Question about 2004 BMW 3 Series

Open Question

Where is oxygen sensor bank 2/1 on 2005 bmw x3, 3.0l engine

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 64 Answers

SOURCE: 328 i 1997: BMW Start up problem: Stuttering

it sounds like the cat is blocked,

Posted on Feb 17, 2009

Ad
  • 15 Answers

SOURCE: BMW 328 i 1997: Start up problems / Stuttering / Engine Light

change the pcv valve its under the intake manifold

Posted on Feb 18, 2009

  • 437 Answers

SOURCE: My check engine light on my 1997 BMW Z3 2.8

Isn't there a rear sensor by the catalytic converter also?

Posted on Nov 04, 2009

  • 95 Answers

SOURCE: IAT and oxygen sensor on a 1994 BMW 740i

http://www.bmwtips.com/tipsntricks/Exhaust/O2sensor.htm

Posted on Jan 07, 2010

  • 279 Answers

SOURCE: what is the location ofttgen sensor, bank 2

Its located in the exhaust manifold on the passenger side,its the sensor closest to the rear of the engine.

Posted on Feb 07, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

P2716 bmw 520i


2715 Oxygen sensor heater before catalytic converter, bank 2: Activation
2716 Oxygen sensor heater after catalytic converter, bank 1: Activation
2717 Oxygen sensor heater after catalytic converter, bank 2: Activation

Jul 07, 2016 | BMW Cars & Trucks

1 Answer

Codes P2270& P2272 after oil change check engine light on drove under 100 miles both O2 sensors bad .Could shop have caused this somehow??? Maybe banging them or something ?


make sure they are plugged in tight Definition of Diagnostic Trouble Code P2270 Category: Powertrain Definition: O2 Sensor Signal Biased/Stuck Lean Bank 1 Sensor 2Note: This definition of P2270 is applied to all manufacturers

P2270 - O2 Sensor Signal Biased/Stuck Lean Bank 1 Sensor 2 Comments ' Add Yours
Possible causes
- Faulty Rear Heated Oxygen Sensor Bank 1
- Rear Heated Oxygen Sensor Bank 1 harness is open or shorted
- Rear Heated Oxygen Sensor Bank 1 circuit poor electrical connection
- Exhaust gas leaks Help with this
When is the code detected?
The Powertrain Control Module (PCM) detected the HO2S12 sensor has reported a lean condition for an extended period during an intrusive test
Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
- High Fuel Consumption
- Excessive Smoke from Exhaust
P2270 Description
The Powertrain Control Module (PCM) supplies a voltage of about 450 mV between the HO2S high and low signal circuits. The oxygen sensor varies the voltage over a range from about 1,000 mV when the exhaust is rich, down through about 10 mV when the exhaust is lean.
The PCM monitors and stores the heated oxygen sensor (HO2S) voltage information. The PCMevaluates the HO2S voltage samples in order to determine the amount of time the HO2S voltage was out of range. The PCM compares the stored HO2S voltage samples taken within each sample period and determines if majority of the samples are out of the operating range.

Definition of Diagnostic Trouble Code P2272 Category: Powertrain Definition: O2 Sensor Signal Biased/Stuck Lean Bank 2 Sensor 2Note: This definition of P2272 is applied to all manufacturers

P2272 - O2 Sensor Signal Biased/Stuck Lean Bank 2 Sensor 2
' Add Comment
Possible causes
- Faulty Rear Heated Oxygen Sensor Bank 2
- Rear Heated Oxygen Sensor Bank 2 harness is open or shorted
- Rear Heated Oxygen Sensor Bank 2 circuit poor electrical connection
- Exhaust gas leaks
What does this mean?
When is the code detected?
The Powertrain Control Module (PCM) detected the HO2S22 sensor has reported a lean condition for an extended period during an intrusive test
Possible symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
- High Fuel Consumption
- Excessive Smoke from Exhaust
P2272 Description
The Powertrain Control Module (PCM) supplies a voltage of about 450 mV between the HO2S high and low signal circuits. The oxygen sensor varies the voltage over a range from about 1,000 mV when the exhaust is rich, down through about 10 mV when the exhaust is lean.
The PCM monitors and stores the heated oxygen sensor (HO2S) voltage information. The PCMevaluates the HO2S voltage samples in order to determine the amount of time the HO2S voltage was out of range. The PCM compares the stored HO2S voltage samples taken within each sample period and determines if majority of the samples are out of the operating range.
P2272 Information for specific makes
P2272 BMW
P2272 DODGE
P2272 FORD

Jul 30, 2015 | Cars & Trucks

1 Answer

I am getting the following codes on my 2002 Nissan Altima v6 3.5 liter P1430, P1420, P1805, P1152, P1102, P1011, P1021 & P1335 I'm going crazy here. Please help!


