Question about 2009 Ford Fusion

Open Question

COMPASS NO RESPONSE

Driving to work and dash alert reads compass no response what does that mean?

Posted by Anonymous on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 14 Answers

SOURCE: Temperature/compass display no longer works, any suggestions?

Number one..,

Id check the fuses then if still you have no luck id check that the unit is getting power by using a circuit tester or voltmeter ect...

Let us no how you get on...

Jules...

Posted on Mar 22, 2009

  • 1 Answer

SOURCE: the trip computer, mileage, and compass died on

I have the same thing happen to my '03 super duty F-350 6.0 and fixed it. Grab the entire console unit, lights and all and just pull straight down. Start with the side opposite the front windshield. It is a bit hard, but there are clips holding it. Pull the one plug off that is powering the console. On the back there is a large black plate with a black plug on it and a smaller black plate with a red plug on it. You will be working with the larger one. Pull off a white plug that is on the side of this larger black plate also remove the black plug on this one as well. Next unscrew the black plate and open it up by gently pulling on the clips. Be careful as there are a few resistors that might fall out. These are the problem. Once you open it up, you will see four resistors that all look the same. These come desoldered and cause this problem. Get a soldering iron and just hold it on one side of the resistor. If you look at it closely, you should see that one side of the resistor is no longer touching the circuit board. Do this to all the resistor sides that are not touching the circuit board. Hold the iron on this point for around 4 seconds or so. After removing the iron, check to see if the resistor stayed down. If it did, move on to the next one. DO NOT push on the resistor to see if it is good, just look to see if it is touching the board. Put it all back together and you are done. I did this to repair mine and it worked great.

Posted on May 27, 2010

satitus
  • 273 Answers

SOURCE: need to repair a electronic compass in my 99 ford

I offer a repair service for this unit. Check out www.autoclockrepair.com drop me a note if you have any questions, thanks!

Posted on Oct 23, 2010

satitus
  • 273 Answers

SOURCE: 2004 f250 powerstroke console with compass, temp,

This is a very common problem with many of the mid 2000 Ford truck and SUV overhead consoles. The console is very prone to internal failure. If the dome lights work but the compass unit does not then it is a faulty computer unit. I offer a reasonable repair service with a lifetime guarantee, check it out: www.autoclockrepair.com
There is a bunch of useful info there. Drop me an email if you have questions, thanks!

Posted on Dec 12, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2007 checy impala read "calibration complete" what does that mean ????


CALIBRATION COMPLETE
Refer to Electronic Compass Calibration do you have an owners manual ?
Compass Calibration
The compass direction will show CAL if it needs to be calibrated. Before calibrating the compass, drive the vehicle to an area that is magnetically clean (free of large metallic objects).
  1. Turn ON the ignition.
  2. Before calibrating the compass, make sure the compass is set to the variance zone in which the vehicle is travelling. See Compass Magnetic Variation Adjustment below.
  3. Press the vehicle information button until the PRESS TO CALIBRATE COMPASS screen is displayed.
  4. Press the set/reset button to start the compass calibration.
  5. The DIC will display CALIBRATING: DRIVE IN CIRCLES. Drive the vehicle in circles at less than 8 km/h (5 mph) to complete the calibration. The DIC will display CALIBRATION COMPLETE when the calibration is complete.

Oct 02, 2016 | 2007 Chevrolet Impala

1 Answer

How can I reset jeep compass comput(er) after replacing battery?


is this a compass car?
or are you say fiddling he electronic compass on a grand Cherokee.
or the compass on a compass, OMG.

if fiddling the electronic compass
the operators guide covers that.
lost that.
its here.
2004 and up

http://www.jeep.com/en/owners/manuals/


read the manual first, then ask for help of lost.

it is there, read it.

Feb 16, 2016 | Jeep Cars & Trucks

1 Answer

Compass in the dash stop working


needs service.
the FSM covers this toy.

alldata.com read

or the real deal (FSM)
click jeep

https://www.techauthority.com/en-US/Pages/Home.aspx

RTM

Did you scan the PCM yet, if not why not, id bet there are errors there. like compass module not talking or?

