Question about 2007 Chrysler 300 AWD Sedan

1 Answer

ETC WARNING LIGHT IS ON AND THE CAR WILL NOT START

HOW DO I TURN THAT LIGHT OFF SO IT WILL START??

Posted by on

  • rodcollier Feb 02, 2009



    I just had the same thing happen this weekend, but the check engine light also came on and it went into limp mode only allowing an idle speed. It was towed to the dealer and they said the throttle sensor is malfunctioning and on my '07 SRT it is built into the throttle body so the whole body must be replaced - $119 part.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Have the same problem on my 05 300c replaced throttle body and map sensor still not fixed next step is replacing accelerator pedal and if that doesnt do it. it has to be the computer. So post if you find another problem that fixes it

Posted on Mar 02, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2004 Nissan Altima 3.5L BATTERY LIGHT went on during 15 minute drive. Next day car "died" while idling after a 20 minute drive. BRAKE WARNING LIGHT & BATTERY LIGHT on prior to full electrical failure.


Start with checking the alternator voltage with a multimeter. With the car off check the voltage in the battery which should be holding 12v charged less if flat of course then start the car and test the battery again. If the alternator is good you should be getting a reading of 14 to 14.5 v if it's the alternator it'll A) not put any charge into the battery or B) be a very low voltage being anything under 13.5 v

Sep 30, 2016 | 2004 Nissan Altima

Tip

How to reset AIRBAG SRS Light on 2003 - 2006 Infiniti G35 Coupe


Hi, on most vehicles, the airbag light should come on for at 6 seconds, and then go off if the system is working properly. If there is a fault or a problem in the system, the light will remain illuminated, or flash continuously. If the airbag light does not work properly, some vehicles have an audible tone that sounds indicating a problem with the airbag light system. When the light is on (or the tone is sounding), the airbag will NOT deploy, even in an accident. <br /> The flashing light on your car is telling there is a problem. <br /> <br /> <b>How to reset AIRBAG SRS Light on 2003 - 2006 Infiniti G35 Coupe </b> <br /> Ignition Key Method: <br /> <ul> <li>Turn IGNITION on (but don't start car).</li> <li>After the AIR BAG warning lamp lights for 7 seconds, turn IGNITION off within 1 second.</li> <li>Wait 4 seconds.</li> <li>Turn IGNITION on (but don't start car).</li> <li>After the AIR BAG warning lamp lights for 7 seconds, turn IGNITION off within 1 second.</li> <li>Wait 4 seconds.</li> <li>Turn IGNITION on (but don't start car).</li> <li>After the AIR BAG warning lamp lights for 7 seconds, turn IGNITION off within 1 second.</li> <li>Wait 4 seconds.</li> <li>Turn IGNITION on (but don't start car).</li> <li>Wait 3 seconds.</li> <li>Turn IGNITION off.</li> <li>Wait 2 seconds.</li> <li>START Car (the light may be blinking slower than before).</li> <li>Wait 3 seconds.</li> <li>Turn IGNITION off.</li> <li>Wait 3 seconds.</li> <li>START Car.</li></ul> <br /> <b>This is a little easier</b> To reset the light simply turn the iginition to the on position, (you dont need to start it). All the lights should stay on for thier diagnostic check. As soon as the airbag light goes off, before it starts flashing, immeditatly turn the car off. Repeat this 3 or 4 times (turning to on then off) and the light should go away

on Dec 07, 2010 | Infiniti G35 Cars & Trucks

2 Answers

Is it normal to have a red triangular warning light come on after pressing the start button and then go off as soon as the other lights(car seat, air bag, break etc) go off..


It's normal. It's part of the instrument cluster module doing what's called a "bulb check" on initial start up, and it should go off in under ten seconds, since it does, there is no problem

Feb 17, 2015 | 2015 Toyota 4Runner

1 Answer

Why does the Engine Warning light come up but other warning lights like battery, oil pressure etc.don't show up in ignition mode & the car doesn't start?


Sounds like a wire was not re-installed under the hood. When the alternator or battery were replaced, there are several power wires under the hood that attach to the same power terminal. Look for a RED wire with a large round connector, that is just hanging out in the open air. You need to install it back onto the post that it came off of. good luck.

May 07, 2014 | 2010 Chevrolet Spark 1.2

1 Answer

No start and warning light on


What does the warning light say? Does it turn over or not? Too little information to go on.

Nov 26, 2013 | 2003 Ford Taurus

1 Answer

2001 Chev Malibu. Turn key on to start car, won't start. No warning lights on no lights on gauge panel. Radio works, dome light work.


check the ground leg to your engine.. it runs off the neg. battery terminal. will connect to frame and engine.. pull it off, wire brush it put it back.. you radio will work, 'cause it draws much less current, and is grounded in dash.

Jan 11, 2013 | 2001 Chevrolet Malibu

1 Answer

Car will not start when ignition key is turned. All warning lamps light up, enginee doesn't even try to start even with the clutch depressed


1. So the car was running normally and then on one occasion you put in the key to start it and all the warning lights flash up on the dash and the starter motor will not turn the engine over. Is that correct.

2. When you last drove the car were any warning lights appearing on the dash.such as check engine warning, engine overheating, electrical charging warnings etc.\

3. Has any work been carried out on the car recently.

4. How old is the battery in the car.

Dec 23, 2012 | 2010 Jeep Patriot

1 Answer

My car smog test said my car failed the MIL/check engine light due to warning lamp failure means what?


Basically, it means the check engine warning light didn't light up when it should. Perhaps a burned out bulb?

Every vehicle has a "system check" that happens every time you turn the key on. Most people don't know it is happening right before thier eyes. So if you go out and get into your car in the morning and you turn the key to "on" but then don't go the rest of the way to the "start" position there are several warning lights on. The check engine light is one of them. All the system is doing is running power through the light to show it is functional.

It doesn't mean there is something wrong, it is just showing that an error "can" be displayed if an error existed by the light being on. Try it next time. Turn the key on but dont start the engine. If your check engine light is off, then that is what they stated in the report.

Apr 13, 2011 | Plymouth Breeze Cars & Trucks

2 Answers

Maintence light is blinkin when i start my car


Generally, the maintenance light should come on for a few seconds, then go off after the car has started. All of the dashboard warning lights do this so driver can tell they are operational. (Should see brake light, low oil pressure, airbag warning, etc. Any of the lowly "idiot" lights should come on.)

As a test, turn the key on, but not to start. All of the lights should flash on for a few seconds, sometimes in sequence, then go out. Now, sart the car, some lights may come on and back off. If none stay on after a few seconds of engine running, you are probably ok.

Sep 23, 2009 | 2000 Honda Accord

Not finding what you are looking for?
2007 Chrysler 300 AWD Sedan Logo

1,018 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

chargerhp
chargerhp

Level 3 Expert

813 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...