Question about 1993 Lincoln Mark VIII

1 Answer

Anti theft horn activates randomly and shuts off before i can even locate the horn,my questions is where is the horn? thank you

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 54 Answers

Going to be under the hood sometimes near the firewall or around the wheel wells is a common place for installation

Posted on Jan 04, 2013

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Horn sticks in the on position and keeps honking. what is the cause


Sticking contacts in the horn pad switch, bad clockspring and even a bad horn relay that is stuck or burned.

Jun 17, 2015 | 1998 Jeep Cherokee

1 Answer

Where is the inertia switch on a99explorer xlt


thats two questions...what exactly is your concern?
The inertia switch is tripped in a collision shutting off the fuel pump, what do you mean about the anti theft?
Two systems...

Sep 28, 2014 | 1999 Ford Explorer

1 Answer

1981 corvette anti theft will not arm


Could be the module is fubar since you have B+ at the terminal. U can also install a hidden double pole switch that deactivates the fuel pump and ignition circuits. And if you want to be fancy you can do the same with a relay that opens those circuits automatically when ignition key is removed so you do not even have to throw a switch!

Apr 08, 2017 | 1981 Chevrolet Corvette

1 Answer

1994 ford explorer limited anti-theft


Two tips:
* If your anti-theft system is sounding (horn honking/lights flashing)you press the panic button on your key fob to shut it off.

* If your anti-theft system is armed (but not triggered) it is disarmed when you unlock the door(s) using your unlock button on your keyfob, the key pad on the driver's door, or your key.

Hope help with this. Good luck (remember rated this).

Feb 25, 2010 | 1994 Ford Explorer Limited

1 Answer

Anti theft activated-now car won't start and radio won't work. Radio won't take radio code and car cranks but doesn't start, horn blares, and headlights flash. I don't have the other code for the anti...


to turn off the theft system, all you have to do is put the key in the door lock and lock and unlock the door, this shuts down the anti theft system,now this has nothing to do with the radio, the only way the radio would ask for the code is if it was removed or the battery unhooked,anyway try the unlocking of the door even try the passenger door, hope this helps.

Feb 16, 2010 | 1992 BMW 5 Series

1 Answer

Recently heard that a 2003 ford explorer sport trac had a anti-theft swith/button on floorboard that when activated will not allow vehicle to start. Where is that located? thanks


don't know about anything like that. I know Ford did put the emergency fuel shut-off switch on the passengers side floor up under the dash just behing the carpet on Rangers and were sometimes unplugged by passengers with long legs. It has a little red button on it that pushed down. Check to see if you have something like that. Maybe it shuts off when the anti-theft alarm is activated and has to be reset.

Aug 09, 2009 | 2003 Ford Explorer Sport Trac

1 Answer

My 2005 honda odyssey anti theft activated when my battery went dead" now ny lights blink and my horn constantly beeps on and off. I cant even put it in drive...how do I reset it?


Not trying to steal your solution, but trying to clean up the unanswered page:
There are two possible answers here:
The simple one:  Use your remote control's "unlock" button to reset the anti-theft system.
or a more comlex one that seems to work: (From the original post)"I found out that you remove the horn fuse, shut the doors, put the key in and unlock it two times then put the fuse back in...it resets the anti theft..."


Apr 12, 2009 | 2005 Honda Odyssey

1 Answer

VEHICLE WONT START


Section 13-11: Anti-Theft System, Active 1998 Windstar Workshop Manual DESCRIPTION AND OPERATION Anti-Theft Alarm System NOTE: The system immediately monitors the ignition key lock cylinder upon removal of the key from the ignition. It is not necessary to arm the system for ignition key lock monitoring.