Feb 24, 2015 | 2014 Jeep Grand Cherokee

1 Answer

How to do I get the compass and temperature gauge to work in the rear view mirror again. Directions are NW and SE all the time


Calibrate the compass built into the upper-right corner of the rearview mirror by holding the compass button (an "N" with two crossing lines) until your zone number appears. Determine your zone number by looking at the map in the owner's manual. Press the compass button until a "C" appears. Then drive in a circle three times at 5 mph or less in an uncongested area. The compass will automatically orient as a result of the circling.

Read more : http://www.ehow.com/how_5927729_reprogram-avalon-after-battery-change.html

Aug 19, 2014 | 1999 Toyota Avalon

1 Answer

Fwd lights always on jeep compass


try it in dirt yet (gravel, sand, grass dirt)
since you didnt post transfer case type can't answer
if you use , part time 4wd on dry pavement this will happen as
will 4low or lock. read the operators guide, one more time.

its a new car get it serviced, or drive in dirt, and turn off 4wd
see if it stays off. if you use the car wrong, the dealer will just stare at you, in a very not so funny way.

new cars come with options, or by sub model, (same really)
some have Automatic Full-Time Four-Wheel Drive
which one?
The Compass also features two electronically controlled four-wheel drive systems. Freedom Drive I and Freedom Drive II, Freedom Drive I is a full-time four-wheel drive system with locking capabilities

if some one used LOCK
you need to unluck in dirt. drive to side of road with gravel
or any loose surface and get bad to normal.
read opeators guide 1 more time.....

Jul 13, 2014 | 2014 Jeep Compass

1 Answer

My 2006 chevy impala dash board read out: calibration complete what does this mean and how would I go about fixing it


This is the Compas reading, In your manual you will see what geographic zone you are in. follow the instructions. enter the zone drive in a circle and the compass will set itself correctly.

Dec 04, 2010 | 2006 Chevrolet Impala

1 Answer

I have 2002 Yukpn Denali XL. There is a OC code that appears in the rear view. What is the cause of this and how can I fix it?


The "OC" indicates your compass is "Out of Calibration". Below is the proceedure to recalibrate your compass.

Compass Calibration
The compass may need calibration if:
 After five seconds, the display does not show a
compass heading (N for North, for example), there
may be a strong magnetic field interfering with the
compass. Such interference may be caused by a
magnetic antenna mount, magnetic note pad holder
or a similar magnetic item.
 The compass does not display the correct heading
and the compass zone variance is set correctly.
In order to calibrate, the letters CAL must be displayed
in the mirror compass windows. If CAL is not
displayed, push in the COMP button for approximately
eight seconds or until the letters CAL are displayed.
The compass can be calibrated in one of two ways:
 Drive the vehicle in circles at 5 mph (8 km/h) or less
until the display reads a direction, or
 drive the vehicle on your everyday routine and after
several turns the compass will become calibrated and
will display a direction.

Good luck.

Oct 23, 2009 | 2003 GMC Yukon XL

1 Answer

Inside compass and thermeter does not work. How


You may have blown a fuse under the dash. I must express that if you don't know how to fix or have knowledge to do these things, find someone who does.
If your vehicle came with a basic manual, read the section on electrical system. It will tell you the location of your fuse box and it will tell you how to reset the compass and temp.
My Chevy came with this and it is the best part of the truck.

Apr 24, 2009 | 1999 Ford Explorer

2 Answers

Temp sensor and compass not displaying on my 2003 yukon xl


Yes. Look in the Fuse Panel inside the Truck. Use a Good Maglight or LED Flashlight and Hold it Behind the Fuses to see the Blown Ones. It is usually in an AUX Outlet. Also check thr Fuse Relay Box under the Hood for a Blown Fuse using the Same Method. See if there is a Relay for this also. If so, Replace it. Let me know if you need any more Help! Please Rate my Response, I need all the Help That I can Get!

Jan 26, 2009 | 2002 GMC Yukon XL

1 Answer

F-150 Supercrew-Outside Temp gauge


Of course that's what the manual say because more money for the dealer. Try disconnecting the battery and see how that works. If not let me know and I fine some way for you.

Cheers

Aug 21, 2008 | 2005 Ford F-150

Not finding what you are looking for?
2009 Ford Fusion Logo

Related Topics:

982 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5474 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...