamp) is turned on, there is a DTC (Diagnostic Trouble Code) set/stored in the ECM/PCM (Engine Control Module/Powertrain Control Module). This code identifies which engine management system component/function experienced a malfunction. Once you pull/read this code, you may begin diagnosis.

Aug 28, 2011 | 2008 Hyundai Sonata

1 Answer

Was driving and the light with the engine came on

That's your check engine light. means that your car computer pick up a bad signal from one of your engine sensor's, go to any auto parts or autozone where they can pull code's from your car for free, then get back us so we can help you with your trouble code.

Jul 02, 2010 | 2000 Dodge Durango

1 Answer


Code PO510 commonly refers to a defective Throttle Position Sensor (TPS). But before you go replacing it check all the wiring. Make sure everything is tight and connected. Check for a wire touching metal and shorting out. Check the ground wire and see if it shares a ground with the coolant sensor or another sensor. That other sensor may be the problem and not the TPS, if it is defective and not providing a good ground

Aug 04, 2009 | Mitsubishi Mirage Cars & Trucks

1 Answer

My check engine light is on, and mt car shuts off

if you can get some one that has a scan tool and can pull the code from the ECM than i may be able to help you bet the engine light can be on for many, many reasons...

Aug 01, 2009 | Pontiac Grand Prix Cars & Trucks

1 Answer

Engine malfunction light came on

As with any check engine light, the only way to find out what the issue is is to have the code read. The dealership can pull the code and let you know what the issue is.
Before considering driving the vehicle to the dealer though, check the obvious: oil level, coolant level, transmission oil level.
If your uneasy, have it towed.

Mar 03, 2009 | 2004 Land Rover FreeLander

1 Answer

2006 Audi A4 - I have an ECU code P0299 -002 lower limit exceeded

You have to pull the code to know what's wrong, do you have any drive ability problems?how different is the car driving after the light come on?

Dec 22, 2008 | 2005 Audi A3

1 Answer

Transmission slipping

What you need is a "revolution sensor" I had the same exact problem. Replaced the sensor and everything is fine

Jun 26, 2008 | 2000 Nissan Maxima

Not finding what you are looking for?
2003 Kia Sedona Logo

Related Topics:

443 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

80608 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides