Question about 2000 Chevrolet Blazer

1 Answer

2000 blazer won't start

Will roll over, but will not start

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 2,101 Answers

Do you hear the fuel pump go on when you turn the key to the run position? do you know if you have spark? are there any codes?

Posted on Jan 04, 2013

  • 9 more comments 
  • faithfraser
    faithfraser Jan 04, 2013

    yes, pump goes on and exhaust comes out tailpipe when cranking. Lights come on, battery is charged fully. Has a "healthy" cranking sound to it, we have tried using starting fluid with no effects. We are assuming there is no spark but don't really know what to check first. It hasn't started in about a month and is kept inside our pole barn, no mice yet but don't want any either.

  • faithfraser
    faithfraser Jan 04, 2013

    in the past there has been a misfire code, fuel pump is new within the past 3 years. as of right now htere are no codes

  • teds repairs
    teds repairs Jan 04, 2013

    there is 2 things to replace . 1 is the crank positon sensor . it is located by the harmonic blancer. the other is the ignition control module ,and it is under the rotor in the distributor. please do not remove the distributor please do not

  • teds repairs
    teds repairs Jan 04, 2013

    here is a picture of the ignition control module. you will need a torque 15 and torque bit20 to get at it.

  • teds repairs
    teds repairs Jan 04, 2013

    here is the crank position sensor. this picture shows where it is the harmonic balancer is missing in picture

  • teds repairs
    teds repairs Jan 04, 2013

    with the misfire I would go with the ignition control module

  • faithfraser
    faithfraser Jan 04, 2013

    Thanks Ted. I'll let you know what we come up with. Is there a test you can do on the part itself before purchasing new? If they are cheap parts it's not too big of a deal :)

  • teds repairs
    teds repairs Jan 04, 2013

    the ignition control module is about 90 dollars in a parts store but cheaper online

  • faithfraser
    faithfraser Jan 04, 2013

    This blazer is a manual trans, does this make a difference?

  • teds repairs
    teds repairs Jan 04, 2013

    no it does not

  • faithfraser
    faithfraser Jan 05, 2013

    Got the truck running, but not to well. I went out this morning and fired it up, runs really rough but it seems to have an air hose/vacuum leak somewhere so this is my new challenge. any suggestions? I ordered the parts from my aunt so they should be in about a week.

×

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 5256 Answers

SOURCE: 1999 chev blazer won't start new fuel pump

So, do you hear the pump buzz on, when key is on? If that's good, then check your ignition circuit: check for spark at a plug. Use insulated pliers, hold end of plug wire 1/4 inch form engine bolt or ground source. When cranked, you should see a bright blue spark. Yes? Try another plug wire, too. No? Try another plug wire. If you have NO spark, could be your coil, coil pack, crank position sensor, ignition module. I would recommend using a diagnostic flow-chart to go through the ignition circuit. That way, you are not replacing unecessary parts_Expensive! Of course, if you have spark at plugs, your ignition circuit is good! Then you have to look further, like your injector circuit. Good luck.

Posted on Oct 30, 2011

  • 1 Answer

SOURCE: My 2001 Chevy Blazer won't start when its cold.

Plug it in at night

Posted on Dec 15, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Turns but won't start


Have the fault codes read. Replace faulty items. Use only
genuine items as replacement as non-genuine are not always compatible with the OEM fitted CPU units. This results in the fault codes not cancelling out. check the engine immobiliser and the battery in your key

May 25, 2013 | 2000 Chevrolet Blazer

1 Answer

2000 chevy blazer won't get over 2200-2300 rpms and has whistle


kinda sounds like the catilist in the converter is bad and the exhaust cant get out

Oct 14, 2012 | Cars & Trucks

1 Answer

2000 blazer won't accelerate worse with the a/c on


try full tune up first and see what happens

Jul 15, 2012 | 2000 Chevrolet Blazer

1 Answer

Won't start after a heavy rain. Ok next day after drying out.


change the distributor cap by friend did the same thing and i wouldent start untill we took the distributor cap off and we seen croshin and we replaced it and it started up like a champ

Jul 14, 2012 | 2000 Chevrolet Blazer

1 Answer

2005 Blazer key won't turn in the ignition


You may want to try to slightly push / pull your vehicle to take weight / tension off the transmission, which in turn will allow you to turn the steering wheel enough to see if the ignition switch can be turned.

Jun 24, 2017 | 2005 Chevrolet Blazer 4WD

1 Answer

2000 Chevy Blazer won't start after horn and lights flashing out of control


sounds like a faulty alarm immoblizer ,,,, .. if its a after fit system , disconect it and shoot it !!!

Feb 13, 2012 | 2000 Chevrolet Blazer

1 Answer

I took the old rear brake pads off my 2000 chevy blazer and the new ones won't go on. They don't allow enough space to go back on?


YOU HAVE TO COMPRESS THE CALIPER PISTON BACK INTO THE CALIPER USING A C-CLAMP OR SIMILAR TOOL. USE AN OLD PAD TO DO THIS.

Jul 09, 2011 | 2000 Chevrolet Blazer

1 Answer

Xterra will not turn on. windows won't roll down, doors stays locked. won't roll over at all. odometer won't come up


Do you get any dash lights when you turn the key on? If not, you could just have a dead battery.

May 27, 2011 | 2000 Nissan Xterra

2 Answers

Chevy blazer wont start 2002


if it turns over there are a cocuple of things to check. crankshaft sensor and the coil pack maybe the computer.id start with the crankshaft sensor

Jun 29, 2008 | 2002 Chevrolet Blazer

Not finding what you are looking for?
2000 Chevrolet Blazer Logo

82 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...