Question about 2003 Mazda Tribute

Open Question

Starter removal from 2003 mazda tribute - 2003 Mazda Tribute

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
TeeShane
  • 21 Answers

SOURCE: spark plugs

You have to remove the intake (and the manifold) just to get to them. They are on the engine like every other car but access is trying because you can't even see them until you start removing the above items. If you still aren't sure where all of this is, follow the plug wires from the coil pack to the plugs. If it does not have wires, it will have individual coils on top of each plug. Unbolt each coil and pull it up. The plug is under it. On your V6, they should be located on the side.
This is very tricky on this vehicle. It is, of course, recommended to take it to a shop. Some special tools may be required.

Posted on Apr 30, 2009

Ad
  • 104 Answers

SOURCE: How do I remove the radio from a 2003 Mazda tribute?

Definitely an easier way. Not familiar with your exact model but usually there are two side strips that are removable to reveal a couple of holes on each side. At the bottom of these holes are retaining clips that need to be disengaged to remove the unit. You can buy a removal tool that is a pair U shaped wires to poke in the holes and press outwards to release the clips. You can also make one out of coat hanger wire. It is a good idea to coat the face of the radio with tape to avoid any scratches. If your radio doesn't come out exactly like this the principle will be similar.

Posted on Sep 20, 2009

ftw1952
  • 10319 Answers

SOURCE: How to remove rear wiper arm on 2003 Mazda

lift the arm outward and a tab will show at the base of the arm. Pull it outward (the tab) and simply pull the arm away from the mounting stud

Posted on Jan 16, 2010

  • 275 Answers

SOURCE: 2003 Mazda Tribute will start, idle rough for a

check the fuel filter air filter and vacuume lines if they all good make sure the spark plugs are making a bright blue spark

Posted on Jan 20, 2010

  • 1757 Answers

SOURCE: I need a serpentine belt diagram for a 2003 mazda

My sincere apologies for the delayed response.
I am personally going back to answer your unanswered questions.

I do not know if you still need this information, but I am going ahead and answering it anyway. You may want to Print the Diagrams for future use.

CLICK
on the following LINK. It has the Belt Diagrams you will need.
If you would: Before Clicking: Let me know if this helped you, or if you have any additional information or questions. Feel Free to contact me at FixYa.com!
Again my apologies...
http://www.2carpros.com/car_repair_information/year/2003/make/mazda/model/tribute/2003_mazda_tribute_drive_belt_routing_diagram.htm

Posted on Mar 06, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I disconnect a starter to replace it on a 2005 Mazda Tribute 2.3l


Disconnect the battery ,,Remove the large cable running to the starter,then the small one,remove the bolts holding it to the bell housing,and then remove the starter.

Nov 12, 2016 | 2005 Mazda Tribute

2 Answers

My fuel emission light is showing on my mazda tribute 2003. Iam just about to trade it in and am wondering if there is cheap way to get it off before i trade it in


Search Results

    Failure of EGR Differential Pressure Sensor : Mazda Tribute ...

    repairpal.com > Problems > Mazda > Tribute
    Check Engine Light and Hesitation or Stumbling While Driving on Mazda Tribute ...this is my second egr valve and car is not picking up the right sped and when ... Mazda Tribute 2003, replacing burnt DPFE, connector bunrt, Need color pinout. ... Drivetrain · Electrical & Lights · Engine · Exhaust & Emissions · Heating & AC ...

    Check Engine Light Diagnosis Cost for Mazda Tribute ...

    repairpal.com > Estimator > Mazda > Tribute
    A Check Engine Light is turned on when the Mazda Tribute engine control module detects a fault in the emissions system. One or more diagnostic codes will be

Feb 05, 2016 | 2003 Mazda Tribute

1 Answer

How come my 2003 mazda tribute fuel injectors not getting any power


Damaged PCM Wires May Cause Engine Misfires : Mazda ...

repairpal.com > Problems > Mazda > Tribute
Check Engine Light Due to Engine Misfire on Mazda Tribute. If the engine is misfiring, it may be caused by a damaged wire(s) which connect the fuel injectors to the Powertrain Control Module (PCM). ... With only 69000 miles and no other problems I hate to replace the vehicle ... 2003 Mazda Tribute- 3.0L V6150,285Visitor.
Fuses OK??

Sep 22, 2015 | Mazda Cars & Trucks

1 Answer

Mazda tribute won't start


Well the battery could be dead or the starter is bad or your ignition is shot or it can be a wiring problem call the dealer ship from the car manufacturing department or parts department to see what they suggest

Mar 22, 2014 | 2003 Mazda Tribute

1 Answer

My 2003 Mazda tribute makes a sound from engine


It COULD be just a simple tentioner getting tight but cant say without hearing it.

Oct 20, 2013 | 2003 Mazda Tribute

1 Answer

How to change the coil pack on cylinder 5 of a 2003 mazda tribute


you have a remove the upper intake to do so. and you will need a new gasket and to torque it down after

Jan 26, 2013 | 2003 Mazda Tribute

1 Answer

Fuse box diagram 2003 mazda tribute


On this website you find fuse box diagram and description for Mazda Tribute

Mazda Tribute 2003 2004 fuse box diagram Auto Genius

Jun 20, 2012 | 2003 Mazda Tribute

1 Answer

Diagram of fuse box for 2003 mazda tribute on a 2003 Mazda Tribute


On this website you find fuse box diagram and description for Mazda Tribute (2003)

Mazda Tribute 2003 2004 fuse box diagram Auto Genius

Jun 05, 2012 | 2003 Mazda Tribute

1 Answer

How do you remove a alternator from a 2001 mazda tribute 6 cylinder


First, disconnect battery, than remove cables from starter (you may want to make mark so you don't get them mixed up when reinstalling,
Than Remove the two bolts holding starter.
Now you can pull out from top by exhaust manifold or if you have room to move through crossmember

Jun 03, 2009 | 2001 Mazda Tribute

1 Answer

Starter


standing in front of your car. starter is located on the back side of the engine on the left side. sits parallel to the ground.

about 3" round and about 5" long. you'll find it where the transmission connects to the engine

Jun 26, 2008 | 2003 Mazda Tribute

Not finding what you are looking for?
2003 Mazda Tribute Logo

Related Topics:

49 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8522 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...