Question about 1990 Subaru Loyale

Open Question

1990 subaru loyale wagon will not start when air temp is 25% or colder fires but will not start

Cold start problem

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 110 Answers

SOURCE: subaru loyale wagon replacing the timing belt

Get a proper manual like Haynes (amazon, parts store, Haynes.com).  You should not have to take either main pullel or cam pulley off to change timeing belt,  you DO want a new tensioner and and new idler pulley (if there is one).  Failure to replace these may result in a later failure that wipes out the blet, and possibly the motor (if it is an interference motor).
If you can change the oil pump from working on the front side of the motor, you are either a magician or a contortionist;!) and I need you to help me work on my car;~)    It's pretty rare for an oil pump to go bad before 400K km or 300K miles  ... the bloddy things are in a constant bath of oil!

Posted on Nov 01, 2008

  • 11174 Answers

SOURCE: Topic: 1990 1.8 L engine in Subaru Loyales. Loyale

have vehicle scanned for codes auto stores such as auto zone /advanced auto do it for free this gives u a starting point as for ur question about 25 different sensors there are about 60+ different codes and anything from bumper to bumper can set off check engine

Posted on Oct 18, 2009

Testimonial: "Thank you. Yes, I really wish we had Auto Zones in this neck of the woods. Unfortuately, the Schucks Auto Store doesn't stock any scanner capable of"

ZJLimited
  • 17970 Answers

SOURCE: The hazard lights on my 1993 subaru loyale are not

Both the turn signal and hazard warning flashers are mounted on the fuse panel.

REPLACEMENT
To remove a relay, simple pull the relay out. When installing a relay, make sure the terminals on the relay line up with the terminals in the fuse panel.
Most of the replaceable fuses for the electrical system are located on the fuse panel under the instrument panel, to the left of the steering column. In addition to the plastic fuses installed in the fuse box, there are 1 or more circuit breakers and a flasher relay.

For access to the fuse panel, remove the fasteners from the lower edge of the cover, then pull the cover downward until the spring clips disengage from the instrument panel. On the base models, the cover simply snaps on and off.

The locations of various fuses are illustrated in the owner's manual, and in some cases, on the cover of the fuse panel (in the pic check inside the circle).

5a08647.gif

Hope that helps.

Posted on Jan 22, 2010

richardrb123
  • 26 Answers

SOURCE: Where is the flasher relay on a 92 Subaru Loyale wagon?

Front seating area, driver side, under dash, above brake pedal, mounted in steering column support bracket

i hope this helps you

Posted on Apr 13, 2010

  • 1 Answer

SOURCE: fuel pump wiring diagram for a 1992 subaru loyale

Under the car, rear passenger side, just in front of the wheel well. The plug is located next to the actual fuel pump.

Posted on Aug 16, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Remove window crank from 1990 subaru loyale wagon


There is a hidden clip. You need a special tool to remove the clip, ask a local parts store for the a door handle/window crank removal tool.

Sep 10, 2012 | 1990 Subaru Loyale

2 Answers

Car ran fine shut it off came back it didn't want to start. started went about half a mile sputered an died wouldn't start back up 1991 subaru loyal wagon


Hi sounds like the typical fuel pump or filter problem with these cars, best way to tell is take top fuel hose off on fuel filter under hood, turn key on ignition (not start) and fuel should pump out, if not its your pump, just beware of doing when engine is hot

Apr 22, 2012 | 1991 Subaru Loyale

1 Answer

Need to know firing order on 1990 subaru loyale 1.8 fuel injection?


this might help as most of the 1.8's where the same its 1-3-4-2 and no 1 cyl is the passengerside front and on the dist.the no.1 plug should bethe 1 on the back side of the dist. to the right next to the hold down. hope this helps

Jul 12, 2011 | 1990 Subaru Loyale

1 Answer

1991 Subaru Loyale Wagon. Fuel injected. Whern car gets warm from running, or sitting in sun and cabin temps get above 70F or more, car cranks but won't start. Been 3 years or more of this. Replaced...


did you check out the battery cables,some times they can get corrosion inside where it cant be seen and cause a short, and lack of output and sonetimes will mess with the charging system.it happend on my 87.

May 12, 2011 | 1991 Subaru Loyale

1 Answer

I have a 1990 subaru loyal, it runs fine but there is a problem with the heat. the heat coming from the heater core isnt very hot, its barely warm. the car gets up to running temp and doesnt overheat. when...


A clog can cause low heater perforance in the winter. I had a 1990 Cadillac Deville that had cold air blowing in the middle of winter, and had the system flushed and that solved the problem.

One can feel the two heater tubes at the firewall leading to the heater core to verify whether or not the antifreeze/coolant is getting hot at the heater core.

Good luck on this repair.

Dec 18, 2010 | 1993 Subaru Loyale

1 Answer

My 94 loyale wagon bogs when stepping on gas, accelerating. New fuel pump installed and check engine light is on


could be air intake problem. check for vacume line loose or air filter needs changed. maybe fuel filter.

Aug 23, 2010 | 1994 Subaru Loyale

1 Answer

Where is the flasher relay on a 92 Subaru Loyale wagon?


Front seating area, driver side, under dash, above brake pedal, mounted in steering column support bracket

i hope this helps you

Apr 10, 2010 | Subaru Loyale Cars & Trucks

1 Answer

Topic: 1990 1.8 L engine in Subaru Loyales. Loyale No.1 Engine check light is staying on after replacement of oil sending unit (oil gauge still doesn't show pressure), EGR value, and the oil fill cap. A...


have vehicle scanned for codes auto stores such as auto zone /advanced auto do it for free this gives u a starting point as for ur question about 25 different sensors there are about 60+ different codes and anything from bumper to bumper can set off check engine

Oct 18, 2009 | 1990 Subaru Loyale

1 Answer

Defroster


Yeks, quick (when engine cool) make sure your radiator is FULL and engine is AIR BLED at the thermastadt. If your master brake cylinder is assisted power your DIAPHARM could be ruptured. Causes low vac in system so heater controls only work at idle the changes to cold when driving

Nov 24, 2008 | 1992 Subaru Loyale

Not finding what you are looking for?
1990 Subaru Loyale Logo

Related Topics:

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top Subaru Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...