The anti-theft alarm system:
  • protects the vehicle from unauthorized entry into the passenger compartment, engine compartment and cargo area.
  • monitors the status of the ignition key lock cylinder.
  • is controlled by a remote anti-theft personality (RAP) module. The remote anti-theft personality module also controls the electronic door lock functions. Refer to Section 01-14B for more details.
  • when armed, detects unauthorized entry into the passenger compartment by using an input from the GEM module regarding the state of the door or liftgate (open or closed).
  • protects the engine compartment with a hood switch which is located on the LH cowl vent panel and is part of windshield wiper motor wiring (17A477) .
  • triggers an alarm if the ignition lock cylinder is forcibly removed from the steering column.
Once triggered, the system responds by:
  • flashing the low beam headlamps, the parklamps, rear lamps and the alarm indicator warning light emitting diode (LED).
  • sounding the horn (13832).
  • disabling the starter circuit until the system is disarmed.
---------------------------------------------------------------------------------------------
Remote Anti-Theft Personality Module
  • The remote anti-theft personality module is located behind the instrument panel (04320).
  • It contains a radio receiver that receives the RF signal from the keyless entry remote transmitter (15K601) through the alarm and lock system antenna (15603) and sends the appropriate command to the power door locks, the horn relay, or the generic electronic module.
  • The remote anti-theft personality module is equipped with an internal backup power supply which holds the programmed code in memory in the event the vehicle battery is disconnected.
-------------------------------------------------------------------------------
Remote Anti-Theft Personality Module Removal
  1. Disconnect battery ground cable (14301). Refer to Section 14-01 .
  1. Remove radio. Refer to Section 15-01 .
  1. Remove lower instrument panel center finish panel. Refer to Section 01-12 .
  1. Lower glove box.
  1. Remove two remote anti-theft personality module bracket retaining screws.
  1. Disconnect electrical connectors and alarm and lock system antenna (15603).
  1. Remove remote anti-theft personality module and bracket.
  1. Remove remote anti-theft personality module from mounting bracket.
Installation
  1. To install, follow removal procedure in reverse order.
  1. Tighten remote anti-theft personality module bracket retaining screws to 6-8 Nm (54-70 lb-in).

    34bdf35.gif
Components The system is composed of the following components:
  • remote anti-theft personality (RAP) module with integral antenna
  • alarm indicator LED
  • door lock cylinder switch RH, door lock cylinder switch LH
  • liftgate door lock cylinder switch (220A40)
  • hood switch (part of windshield wiper motor wiring (17A477))
  • ignition lock anti-theft switch (19A438)
The following vehicle components are also used by the anti-theft alarm system:
  • generic electronic module
  • power door lock switch (14028)
  • door open warning lamp switch (14018)
  • autolamp relay (14N089)
  • horn relay and bracket (13853) and horn (13832)
  • low beam headlamps
  • rear lamps (13404) and parking lamps (13200)
  • starter relay
  • door lock relays
  • keyless entry remote transmitter (15K601)
--------------------------------
Disarming an Untriggered System NOTE: A perimeter alarm will "shut off" after 165 seconds, but the system is still triggered and is not disarmed.

An armed but untriggered perimeter anti-theft system can be disarmed by one of the following four events:
  1. Unlock the doors by pressing the keyless entry remote transmitter (15K601) UNLOCK button once.
  2. Unlock any door with a key.
  3. Turn ignition switch to RUN or ACC.
  4. The remote entry PANIC button will disarm the anti-theft system only when the perimeter alarm is triggered and sounding.
------------------------------------------------
System Triggering NOTE: Although the remote entry PANIC alarm is not associated with the monitoring of the vehicle, the user will frequently say that the theft system was triggered when actually the keyless entry remote transmitter PANIC button was inadvertently pressed. A panic alarm will not flash the THEFT indicator.

The alarm can be triggered by the following events if the system has been armed and has not been disarmed first:
  • Open any door or liftgate.
  • Open the hood (16612) (if the hood was open when the system was armed, it must be closed before it can trigger the alarm).
  • Dislodge the ignition key lock cylinder.
  • The anti-theft system may be triggered inadvertently when the module is disconnected and then reconnected. To avoid inadvertent alarm triggering, disconnect the smaller 22-way connector first.
When the system is triggered the perimeter alarm will operate as follows: The remote anti-theft personality module will pulse the following outputs at approximately 1.3 Hz, 50 percent duty cycle for two minutes 45 seconds for North America. NOTE: Other perimeter alarms can be programmed for the system.

  • low beam headlamps
  • parking lamps
  • horn
  • THEFT indicator
The perimeter alarm can be retriggered, after a perimeter alarm has sounded for 165 seconds. After a perimeter alarm has timed out, if any trigger input is first seen as normal and is then seen in its trigger state, the perimeter alarm will be retriggered. The perimeter alarm can be triggered a total of three times between an arming sequence and a disarm event. An active panic alarm will be deactivated when a perimeter alarm is triggered (a perimeter alarm overrides a panic alarm).

Mar 02, 2009 | 1998 Ford Windstar

Not finding what you are looking for?
1993 Lincoln Mark VIII Logo

67 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lincoln Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

fordexpert

Level 3 Expert

5522 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...