Question about 1987 Toyota Supra

2 Answers

What is correct tire pressure for 1987 supra

We drove our 1987 Supra down to FLorida. we started it on Saturday and it's driving well. The tires are all 27 psi. We can't find what the proper pressure is?

Posted by on

  • Toyota Ed May 11, 2010

    Is there a tag inside the glove box? That is where the tire info is supposed to be.

×

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 61 Answers

It depends on what size of tires are on the car.

This supra should have one of two different tire sizes. The first is 205/55R16 and the pressure should be 36PSI. The second is the fifty series tires, 225/50VR16 and the pressure should be 28 PSI.

A side note, aside from potentially being displayed on the tire itself and the owner's manual (if it's still in the car), the correct tire pressure is also typically put on a small placard that is mounted on the driver's door or glovebox area.

Hope this helps and good luck!

Posted on Jan 19, 2009

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 152 Answers

Look on the metal part of the inside door frame on either the driver or pasenger side. it will tell you there. should be around 32psi if stock tires

Posted on Jan 19, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

General directions on how to change the front brakes on a Toyota Supra, 1987.


Buy brake pads.
loosen lugs
Jack car, place on jack stand
turn wheel so front of tire is pointing out.
remove tire
remove caliper (two bolts on back side of caliper
slide caliper off rotor.
(if rotor is damaged, see about having it turned or replaced)
take pads off caliper
open hood and remove cap to mater cylinder reservoir
using special tool (or C-clamp and something to protect piston) push the piston back into the caliper fully.
place new brake pads on caliper.
fit caliper on the rotor
Secure caliper to wheel with bolts
replace wheel
remove jack stand
remove jack
tighten lugs on wheel
replace hubcap
start engine (do not drive yet!!!!!)
pump brake pedal until it tightens up
observe reservoir on master cylinder (fill if needed)
replace cap
pump brakes again
take out for a test drive.

good luck and don't forget to vote!!!

Oct 11, 2010 | 1987 Toyota Supra

1 Answer

I just replaced the turbo on my 1987 supra i drove it home from my shop and then the next day i was goin for a drive i started it up every thing was good i hit the gas when i started to build boost it...


do you have a service manual that troublshoots turbos--get car scanned and inspect entire vehicle for vacuum leaks or other problems of aging-itz 24 yrs--OBD I diagnostic n dont go replacin parts til u know

Aug 18, 2010 | 1987 Toyota Supra

1 Answer

1987 SUPRA WONT START WHEN COLD


sounds like a coolant temp sensor for (computer)

Jan 11, 2010 | 1987 Toyota Supra

1 Answer

How do i install a t70 turbo to a 1987 toyota supra turbo 7mgte 3.0


you will need an additional turbo manifold. I have the correct one its for sale right now on eaby. The ct26 turbo manifold does not allow for proper mounting. I can include directions with the manifold

Dec 03, 2009 | 1987 Toyota Supra

1 Answer

I have a 1987 toyota supra and it isnt getting any spark


poss bad earth, check ecu supply when then cranking. if not you need an oscilliscope to see what is up with signal on crank sensor, some vehicles power cable is so close the noise from it wipes the signal same as a bad starter it interfers with the signal, (noise is the magnetic fields)

May 18, 2009 | 1987 Toyota Supra

1 Answer

1987 toyota supra.


hmm. . . . go to tuner shops. . . for sure if they dont have one they can order 1 form japan. . . it maybe an aftermarket clutch but why not. . . they last longer. . . 8)

Oct 22, 2008 | 1987 Toyota Supra

1 Answer

Brake Pedal difficult to push down


did you adequately bleed the brakes?

Aug 18, 2008 | 1987 Toyota Supra

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

200 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...