Question about Cars & Trucks

1 Answer

My humidifer says that the water level is low and will not turn on, but the tank is full

The machine is 2 years old, has always worked great until I needed to use this season

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Cars & Trucks Master
  • 21,873 Answers

This is the car and truck section, but I would say the float sensor has failed.

Posted on Jan 05, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

emissionwiz
  • 75822 Answers

SOURCE: Fuel level sensor in tank bad????

Yes it is all one unit, and yes that is what the problem is. don't use aftermarket parts, use OEM, (Delco Remy) they are much better quality.

Posted on Sep 08, 2008

  • 651 Answers

SOURCE: 1999 mitsubishi montero overheating

sunds like it needs a new thermostat. good luck

Posted on Nov 29, 2008

  • 85 Answers

SOURCE: coolant in coolant reservoir did not fill low level in radiator

you must drain air out of system
so when engine is warmed up, just unscrew slightly the thermo time switch which is the highest sensor and unit in cooling system besides the reservoir, until alittle air releases then when antifreeze starts coming out then retighten to specs. BE VERY CAREFUL !!!! LOOSEN VERY SLOWLY AND NOT COMPLETELY REMOVE FOR THIS CAN CAUSE BURNS. MIGHT WANT TO USE A RAG AROUND SENSOR. If this doesnt solve it then make sure you have the correct rad. cap. Also that the filling hose is not clogged as well as the little port on radiator.

Posted on Feb 19, 2009

Molson02536
  • 3854 Answers

SOURCE: Low oil pressure light goes on until car warms up. Oil level is good

The oil pressure sending unit has gone bad. I sending unit is just above the oil filter and you can get to it from the top. When you face the Engine look down towards the oil filter, the oil pressure sending unit is just above that and it looks like a cylinder with two wires coming from it. If you don't see it, it's right between the exhaust manifold and oil filter.
If you go to Auto Zone or Parts Source, they'll have the oil pressure sending unit and the step by step instructions, When installing the new sensor. Do not use teflon tape or any sealant, the sensor is tapered and need's the good ground from the engine to give you right readings.
Good luck and hope this helps.

Posted on May 11, 2009

saabreur
  • 51 Answers

SOURCE: 1989 Saab 900 low level fuel light

You don;t say whether the fuel gauge is reading accurately, or whether it's always on empty. If the gauge is always showing empty, it's most likely a problem with the sending unit in the fuel tank. Check the resistance across the two terminals of the sending unit.

On a C900, the fuel sender level unit is separate from the fuel pump and located on the right side top of the tank, accessible by removing the trunk floor lift up panel (the pump is located on the left side top of the tank.
Possible problems are: electrical line off or broken, float not working (it's fairly delicate); or gauge not working.

Test the resistance of the sending unit with the lines disconnected, the resistance should be 2.6 to 3.8 ohms full tank, 63.3 to 67.5 ohms empty tank; and test for voltage across the top of the sender unit, if no voltage, that's likely the problem!

If the gauge is otherwise reading accurately (showing 'full' for a full tank, etc) then the problem is likely a gauge malfunction and can be simply replaced.

Good luck!

Saabreur

Posted on Aug 09, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

4 Answers

Why do heat and defrost only work when I'm moving?


it sounds like it may be low on antifreeze. sometimes when there isn't enough antifreeze in the radiator it wont put out much heat until you rev up the engine. at idle the water pump cant move the anti freeze but at a higher rpm. it can. but there is a chance you may burn up the water pump by not having enough antifreeze. check it and fill to proper level and see if this cures it.

Jan 19, 2016 | 2005 Jeep Liberty

1 Answer

Why do i have a problem with my ford transit vans diesel motor


well Simon lets see what we can do here I understand the frustration and you must understand your truck is not in front of me but I will try my best O.K. now first of all I think this is either fuel or emissions related and lets start here there is a extreme possibility that you might have water or dirt in your diesel fuel inside the tank and it will float until the level gets low then you are more at risk of it getting pulled through the fuel pump don't misunderstand me this can always happen when the tank is full from the fuel sloshing around while driving but it will happen much more when the level is low what I would like you to do is add a couple of dry gas and a couple of fuel conditioner additives to your tank these are combustible and will mix with the diesel so don't worry and if there is water it will dry it up & also mix with it to get it out of the tank run the tank down as close to empty as you can get if you have a can with 5 gallons go all the way till it runs out of fuel then immediately change the filter and put the same stuff in again then the diesel fuel and then fill the old girl up again to the top I'm trying to get the water or dirt that could be in your tank out without dropping the tank and being extremely costly you should only have to do this 2 times and it should clean the old girl out but it will get less frequent with the sputtering and stalling and if you see this result keep doing it as many times as it takes to get the tank purged of what is in there but if you don't start to see results we must now turn to the emissions system you also must know when the truck had a tune up how long ago post back with any news on the progress good luck

Aug 27, 2014 | Ford Transit Cars & Trucks

2 Answers

2004 jetta overheats real quick no collant leaking eng fan seems to come on too late


SOUND LIKE ENGINE COOLANT LEVEL LOW.CHECK COOLANT SURGE TANK.IF LOW MORE LIKELY RADIATOR COOLANT LEVEL LOW.ADD COOLANT TO COOLANT SURGE TANK UNTIL COOLANT LEVEL STAY AT FULL COLD MARK DONT OVERFILL OVERFLOW JUG.

