Question about Cars & Trucks
So the car has been doing it on and off for a couple of weeks and would eventually end up going but now it wont move at all, found when it was warmed up for a good 5 minutes it would go but today it took me to rev the out of it to finally get going but half an hour into my trip it wouldn't move again when I was waiting at an intersection so ended up having to tow it home, any ideas and suggestions on what it could be would be greatly apppreciated.
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
ok when the check engine light comes on that usually indicates a engine malfunction...what you can do is go to your local autozone and they can do an OBDII test for free..my bet says it is the cam or crank sensor.. DO NOT SHUT THE CAR OFF AT AUTOZONE..LOL
Posted on Jan 01, 2009
Try cleaning the fuel pump filter. Under the seat behind the driver lift the carpet and you will find a round cover with six screws remove the cover. The fuel pump is directly below unscrew the retaining round plate and remove the pump. At the base of the pump is a small filter if it is covered in black muck that's your problem. clean and replace. job takes about 10 mins good luck. please let me know how you got on!
Posted on May 08, 2009
Check your terminal connections, if they are loose they will need to be inspected for breaks. If they are broken you will need to replace the connection. Make sure they are clean and free of corrosion.
Other possible Problems
If the car wont turn over your starter could be bad.
If it turns over but wont start it could be any number of these problems.
EBX (Engine Brain Box)
CBX (Chassis Brain Box)
Posted on Feb 15, 2010
Symptoms- Engine Light ON (or Service Engine Soon Warning Light)
- Lack/Loss of Power
- The engine may be harder to start
- The engine may stumble or stallPossible causes- Ignition/Distributor engine speed sensor harness circuit is open or shorted
- Ignition/Distributor engine speed sensor poor electrical connection
- Faulty Ignition/Distributor engine speed sensor
- Faulty Crankshaft Position sensor
- Low battery charge
- Faulty Engine Control Module (ECM)When is the code detected?The P0322 code is triggered when the Engine Control Module (ECM) detects no signal.P0322 VOLKSWAGEN DescriptionIgnition failure sensor is used to check whether the spark ignition is occurred correctly or not and also used to tachometer drive. The sensor monitors the voltage difference between a resistance which is on the battery circuit for ignition coil. When the ignition coil works properly, the electric current through the resistance is detected as voltage drop. This is confirmed for every ignition event with the crankshaft sensor and the camshaft sensor. If ECM detects a malfunction, no ignition is possible, so the engine would not start. If there is no ignition signal for a predetermined cycle for one or two ignition coils, an ignition coil circuit failure exists.
Posted on Nov 12, 2011
Tips for a great answer:
Oct 10, 2011 | 1999 Subaru Legacy
Jul 18, 2011 | 1999 Subaru Legacy
Mar 28, 2011 | Subaru Legacy Cars & Trucks
Jan 25, 2011 | 1999 Subaru Legacy
Sep 08, 2010 | 1999 Subaru Legacy
Jan 27, 2010 | 1999 Subaru Legacy
Apr 05, 2009 | 1999 Subaru Legacy
Jan 11, 2009 | 1999 Subaru Legacy
18 people viewed this question
Usually answered in minutes!