Question about 1994 Isuzu Trooper

1 Answer

I need a new air flow meter were can i purchase one?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 4 Answers

Posted on Jan 04, 2013

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

22re trouble code 24 and 32


24 Intake air temp sensor and 32 mass air flow meter circuit or vacuum switch failure . Air temp sensor is internal in the vane style mass air flow meter it is not replaceable you will need a new meter.

Mar 21, 2014 | 1994 Toyota Pickup

1 Answer

I have nissan sentra b15 2001 the car starts but do not exlarate , the scaner detect the air flow sensser is bad , i got new one but now the car cranck but wont start yes i have spark


did you replace it with new one, or used one?? also have you replaced your air filter and used NISSAN only air filter. something tells me that you had non nissan/aftermarket air filter installed and that is why your air flow meter failed. you need to use nissan air filter ONLY in your model nissan. sentras do not like non nissan air filter, because non nissan filters are not coated in small amount of oil and let foreign particals / dirt go pass the filter and that will fry your $500 air flow meter.

Sep 16, 2011 | 2002 Nissan Sentra

2 Answers

2003 be jetta won't go more than 20 mph


Hi there? It sounds like the car is ranning on limp mode. Is the engine managment light on? if so, the air flow meter can cause this simptons. If you disconnect the air flow meter which is located next to the air filter box, it should improve it if it is disconnected, don't worry this will not cause any problems.
If it improves it by disconnecting the air flow meter then you'll need a new air flow meter..
Good luck......

May 20, 2011 | 2003 Volkswagen Jetta TDI

1 Answer

I recently purchased a C200 Merc with 162 000 Km. On two ocassions the car lost power and began to idle roughly. It would not accelerate at all and barely moved. A few moments later everthing went back to...


most possibly it could be the air mass sensor ( air flow meter) first check air flow meter, if you get in to the workshop and fixed the diagnose cpu you can see the fault code, if not the air flow meter next have to check crank angle sensor, if you check the fault code you can see what's wrong, if the fault code like mixtcher information retch or Lin replace air flow meter,

Oct 17, 2010 | 1998 Mercedes-Benz C-Class

1 Answer

Mercedes Benz C-class 180C, the car stops engine each time I break, I have removed the switch connection to the air flow meter and this stops, what is the implication of removing the switch and driving car...


don't drive the car without air flow meter connected because the air flow meter signal very impotent for fuel mixture in combustion chamber, in your car faulty air flow meter replace air flow meter, is this information helped you?

Mar 24, 2010 | 1998 Mercedes-Benz C-Class

1 Answer

Air flow meter


air flow meters are expensive i would first replace the coolant temperature sensor

May 28, 2009 | 1996 BMW 318

2 Answers

Idle and Power Where is the fuel filter?


Fuel filter is inside the gas tank and its built into the fuel pump housing. You need to remove the back seat and get into the tank via access hole under the seat. Than you need to "split" the fuel pump assembly open and get the filter out. Reverse procedure to assemble. Those filters are rated for 105k miles. My 00 Maxima has 167K on it and it runs just fine with the original. As far as the air flow meter , its a pretty common part that fails and that's why 00 Max air flow meter costs only $100 and all others $500 or more. If you replace an air flow meter, make sure that you use a "NISSAN" air filter or YOU WILL BE replacing the air flow meter AGAIN. Also with the new air flow meter the cars ECM/Computer needs to be reprogrammed. As far as plenum gaskets leaking?? unless someone had it apart and didnt put it back together the right way, its "VERY UNLIKELY" for those gaskets to be bad. Totally bullet proof.

Mar 03, 2009 | 2000 Nissan Maxima

1 Answer

Repair air flow meter


jjj8000: Your car uses what is called a "Hot wire air mass sensor"
This cylindrical black plastic component which has screens at both ends and an electrical connector with roughly 6 pins, is not a serviceable component. It has a set of wires inside of it which after the engine is shut off, gets to a temp over 1,000 degrees Fahrenheit to burn off residue collected on it during the time air has been passing over it. If I could repair this type of component in my shop, I would stand to make a lot of money! Unfortunately, it takes specialized testing equipment for the remanufacturing process. Not to mention the replacement components to put in to replace the ones needed to rebuild the cores.
I wish I could give you a better answer, but it's the only one I know. However, prior to condemning the air flow meter, make sure you have made the proper diagnosis. FALSE AIR problems are often diagnosed as air flow meters. Check and make sure the boots (hoses) which the attach the the air flow meter and go to the throttle body, have no tears or leaks. Make sure you have no split vacuum lines or hoses. Remember, the ECM determines the injector pulse width by the amount of air metered through that component. If any un-metered air that passes after the air flow meter, will create a situation of hesitation and stumbling, lean conditions and more. DO YOU HOMEWORK!"
I'm the new guy on the block here at "Fixya" and need all the feedback possible to get better ratings. If I have helped you, please write in. Thanks......mybunkey

Jan 13, 2009 | 1988 Nissan 300ZX

1 Answer

Poor idle, power loss off idle then takes off if you give it more throttle like a quarter more pedal, engine code says bank 2 is to lean


You need a new MAF (mass air flow sensor or air flow meter as its called). and you will also need a new air filter, since you most likely used aftermarket one and that's what killed that MAF sensor/meter. Aftermarket air filters dont sit right in the box and are not oil soaked, which helps to catch any debris and dirt coming into your engine. Replace you air filter with Nissan filter and install a new MAF/air flow meter. If your air box is dirty, clean that out too. MAF sensor will run you about $500 and the air filter about $17. Common problem on a Sentra if you are not using Nissan air filter.

Aug 02, 2008 | 2002 Nissan Sentra

Not finding what you are looking for?
1994 Isuzu Trooper Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...