Question about Cars & Trucks
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: how to install heater blower
This is an easy solution. Remove the glove box door strap and remove the glove box door by letting it drop towards the floor while supporting the door and it will release from the dash. Then you will see the blower motor housing along the firewall on the interior. You will just need to unplug the wires to the motor and remove a few screws and carefully remove the motor with the blower cage attached to it. Then just reverse the process and you will be good.
Posted on Feb 07, 2009
SOURCE: 1999 jeep wrangler heater blower
you need to change the resister block for the fan. it is located on the heater duct near the fan... there is a connector on it and two or three screws holding it in.
Please take a moment to rate this solution thanks
Posted on Feb 21, 2009
Run a new wire to the motor from the switch this will do 2 things for you. It will tell you if your switch is still good, and if it works you just fixed your problem.
Posted on May 03, 2009
I'd replace blower resistor, usually found under hood on firewall on passenger side, or on duct work, inside under dash on passenger side,close to blower motor.
Posted on Jun 01, 2009
You can test both of them once you have it apart. I have given you instruction below. Please follow them as injury could result.
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. DISCONNECT AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE AIRBAG SYSTEM CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE WAY TO DISABLE THE AIRBAG SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
CAUTION: Stay clear of the blower motor and resistor block (Hot). Do not operate the blower motor with the resistor block removed.
Disconnect and isolate the battery negative cable.
Remove the glove box from the instrument panel (Refer to 23 - BODY/INSTRUMENT PANEL/GLOVE BOX - REMOVAL).
Pull out the lock on the blower motor resistor wire harness connector to unlock the connector latch (Blower Motor Resistor Block- Typical).
Depress the latch on the blower motor resistor wire harness connector and disconnect the connector from the resistor.
Remove the two screws that secure the blower motor resistor block to the HVAC housing.
Remove the resistor block from the HVAC housing.
Posted on Jun 20, 2009
Tips for a great answer:
Aug 22, 2011 | 2000 Jeep Wrangler
Dec 14, 2010 | 1991 Jeep Wrangler
Nov 27, 2009 | 2001 Jeep Wrangler
Mar 29, 2009 | 1999 Jeep Wrangler
Feb 21, 2009 | Jeep Wrangler Cars & Trucks
Feb 12, 2009 | 1995 Jeep Wrangler
303 people viewed this question
Usually answered in minutes!