Definition of Diagnostic Trouble Code P1430 Ford: Electric Air Pump Secondary Lincoln: Electric Air Pump Secondary Mazda: Electric Air Pump Secondary Mercury: Electric Air Pump Secondary Toyota: Intake Constrictor CTRL Circuit Open or Short

Definition of Diagnostic Trouble Code P1420 Audi: Second Air Injection Valve Circ Electrical Malfunction BMW: Secondary Air Valve Control Circuit Electrical Buick: Intake Air Low Pressure Switch Circuit Low Voltage Cadillac: Intake Air Low Pressure Switch Circuit Low Voltage Chevrolet: Intake Air Low Pressure Switch Circuit Low Voltage Chrysler: Register Resonant Charging 1 (RRC1) Dodge: Register Resonant Charging 1 (RRC1) Ford: Catalyst Temperature Sensor GMC: Intake Air Low Pressure Switch Circuit Low Voltage Honda: Nox Adsorptive Catalyst System Efficiency Below Threshold Catalytic converter Jeep: Register Resonant Charging 1 (RRC1) Lincoln: Catalyst Temperature Sensor Mazda: Catalyst system efficiency below threshold (bank 1) Mercedes: AIR Pump Switch over Valve Mercury: Catalyst Temperature Sensor Oldsmobile: Intake Air Low Pressure Switch Circuit Low Voltage Pontiac: Intake Air Low Pressure Switch Circuit Low Voltage Saturn: Intake Air Low Pressure Switch Circuit Low Voltage Subaru: EVAP Purge Control Solenoid Circuit High Input Toyota: SCV Control Circuit Malfunction Volkswagen: Second Air Injection Valve Circ Electrical Malfunction

Definition of Diagnostic Trouble Code P1805 Ford: Four wheel drive high indicator circuit failure Lincoln: Four wheel drive high indicator circuit failure Mazda: (4WD) High Indicator Open Circuit Mercury: Four wheel drive high indicator circuit failure Toyota: SB Solenoid Circuit Malfunction

Definition of Diagnostic Trouble Code P1152 Audi: Bank1, Long Term Fuel Trim, Range 2 Leanness Lower Limit Exceeded BMW: Oxygen Sensor Heater Circuit Low Voltage (Bank 2 Sensor 1) Ford: Lack Of Heated Oxygen Sensor Bank 2 Sensor 1 Switches - Sensor Indicates Rich Jaguar: Lack of H02S-21 switch, sensor indicates rich Land Rover: Oxygen sensor response time bank 2.Short circuit to ground Lincoln: Lack Of Heated Oxygen Sensor Bank 2 Sensor 1 Switches - Sensor Indicates Rich Mazda: Lack Of Heated Oxygen Sensor Bank 2 Sensor 1 Switches - Sensor Indicates Rich Mercury: Lack Of Heated Oxygen Sensor Bank 2 Sensor 1 Switches - Sensor Indicates Rich Subaru: Oxygen sensor range /performance problem (Low) Volkswagen: Bank1, Long Term Fuel Trim, Range 2 Leanness Lower Limit Exceeded Volvo: Oxygen Sensor Front, Bank 2

Definition of Diagnostic Trouble Code P1102 Acura: Mass Airflow (MAF) Sensor Lower Than Expected Comprehensive Audi: Oxygen Sensor Heating Circuit,Bank1-Sensor1 Short to B+ Chrysler: HEV Stop Request Performance Dodge: HEV Stop Request Performance Hyundai: MAP Sensor Circuit Low Input Jeep: HEV Stop Request Performance Kia: Heated Oxygen Sensor Bank 1 Sensor 1 Heater Circuit High Input Land Rover: Throttle to air flow plausibility not active.Last occurrence - minimum signal Mazda: Mass Air Flow Sensor In Range But Lower Than Expected Mitsubishi: Traction Control Ventilation Solenoid Circuit Porsche: Heated Oxygen Sensor 1 Ahead Of TWC Heater Short To B+ Saab: Front Heated Oxygen Sensor Bank 1, Control Module Input, Current in Pre-Heating Circuit Too High Subaru: Pressure Sources Switching Solenoid Valve Circuit Malfunction Volkswagen: Oxygen Sensor Heating Circuit,Bank1-Sensor1 Short to B+ Volvo: Power Stage Group B

Definition of Diagnostic Trouble Code P1011 Saab: Injector Cylinder 1 Shorting To Ground Toyota: OCV for VVTL Open Malfunction (Bank 1)

Definition of Diagnostic Trouble Code P1021 Honda: Valve Pause System Stuck On Comprehensive Mitsubishi: OCV OPN. Bank 1 Saab: Injector Cylinder 2 Shorting To Ground Toyota: OCV for VVTL Open Malfunction (Bank 2)

