Question about 2008 Chevrolet Uplander

Open Question

Checking the coolant level in my 2008 chevy uplander

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: Have 44k on a 2008 chevy uplander. Front left

I have a 2008 as well.. with 39K and the front right needed replaced.
it was covered under the 100K warranty

Posted on May 04, 2010

Ad
  • 12650 Answers

SOURCE: have to replace a chevy uplander 2008 left rear

open rear hatch and will see the access screws un screw careful not to drop and pull away like opening a door and assembly is free from van

Posted on Jun 10, 2010

  • 196 Answers

SOURCE: I have a 2008 Chevy Uplander. The rubber moulding

Any non acetone based glue would work. Also make sure it's not water soluble (Elmers or other art glue). Most auto parts stores carry weather strip glue for about $5.

Posted on Jun 11, 2010

Testimonial: "Great! Thank you."

hepcars
  • 1249 Answers

SOURCE: what kind of tires do I need for a 2008 chevy

Tires have many variables that affect drivability and safety...Depending on how you use your Uplander...like most things...you get what you pay for...It is usually best to stay with original tire size...ie...225/60/R16..(This confirms speedometer accuracy and tire wheelwell clearances). Comparison by mileage warranty will help assure good quality. All season tread pattern is best overall...For best ride quality the Michelin Harmony is hard to beat. Yokohama tires have proven to be great performers, but do not ride as soft as the Michelin...Goodyear design and quality is not the leader as they used to be in the 1980's...still OK but harsh ride and poor performance in slippery weather...Bridgestone is good also, but not as good as the Michelin or Yokohama...You will be pleasantly surprised with either the Michelin or Yokohama...Tire sidewalls are required to show the USDT rating for temperature and treadwear comparison...Last but just as important is tire air pressure...35 lbs psi is best for everyday driving, handling, and tread wear...Hope this helps.

Posted on Feb 01, 2011

  • 1608 Answers

SOURCE: my 2008 chevy uplander engine

You will need to get the codes checked.This will help in finding out what is causing the light to come on.Once you get the code or codes we can find out what could be causing the problem.Let me know when you get the codes and I`ll be glad to help you out.Good luck.

Posted on Mar 01, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Bleeding the coolant system 2005 chevy uplander


Bleeding the coolant system Leisa, Check the attached links,instruction and guides on bleeding cooling systems. Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
How To Fill Bleed Coolant Chevy 3 4L V6
Bleeding Air In Cooling System
Coolant Flush How to Chevrolet Uplander 2005 2008 2008 Chevrolet Uplander...
How To Bleed Cooling System EricTheCarGuy


May 21, 2016 | Cars & Trucks

3 Answers

How do I change the oil on my 2007 Chevy uplander?


crawl under it and remove the drain plug .when drained put plug back in , change filter and add new oil

Aug 11, 2015 | Cars & Trucks

2 Answers

I have a 2005 Chevy Uplander and its reading engine coolant hot


Is it actually overheating?
If not, could be a coolant temp sensor, which controls your gauge

Feb 13, 2015 | 2005 Chevrolet Uplander

1 Answer

Where is the rear heater motor located on 2008 uplander


If the van has E59 on the RPO sticker you have to remove the left rear lower trim panel to access the motor. If it does not have E59 just remove the left rear compartment lid and compartment to access the motor. RPO E59 is a power left sliding door.

Sep 24, 2014 | 2008 Chevrolet Uplander

1 Answer

My 2008 Chevy uplander engine light on and the code shows for cam shaft sensor and intake manifold what I do


The intake code means its leaking from the intake,bad gaskets, or a vacuum leak. check for bad gaskets on intake manifold. You can tell by putting a bit of oil around the maifold. if it is leaking the engine will flair up. To check this, External leak-- Coolant seeps through the broken intake manifold gasket to the outside of the engine. If its bad enough you will see coolant dripping from gasket. Coolant seeps through the damaged gasket to the inside of the engine, mixing with motor oil. If you suspect an internal leak, check your oil dipstick. Or if you have a substance under oil filler cap that looks like a milkshake, Oil is mixing with coolant. this means intake gaskets are bad, Now for the camshaft sensor, If you have a manifold leak. this could be giving you a false camshaft reading! Because, If sensor is bad vehicle will not start unless theres a wire problem. Symtoms of a bad sensor are--- engine sputtering, poor acceleration, stalling/inability to start. HopeI helped you out! Good-Day!

Jul 26, 2014 | 2008 Chevrolet Uplander

3 Answers

2008 Chevy Uplander has 21,000 miles. Nno heat from rear heater at idle. Disconnected hoses and flushed, water flowed good. Reconnected hoses and still no heat. Raised idle to 2000 rpm and got good heat....


Uplanders with the 3.9 engine are prone to no heat at idle speeds. Probably weeping head gasket. Air bubble trapped. Dealers will remove rad cap and let it sit at about 25 deg. angle for a couple hours. Good for awhile.

Nov 15, 2010 | 2008 Chevrolet Uplander

2 Answers

I have a 2008 Chevy Uplander. The rubber moulding


IN most commercial auto storesd they sell a molding spray glue that is OK at best but most body shops have the GOOD STUFF GOOP for rubber molding this is good stuff ask for a little for personal use they may give you the end of a tube of GOOP

Jun 11, 2010 | 2008 Chevrolet Uplander

2 Answers

Have 44k on a 2008 chevy uplander. Front left


I have a 2008 as well.. with 39K and the front right needed replaced.
it was covered under the 100K warranty

Mar 19, 2010 | 2008 Chevrolet Uplander

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

67 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...