Question about Cars & Trucks
I just bought the jeep and the dealer didnt know how to work it
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
depending on your alarm which it sounds like a viper model maybe? on my 02 you have to incorporate a factory alarm bypass module in order to be able to start the truck, they run about 100.00 bucks and have to be profssionally installed. The truck wont start because the computer isnt recieving the proper starting sequence due to the factory alarm
Posted on Jul 02, 2009
Its usually not the nav unit. Best way to find out many dealers have a demo nav disc ask them to pop it in if it works then u know the disc is at fault not the nav unit. The bad news it the disc costs about $300. Hope this helps please rate if it does.
Posted on Sep 10, 2009
next to the fan motor there should be a connector that has three or four wires that attached to the blower resistor. it should have two screws holding it to heater case, just pull it out and replace.
Posted on Feb 13, 2010
Testimonial: "This info was very helpful but need a little more info of where the fan motor is located. I will post another question to find that info."
Common problem in snow country where salt water can corrode starter parking gate wire connection at started tab. Just cleanthe connector and tab, coat in dielectric grease, problem solved in 15 minutes!
Posted on Dec 05, 2010
Tips for a great answer:
Jan 23, 2017 | 2008 Jeep Commander
Oct 02, 2014 | 2006 Jeep Commander
Jan 10, 2013 | 2006 Jeep Commander 5.7
The engine and automatic transmission in this vehicles drive train are fully electronically controlled by a computer called the PCM (Power Train Control Module). Whenever a problem like this occurs the computer stores a record of the problem (there are of course some exceptions to this, like the fuel pump, engine coolant temperature sensor and MAF sensor for instance) in the form of a fault code in its memory, to read these fault codes you must have the systems memory scanned with a special tool. Once the fault code(s) are read you then must perform the appropriate diagnostic testing to find and resolve the problem(s) DO NOT REPLACE ANY PARTS UNTIL A TRAINED TECHNICAIN HAS DIAGNOSED THE PROBLEM TO AVOID SPENDING YOUR HARD EARNED MONEY ON PARTS THAT MAY NOT CORRECT THE PROBLEM
Aug 24, 2012 | 2006 Jeep Commander
Jul 27, 2012 | 2006 Jeep Commander
Jan 25, 2010 | 2005 Nissan Sentra
Jan 10, 2010 | 2000 Jeep Grand Cherokee
Aug 14, 2009 | 2006 Ford Taurus
Mar 18, 2009 | 2000 Jeep Grand Cherokee
130 people viewed this question
Usually answered in minutes!