Definition of Diagnostic Trouble Code P1335 Audi: Engine Torque Monitoring 2 Control Limit Exceeded Buick: CKP Circuit Cadillac: CKP Circuit Chevrolet: CKP Circuit Ford: (EGR) Position Sensor Minimum Stop Performance GMC: CKP Circuit Infiniti: CKP Sensor (Ref) Jaguar: CKPS Circuit Malfunction Land Rover: Exhaust gas recirculation position sensor minimum stop performance. Lexus: Igniter Circuit Malfunction Bank 2 (During Engine Running) Lincoln: (EGR) Position Sensor Minimum Stop Performance Mazda: (EGR) Position Sensor Minimum Stop Performance Mercedes: CKP Sensor Circuit Malfunction, Bank 2 Mercury: (EGR) Position Sensor Minimum Stop Performance Oldsmobile: CKP Circuit Pontiac: CKP Circuit Saturn: CKP Circuit Toyota: No CKP Sensor Signal Engine Running Volkswagen: Engine Torque Monitoring 2 Control Limit Exceeded http://www.obd-codes.com/trouble_codes/nissan

Jun 29, 2015 | Nissan Cars & Trucks

1 Answer

Error code p1040


P0140 BMW P0140 BMW - O2 Sensor Circuit Low Voltage Bank 1 Sensor 2



Possible causes - Faulty Rear Heated Oxygen Sensor Bank 1
- Rear Heated Oxygen Sensor Bank 1 harness is open or shorted
- Rear Heated Oxygen Sensor Bank 1 circuit poor electrical connection
- Inappropriate fuel pressure
- Faulty fuel injectors
- Intake air leaks may be faulty
- Exhaust gas leaks

Replacing the Rear Heated Oxygen Sensor Bank 1 usually takes care of the problem
http://engine-codes.com/p0140_bmw.html

Apr 22, 2014 | 2006 BMW 325i

1 Answer

How many o2 sensors are on a 1999 Silverado 5.3


The 1999 5.3 V8 engine had 4 oxygen sensors. There are two catalytic converters on this engine, one on the driver side of the engine, and one on the passenger side of the engine. This is important to know, as the number of oxygen sensors is directly related to the number of catalytic converters on the vehicle. Driver side is referred to as Bank 1, passenger side is referred to as Bank 2. This is very important to know when looking up replacement oxygen sensors. There is one oxygen sensor in front of, or before the catalytic converter, usually referred to as a pre-catalyst O2 sensor. There is also one behind, or after the catalytic converter, usually referred to as a post-catalyst oxygen sensor. So, you have two oxygen sensors on Bank 1, and two oxygen sensors on Bank 2, for a grand total of 4 oxygen sensors.

Oct 03, 2013 | 1999 BMW 318 ti

1 Answer

The check engine code is 155 and 217


155 - Oxygen Sensor Heater Circuit , Bank 2 Sensor 1 217 - Serial Communication Link
The 217 code indicates the communication bus between two or more of your computers is malfunctioning. The 155 code is one of your rear oxygen sensors malfunctioning.

Oct 21, 2010 | 1996 BMW 3 Series

1 Answer

Fault code 0134


P0134 Oxygen Sensor Circuit No Activity Detected (Bank 1 Sensor 1)
Check wiring to Oxygen sensor.

Apr 22, 2010 | 1992 Land Rover Range Rover

1 Answer

What is the location ofttgen sensor, bank 2


Its located in the exhaust manifold on the passenger side,its the sensor closest to the rear of the engine.

Feb 07, 2010 | 2004 BMW 3 Series

1 Answer

Bmw 330ci m sport automatic 2001 makes a clinging sound when accelerating engine management light on and diagnostics says 228-e4-fuel trim bank 2- too lean. 227-e3-fuel trim bank 2- too lean its not...


Explanation:

According to my research and the BMW master mechanic, basically your oxygen sensor is getting an abnormal reading. The abnormal reading will result in the sensor being unable to adapt beyond its +/- 10% threshold to adapt for the fuel/trim mixture. Therefore, either your car is going to run too lean (not enough fuel) or too rich (too much fuel).

Problems:

1) Either your pre-cats oxygen sensors are bad.
2) Fuel pressure regulator
3) Leak in the air intake /vacuum system

I would think that it is probably your oxygen sensors. Replace that and you should be good to go. Thanks for rating my response and for using FixYa!

Jun 30, 2009 | 2001 BMW 330

Not finding what you are looking for?
2004 BMW 3 Series Logo

Related Topics:

140 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

Frankie B

Level 2 Expert

65 Answers

Fred Sops

Level 2 Expert

272 Answers

Doberman

Level 2 Expert

254 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...