Question about 2000 Mercury Grand Marquis

1 Answer

Electric window off track

Posted by on

  • Rob Houg
    Rob Houg May 11, 2010

    Your going to have to remove the door skin or. bring it to mako for about 50 bucks they will fix.

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 328 Answers

You'll need to remove the inner door panel to get it back on track and repair any broken mechanisms inside the door

Posted on Jan 19, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

When operating drivers door electric window it makes a grinding screeching noise & gets stuck half way & have to close window by operating switch while pulling window up


If sounds like the window came off the window track & when it gets halfway up the window motor may start grinding. 1st try lubing the rubber window seals w/ white grease to see if that helps . if not remove the inner door cover & ck to see if the glass is firmly sealed to the track & lube all gears & motor gears . If window is out of the track a SPECIFIC ADHESIVE GLUE is made for it. Reset it in the track & re glue it in position .Don't forget to lude the edges & seals. GOOD LUCK, Frank M

Feb 22, 2016 | 2003 BMW Z4

2 Answers

Electric window came off track


No track to come off of

You have a broken window regulator to replace

Apr 03, 2014 | 1999 Buick Century

1 Answer

Passenger window will not come up


ok the window rides on a track and the window has eithor came off track it apart put back on track if electric maybe motor is burnt out test with volt meter

Sep 13, 2010 | 1994 Lexus LS 400

1 Answer

I replaced the electric window motor and now the window seems to be "off track" as it goes up at an angle and will not go all the way up. How do I adjust the tracks so that the window goes up and down...


Its in the track of the window you will have to go back and take the window loose the pull the window and hold it in place (I use duct tape)then roll the track to the full up position and reset the glass to it.
let me know if this helps

May 14, 2010 | 1997 Oldsmobile Achieva

1 Answer

Electric rear window falls down


poss your window track is broken or off track take the door panel off to see the track to see if its still going up or down or poss bad widow regulator

Apr 04, 2010 | 2004 Jeep Grand Cherokee

2 Answers

Renault scenic drivers electric window motor runs


The track guide that operates the window from the motor is damaged or has jumped track. Remove the inner door panel and operate the window and see which has happened. If it has jumped track check for missing or damaged guide retainers if it is damaged or broken replace it. Normally runs about $15 to $20 for the part. Now if the drive guide is not damaged and it is still not working the gear that drives it is damaged and you will need to replace the motor as this is pressed on and not user replaceable. Good Luck

Sep 12, 2009 | 2001 Renault Sportwagon

1 Answer

Fallen driver's side window


probably need a new window regulator. ebay. 93 to 98 should fit.

Section 01-05: Trim, Interior 1998 Villager Workshop Manual
REMOVAL AND INSTALLATION Trim Panel(s), Door Front
Removal
  1. Disconnect the battery ground cable (14301) if equipped with power locks or power windows.
  1. swv~us~en~file=ani_caut.gif~gen~ref.gif CAUTION: Use care when removing the front door inside handle escutcheon (22620). Failure to do so can result in damage to the component.
    Carefully pry off the front door inside handle escutcheon by inserting a standard 1/4 inch screwdriver between the top rear portion of the front door inside handle escutcheon and the front door trim panel (23942) .




  1. If equipped with manual windows, slip a clean shop rag between the window regulator handle (23342) and the front door trim panel .
  1. Pull the shop rag back and forth to release the window regulator handle clip.




  1. Remove the three cover caps and front door trim panel screws.
  1. Remove the one front door trim panel capped screws from the door pull handle.
  1. If equipped with power windows, remove the door pull handle. Disconnect the electrical connectors.
  1. Slide a flat-bladed tool behind each of the retainers and twist the tool to disengage the front door trim panel from the front door (20124) .
  1. Remove the front door trim panel.
Installation
To install, reverse the removal procedure.
---------------------------------------------------------
Window Regulator, Power Front Door
Removal
  1. Disconnect the battery ground cable (14301) .
  1. Remove the front door window glass (21410) . Refer to the front door window glass removal procedure in this section.
  1. Remove the two front door brace bolts and the front door brace.


    415712f.gif

  1. Disconnect the front window regulator electric drive electrical connector.
  1. Remove the four front door window glass regulator track bolts.

    67b6136.gif


  1. Remove the three front window regulator electric drive bolts.
  1. Remove the front door window glass regulator track and the front window regulator electric drive (23394) as an assembly through the opening in the front door (20124) .
Installation
  1. Install the front door window glass regulator track and the front window regulator electric drive as an assembly through the opening in the front door .
  1. Install the three front window regulator electric drive bolts. Tighten the front window regulator electric drive bolts securely.
  1. Install the four front door window glass regulator track bolts. Tighten the front door window glass regulator track bolts securely.

Apr 29, 2009 | 1998 Mercury Villager

1 Answer

Window is off track






1. remove door panel, door latch handle and window crank unless it is electric, then remove electric control panel , usually on top of arm rest.
2, Remove insulation sound barrier (plastic sheet)
3. Inspect window for damage. If none is found, notice where the window normally slides up and down in what is called tracks. There is felt material inside the tracks.
4. Also look to see if the window has dropped out of the two crossed arms that have white plastic rollers on them. Be careful handling these arms because they are very sharp.
5. Look for small tabs holding track to door. Usually top and bottom. Loosen these screws slightly until you can move them back widening the distance between both tracks so that you will be able to slide the window back into the tracks.
6.Once the window is back in track, move the loosened track back up so its just touching the window, then retighten the screws.
7. Test window operation.
8. If the window comes off tracks again, window regular is causing problem and should be replaced.


Hope this helps.


If you would like to correspond further with me on this or any other issue, please feel free to do so.
Bill
ASE Master Technician

Nov 26, 2008 | 1999 Chevrolet Malibu

1 Answer

FRONT DOOR WINDOW


Yes. I have fixed my driver side window several times. The window went all the way down and came off the track, usually because the window automatically went all the way down. The first step was to take the interior side of the door off: (1) I unscrewed the screws around the door and pull the plastic screws out. (2) I disconnected the thin metal rod that connects the door handle to the door frame to be able to pull the interior part of the door away from the metal frame of the door. (3) I unscrewed the speaker to see where the window meets the rubber track. (4) I kept the electrical wires connected so that I could use the electric window button to lower and raise the window. (5) I lowered the window down below the rubber track and loosened the screw holding the rubber track to the door. (6) I manually adjusted the rubber track around the window glass and pressed the electric window button up slowly, making sure the glass stayed on the track. (7) I put everything back in place, screwed in the screws, etc. Be careful not to let the window go all the way down, because it seems to fall off the track at that point. Hope this helps!

Nov 08, 2008 | 1992 Honda Accord

1 Answer

1998 Jeep Cherokee window installation


If it slipped the track, something broke inside the door.
You have to take the door panel off and see what the problem is.

Oct 12, 2008 | 1998 Jeep Cherokee

Not finding what you are looking for?
2000 Mercury Grand Marquis Logo

106 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Fordexpert

Level 3 Expert

5331 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...