Aug 24, 2011 | Volkswagen Jetta Cars & Trucks

2 Answers

My temp gauge goes to the third line before fans come on and only the low fan comes on. I already replaced thermostat, engine coolant temp. sensor and radiator flush... any idea why high fans dont come on...


CHECK COOLANT FAN FUSES AND RELAYS. CHECK COOLANT LEVEL.MAKE SURE ITS NOT TOO LOW BECAUSE IF COOLANT TOO LOW . BY NO COOLANT AROUND OR COOLANT SENSOR NOT SUBMERGED IN COOLANT COOLING FANS WONT TURN ON.MAKE SURE YOU HAVE 50/50 ANTIFREEZE AND WATER. CHECK FOR CLAPSE RADIATOR HOSES.CHECK RADIATOR HOSE AT WATER PUMP.IF HOSE LOOK CLAPSE REPLACE IT AND BLEED COOLANT SYSTEM.IF EVERY THING HAS BEEN DONE YOU NEED ENGINE BLOCK FLUSHED OUT.HEATER CORE ALSO COULD BE STOPPED UP.A VERY HIGH MILEAGE ENGINE WILL OVER HEAT.OLD ENGINE LOSES COMPRESSION AND HORSE POWER.PUTTING MORE LOAD ON THE OLD ENGINE WILL MAKE IT OVER HEAT.IF COOLANT LEVEL IS LOW.BLEED COOLANT SYSTEM.START THE ENGINE LET IT IDLE FEW MINUTES WATCH THE COOLANT TEMPERATURE GAUGE.WHEN TEMPERATURE START RISING.TURN OFF THE ENGINE LET IT SET FOR 20 MINUTES.TAKE A LARGE RAG PLACE OVER RADIATOR CAP ON COOLANT EXPANSION TANK SLOWLY OPEN RADIATOR CAP JUST A LITTLE TO RELEASE A LITTLE PRESSURE AT A TIME.DONT OPEN CAP RAPIDLY OR YOU WILL GET SCALDED.ONCE THE RADIATOR CAP REMOVED.IF COOLANT LOW ADD MORE COOLANT IN THE THE COOLANT EXPANSION UNTIL YOU GET TO THE COLD MARK.REPEAT THIS PROCEDURE START ENGINE LET IT RUN UNTIL TEMP GAUGE START CLIMBING A BIT DONT LET CAR RUN TO OVER HEAT JUST IDLE UNTIL TEMP JUST START TO RISE.THEN YOU TURN OFF ENGINE. WAIT 20 MINUTES.THEN USE LARGE RAG OPEN RADIATOR CAP LITTLE AT A TIME. DO THIS PROCEDURE UNTIL THE COOLANT IN THE EXPANSION TANK STOP DROPPING. THEN ALL THE AIR IS BLEED OUT THE COOLANT.WHEN COOLANT LEVEL STOP DROPPING, WHEN YOU DRIVE CAR AROUND.AND TURN OFF ENGINE.WHEN ENGINE OFF CAR SET FOR A WHILE KEEP CHECK ON THE COOLANT LEVEL IN COOLANT EXPANSION TANK. THE COOLANT LEVEL SHOULD BE AT THE COLD MARK IN THE EXPANSION TANK.MAKE SURE COOLANT IS IN THE EXPANSION TANK.IF NOT AIR WILL DRAW IN COOLANT SYSTEM. CAUSING ENGINE TO OVER HEAT.IF BLEEDING AIR OUT THE COOLANT SYSTEM DONT HELP AND COOLANT FANS DONT TURN ON YOU HAVE PCM PROBLEMS.

Apr 22, 2011 | 2004 Pontiac Grand Prix

1 Answer

Over heating


Try checking your antifreeze levels. If you antifreeze tank is low try filling it to the "Fill" or "Full" level. If your antifreeze tank is empty, remove your radiator cap, (make sure the engine has cooled off. If you try to open it while it's hot, you could get sprayed with hot antifreeze) and fill the radiator slowly. Then refill your antifreeze tank. Remember to always mix the antifreeze with water (50/50 mix) for full protection.

Mar 05, 2011 | 1998 Pontiac Bonneville

3 Answers

Screen on dash says "coolent low".


Sounds like a bad thermostat. A malfunctioning thermostat will back up coolant into the overflow. BTW, are you experiencing any problems with the heat or AC? This would also be an indicator that the thermostat is faulty.

Apr 23, 2009 | Chevrolet Venture Cars & Trucks

3 Answers

2001 Chrysler Sebring


try replacing the thermostat

Nov 08, 2008 | 2001 Chrysler Sebring

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...