Question about 1984 Dodge Ram Wagon

Open Question

Missing vacuum lines in 1984 Dodge Ram 100 318 V8

On the passenger side fender wall is a ''selnoid'' for the vacuum lines that go to the smog condenser. I am looking for a diagram so I can check to see if all the lines are accounted for. It looks like some are missing :(

Posted by on

  • Pudge1999 Mar 12, 2009

    the problem i am having is there is a vacuum leak but i cant find it so therefore i need a vacuum line diagram for a 1984 dodge d150 with a 318 v-8 and a 2bbl carb

  • 33365 Apr 09, 2009

    i have the same problem but mines a 1984 dodge ram d100 with a 360ci

×

2 Suggested Answers

  • 5 Answers

SOURCE: I need a vacuum harness for my heater in 1984

go to a nearby salvage yard.

Posted on Feb 27, 2010


  • 1565 Answers

SOURCE: Looking for a vacuum line

go to autozone.com. become a member. and look up the vacuum diagram for your particular yr, engine, trans, ca or 49 state.

Posted on Mar 15, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Vacumn lines diagram


360 cu in (5.9 L) LA V8
or the 5.9 Cummins.? is really 5.88L
here is that generation line up.
3.9 L Magnum V6
5.2 L Magnum V8
5.9 L Magnum V8
5.9 L Cummins Turbo-diesel I6
8.0 L Magnum V10 so 5.9 dont help me...see?
what is the question the above is a statement of fact.
do tell?
did you leave out , what is it? or ????
are you just curious?
if in the USA> are you? open hood, look up.see EPA vacuum map?
bingo ? (ours does !)
if no bingo, it's in the FSM for your country (only) book, dealer sells book..
and at alldata.com
did it fall off?
vacuum maps very by
country (smog laws) and engine.
and by options.

Jul 06, 2014 | 1998 Dodge Ram 1500 4WD

1 Answer

What is the location of cylinder number 8 in 2010 dodge ram v8


1-8-4-3-6-5-7-2 Clockwise rotation....
.pass side 2-4-6-8
driver side 1-3-5-7
So #8 would be passenger side rear plug closest to the fire wall..

Dec 30, 2013 | 1998 Dodge Ram 1500 4WD

1 Answer

4wd will not engage,rpm gauge surges while driving at highway speeds, and air conditioner shuts off when pulling hills.


The the vacuum port on the passenger side of the intake, take a good look this is over looked often and this line is the most common to come off or break.
This truck does not have many lines , also follow lines from intake manifold to fire wall and see if there are any broken lines,

Oct 30, 2012 | 1998 Dodge Ram 1500 4WD

2 Answers

I need a vacuum line diagram for a 1984 cadllac coupe deville


zjlimited_803.gif

Fig. 31: Vacuum circuits - 1984 V8 4.1L engine Fed. and High Alt. (DFI)


zjlimited_804.gif

Fig. 33: Vacuum circuits - 1984 V8 4.1L engine Calif. (DFI)

Hope helps. Just keep in mind that your feedback is important and I'll appreciate your time and consideration if you leave some testimonial comment. Have a nice weekend and thanks for using FixYa.

Jose.

Oct 18, 2011 | 1984 Cadillac DeVille

1 Answer

Vacuum line looks chewed in half and can not tell where it needs to go. It is at the t above the check valve on passenger side......ac only blows thru default defrost and floor


It sounds like vacuum is not getting to the vent, heat and A/C controls. Find the vacuum can. It may be under the hood on one of the inner fenders. The "one-way" check valve is usually located in the line and close to the can, make sure it works properly. The valve could be the very thing that's causing the problem. Trace the lines back to the vacuum block at the intake manifold or fire-wall, and also back to where the line goes thru the fire-wall. Check the can for leaks or obvious holes. They used to be just a plain metal can, but it could be a plastic ball. Check the lines as you go, for breaks and rub-thru's. Move the controls thru all settings and listen for vent door movement. Worst case is a bad vacuum motor or air flow position selector switch, and/or a faulty Blend Door Actuator. If you have been driving around with the Temperature knob or control set at the same spot for months, move it from fully cold to fully hot several times and wait for the air temperature to change each time. This will help reset the blend door and vacuum control system. Hope this helps... Let me know what you find.

Aug 30, 2011 | 2001 Dodge Ram 1500 Truck 2WD

1 Answer

1999 dodge ram cylinder numeration


If you have a v8 1,3,5,7 on drivers side front to back 2,4,6,8 passenger side front to back v6 same just don't have 7&8

Apr 02, 2010 | 1999 Dodge Ram

1 Answer

WHERE IS THE iat SENSOR ON A 2008 DODGE RAM 1500,4.7L V8


on the intake manifold passenger side near the front i think

Jan 23, 2010 | 2008 Dodge Ram 1500 2WD

1 Answer

1984 nissan pickup fuel pump relay location


If it's like mine, the relay is located on the passenger side fender wall. You should see a set of 5 relays together. It is the first one in the back.

Nov 29, 2009 | 1984 Nissan Pickup

2 Answers

Wheres the fuel filter located at,on a 1988 dodge D250 ram truck 360 V8 auto trans.


follow the fuel line up from the gas tank and you will find a round canister this is the filter also it is usually located on the driver side under that area

Nov 13, 2009 | 1988 Dodge Ram Wagon

1 Answer

Shift motor vacuum line on dodge 1999 ram 2500


they have two lines from the axle they run along the front of the crossmember above the skid plate to the top of the transfer case on the drivers side

Apr 08, 2009 | 1999 Dodge Ram

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

355 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

70374 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6878 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...