Question about 2002 Toyota Camry

1 Answer

How do i replace the positive battery cable for 2002 camry

Cable to short to replace just the terminal

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Toyota Master
  • 14,384 Answers

You can take your cable to Autozone and show them your cable and they will get you a new one with end on it that goes on battery post.

Posted on Jan 05, 2013

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 120 Answers

SOURCE: changed positive cable terminal, now battery dead, fuse box ticks

hazard lights left on ? check to see waht relay it is that is clicking anr read to see what it is for? hope this helps

Posted on Aug 25, 2009

flbergeron68
  • 541 Answers

SOURCE: 2002 camry won't start. everything works except

recharge battery, it must be dead

Posted on Jul 04, 2010

  • 514 Answers

SOURCE: 2002 TOYOTA CAMRY V6. Changed the battery,

did you check all your fuses, if gas pedal- throtlle is controlled by cables tipycal, or is controlled by a sensor you want to check that. also check all your wires one of them maybe is burned or your pcm the THE COMPUTER. good luck.

Posted on Sep 17, 2010

rickyrt441
  • 4399 Answers

SOURCE: 1994 Toyota Camry LE Sedan

Thanks for choosing FixYa and welcome to the site. This could be either a fuel issue or an ignition issue. Have you tested the fuel pressure yet? If you don't care, can you tell me everything you have checked so far. Also, how often is the stalling/quitting?

Posted on Aug 16, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to replace old battery with new in a 2002 oldsmobile silhouette


Take note of any radio codes. If you don't know them, get a small or another 12v battery, a set of small jumper leads, connect the leads clips to the matching cables on the car at the battery. You are now supplying a small current in parallel. Using a buddy to hold the battery terminals away from the bodywork remove the negative first, then the positive. Remove battery and replace with new battery. Reattach positive terminal first then negative, then remove small jumper cables and it should have preserved your codes etc.

Nov 17, 2016 | 2002 Oldsmobile Silhouette

1 Answer

Door Open light blinks rapidly making a clicking noise when trying to start the car and will not turn over. No lights except for the one flashing very quickly.


Sounds like you have either a dead battery or a bad connection on the positive/negative terminals or the starter motor or the ground to body connection? It is also possible for the cable to have corrosion built up inside the insulation causing a resistance? Clean your battery terminals first then if a charger is unavailable using booster cables connect the positive cable to the dead battery then the positive cable to the jumper battery then connect the negative cable to dead battery and positive cable to jumper battery and attempt to start the car if same conditions then the xonnections may either be loose or corrosion hampering voltage to be supplied efficiently! A digital voltmeter will or should show a 12-volt reading on the battery if less than 12-volts the battery needs to be charged or replaced?

Jan 16, 2015 | 2002 Toyota Camry

2 Answers

Postive battery cable very hot


Turn off and check positive cable for wear, if the cables outer covering is damaged, it can short to the chassis or other metal parts of the car.. and cause the cable to heat up. Leave it in that sate long enough and it will eventually melt. or in extreme cases cause a fire. If you find any damage, then replace said cable immediately

Jun 24, 2014 | 2002 Audi A6

2 Answers

Replaced battery car will start but no power


try to disconnect the battery for about 20 minutes. hook it back up and make sure you have the positive and negative wires on the right terminal. wrong way can short and burn your entire electrical harness. Check the fuses.

Apr 21, 2014 | 2002 Toyota Camry Solara

1 Answer

Battery light on, charge system ok, batterry ok, belt ok why the battery light stay on..?


Go to Autozone and have them test your battery and alternator,make sure cable from positive battery cable to starter is tight and negative cable is tight at other end and battery terminals are clean and tight.could be a dead cell or alternator is over charging..

Jun 27, 2013 | 2002 Toyota Camry

1 Answer

95 4cyl camry intermittant spark loss thus engine dies and fails to crank for short period, sometimes can be coaxed to crank again after removing negative battery terminal for several minutes and...


Test the crankshatt position sensor. If it tests good, please get back to us.

OPERATION The Crankshaft Position (CKP) sensor provides a signal through the ignition module which the ECM uses as a reference to calculate rpm and crankshaft position.

TESTING The crankshaft sensor should be tested either cold 14-122°F (-10-50°C) or hot at 122-212°F (50-100°C).
  1. Using an ohmmeter, measure the resistance between terminals. Resistance cold should read 1630-2740 ohms and hot; 2060-3225 ohms.
  2. If resistance is not within specification, the sensor may be faulty.
REMOVAL & INSTALLATION See Figure 1

Fig. Fig. 1: The crankshaft position sensor is located to the right of the water pump-1MZ-FE engine
  1. Disconnect the negative battery cable.
  2. Remove the right hand engine under cover.
  3. Remove the right side fender apron seal.
  4. Remove the sensor wiring retaining nuts.
  5. Remove the bolt and disconnect the crankshaft position sensor wiring, then withdraw the sensor.
To install:
  1. Install the sensor and secure with the bolt to 69 inch lbs. (8 Nm).
  2. Attach the engine wiring.
  3. Install the right hand fender apron seal.
  4. Install the right hand engine under cover.
  5. Connect the negative battery cable.
  6. Reset any electrical components such as the radio or clock.

0900c152801ccc4a-cuc0wv5q552isopkhsunrpmi-3-0.gif

Jul 02, 2017 | 1995 Toyota Camry

1 Answer

2002 TOYOTA CAMRY V6. Changed the battery, replaced neg end of battery cable, reversed post on battery shorted 190 amp fuse, replaced that and the air filter. Car starts fine, idle fines, but will not...


did you check all your fuses, if gas pedal- throtlle is controlled by cables tipycal, or is controlled by a sensor you want to check that. also check all your wires one of them maybe is burned or your pcm the THE COMPUTER. good luck.

Sep 17, 2010 | 2002 Toyota Camry

1 Answer

While putting in a new battery in a toyota camry the instrament gauges, radio,and all back lights stoped working... replaced all fuses and still wont work


Ok, first (I know it sounds stupid) were the battery terminals put on correctly? positive to positive.. If so, then check your fuses BOth under the hood and inside the car. Check to see if any other devices are supposed to be connected to the positive lead of the battery or any loose non connected electrical wires by your battery. You might have a relay that went out or a short between your battery (and/or battery cable) and your "firewall".

Sep 26, 2009 | 1999 Toyota Camry

Not finding what you are looking for?
2002 Toyota Camry Logo

156 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8557 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...