Question about 2002 Nissan Xterra

Open Question

Replace fuse for obd plug 2002 xterra

Not getting any power to my obd plug. Supposed to be a fuse, but i can't find it. possibly the relay?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 203 Answers

SOURCE: 2002 Nissan Xterra

you will have to remove the door panel on the inside and if you cant see the retaining bolts there should be a triagle shaped piece of plastic covering the bolts. if this helps please rate joe

Posted on Nov 21, 2008

  • 1 Answer

SOURCE: Where is the obd plug in on a 2002 Nissan Xterra ?

I had this same problem and I found that the Data Link Connector is located below the dash board, but on the Canadian model I own, it has a white connector right below the fuse block area which required me to remove the lower plastic panel to gain access ( as per the haynes manual you need a OBD-11 SCAN TOOL TO ACCESS INFO.

Posted on Mar 15, 2009

  • 225 Answers

SOURCE: fuse for power window in a 2002 nissan xterra

look under the hood in the fuse box. if not look under the dash on the driver side. look in the owner manuel if u have one. best of luck.

Posted on Aug 06, 2009

alicantecoli
  • 22095 Answers

SOURCE: 2002 Nissan Xterra. Do I need a replacement key

the hardware shop are totally correct dealer only or a specialised auto locksmith

Posted on Dec 24, 2009

  • 77 Answers

SOURCE: xterra car quit running. had no spark @

Yes, there is fuel pump relay, which is generally located on the passenger side kick panel. But in your case, the fuel pump relay on 2002 model Xterra is indeed located under the dash around the steering wheel, but no you don't need to remove the cover just lay in floor and you can see it, it will slide off a bracket and you can remove and replace it.
Good Luck!

Posted on Jan 15, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

New Beetle 2002 Hi-Beam lights only flash, don't stay on, what can I do?


I would test the relay to make sure it is still good and everything there is working like it is supposed to. I would also look at the switch and make sure noting came unplugged and it is still in good working order sometimes new parts are still bad.

Jul 26, 2015 | 2002 Volkswagen New Beetle

1 Answer

Ford F250 2002 7.3 Diesel won't start


check engine immobiliser and crank position sensor . Run fault codes and replace faulty units.

Apr 04, 2013 | Ford Cars & Trucks

2 Answers

Horn not working


or it is the horn, and that has gone bad. Could also be low voltage getting to the horn.
You should have a relay separate from the fuse for it.
Find that relay and swap it with another one of the same size.
like, if the power windows or headlights are the same part number for the relay, just switch them for the test.
if the relay is not the problem, and the horn itself is a no go, the problem could be in the steering wheel/horn ring. under the airbag.

hope this puts you on the right track

Dec 11, 2012 | 2002 Toyota Land Cruiser

1 Answer

Hi I have a 2006 envoy and have a short in the wiring went to plug in my obd reader and there is no juice found a blown fuse replaced it blew right away fuse is { 2 amp ltr } can you please tell...


I think only the lighter and obd are on that circuit. But, the 2 amp fuse is much, much too small for the lighter, or anything else for that matter. Replace the fuse with a 30 amp fuse, and try the code reader again. If the fuse continues to blow, replace the cigarette lighter assembly.

Mar 30, 2011 | 2002 GMC Envoy

1 Answer

Xterra car quit running. had no spark @ distributor. replaced crank sensor and got spark. no gas pressure. replaced fuel pump, new one do not work. no power to it. checked fuses/relays, no luck. ran...


the fuel pump fuse is fuse #1 15amp in the inside fuse box ( left side of dash behind fuse box cover ) the fuel pump relay is behind left side of dash ------- cavity #2 & #5 at the relay should have battery voltage in start and run cavity # 3 is the power out to fuel pump and cavity #1 is the ground that is turned on by the on board commputer.

Jan 15, 2011 | Nissan Xterra Cars & Trucks

1 Answer

Xterra car quit running. had no spark @ distributor. replaced crank sensor and got spark. no gas pressure. replaced fuel pump, new one do not work. no power to it. checked fuses/relays, no luck. ran...


Yes, there is fuel pump relay, which is generally located on the passenger side kick panel. But in your case, the fuel pump relay on 2002 model Xterra is indeed located under the dash around the steering wheel, but no you don't need to remove the cover just lay in floor and you can see it, it will slide off a bracket and you can remove and replace it.
Good Luck!

Jan 15, 2011 | 2002 Nissan Xterra

2 Answers

Where is the obd plug in on a 2002 Nissan Xterra ?


It should be under the drivers side dash board. 1/2in x 1in black connector.

Mar 13, 2009 | 2002 Nissan Xterra

2 Answers

2002 Nissan Xterra drivers power window wont roll down


Quite possibly yes...I would first check any relays and/or fuses just in case.  A few dollars for a fuse or relay is much cheeper than say $100.00 and a few hours of labor.  
You can purchase just the window motors from any major auto parts stores.  You can also purchase the window motor with the regulator.  The regulator is kind of like a rope and pulley system to lift the window up and down and the motor is attached to this assembly.  It is a little more expensive but I would change both.  I always change both just in case the regulator is bad and it isn't the motor.  You will have to remove the plastic interior of the door in order to change either the motor or the motor/regulator assembly.

Any questions, feel free to ask!

Feb 04, 2009 | 2002 Nissan Xterra

Not finding what you are looking for?
2002 Nissan Xterra Logo

Related Topics:

62 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...